Composite partial pressure means the sum of the partial pressures of the VOC compounds in a solvent.
Operating pressure means the pressure at which the parts of an irrigation system are designed by the manufacturer to operate.
Diameter means the diameter of the stem of a tree measured outside the bark at a specified point of measurement.
Sewage sludge weight means the weight of sewage sludge, in dry U.S. tons, including admixtures such as liming materials or bulking agents. Monitoring frequencies for sewage sludge parameters are based on the reported sludge weight generated in a calendar year (use the most recent calendar year data when the NPDES permit is up for renewal).
design pressure means the maximum pressure that a pressure vessel or plant is designed to withstand safety when operating normally;
Process weight means the total weight of all materials introduced into any source operation. Solid fuels charged will be considered as part of the process weight, but liquid and gaseous fuels and combustion air will not.
width means, in relation to a lot,
Diatomaceous earth filtration means a process resulting in substantial particulate removal in which (1) a precoat cake of diatomaceous earth filter media is deposited on a support membrane (septum), and (2) while the water is filtered by passing through the cake on the septum, additional filter media known as body feed is continuously added to the feed water to maintain the permeability of the filter cake.
Sewage sludge fee weight means the weight of sewage sludge, in dry U.S. tons, excluding admixtures such as liming materials or bulking agents. Annual sewage sludge fees, as per section 3745.11(Y) of the Ohio Revised Code, are based on the reported sludge fee weight for the most recent calendar year.
Lot width means the shorter of the following two linear measurements:
Pressure means relative pressure versus atmospheric pressure, unless otherwise stated.
Reid vapor pressure means the vapor pressure of crude oil or other volatile petroleum products at 100 degrees Fahrenheit as determined by the latest edition of ASTM D6377 (RVPE): Standard Test Method for Determination of Vapor Pressure of Crude Oil.
Acre-foot means the amount of water necessary to cover one acre of land to the depth of one foot, or 325,851 U.S. gallons of water.
Interconnector means a transmission line which crosses or spans a border between Member States for the purpose of connecting the national transmission system of those Member States or a transmission line between a Member State and a third country up to the territory of the Member States or the territorial sea of that Member State;
Nominal tomographic section thickness means the full width at half-maximum of the sensitivity profile taken at the center of the cross-sectional volume over which x-ray transmission data are collected.
Energy efficiency improvement means equipment, devices, or materials intended to decrease energy consumption, including, but not limited to, all of the following:
Gasification means the substoichiometric oxidation or steam reformation of a substance to produce a gaseous mixture containing two or more of the following: (i) oxides of carbon; (ii) methane; and (iii) hydrogen;
Turbidity means the cloudy condition of water due to the presence of extremely fine particulate materials in suspension that interfere with the passage of light.
Wind Turbine means a mechanical/electrical system that converts the kinetic energy of blowing wind into mechanical or electric power.
Direct scattered radiation means that scattered radiation which has been deviated in direction only by materials irradiated by the useful beam (See "Scattered radiation").
PAD means a Preauthorized Debit.
Drainage area means a geographic area within which stormwater, sediments, or dissolved materials drain to a particular receiving waterbody or to a particular point along a receiving waterbody.
Basement means any area of the building having its floor subgrade (below ground level) on all sides.
Finished water means the water that is introduced into the distribution system of a public water system and is intended for distribution and consumption without further treatment, except as treatment necessary to maintain water quality in the distribution system (e.g., booster disinfection, addition of corrosion control chemicals).
Plant canopy means the square footage dedicated to live plant production and does not include areas such as office space or areas used for the storage of fertilizers, pesticides, or other products.
Plate means the license plate, including renewal decals, if any, issued for a vehicle registered under the plan by the base jurisdiction.
Electrical protection barrier means the part providing protection against any direct contact to the high voltage live parts.