Examples of Drawer unit in a sentence
Drawer unit face frames and base cabinet top rails shall be 3/4” pre-finished particle board.
FTop tray: 1200 mm x300 mm wide made out of 18 gauge CRCA Sheet GTable should be provided with following electrical and net work facility i.5A 3 pin Universal Socket -3 Nos per table ii.2 Ethernet Socket Ports one per table 2Supply of Mobile pedestal consist of mobile Drawer unit with three drawers made up of 18mm thick pre-laminated particle board conforming to IS : 12823 (exterior grade) for side,top,bottomand drawers with center locking facility,full open type telescopic slide for drawers.
Drawer unit shall be made of 18mm prelaminated particle board with inner drawer in steel duly powder coated moving on nylon rollers.
It shall be covered with board at the top.Workstation consists of work surface of 25mm thick prelaminated particle board having PVC edge lapping of 2mm thick on all exposed edges and 0.6mm on all butt edges & pressed at 200o C with hot melt glue on edge handing machines.The Workstation shall have side quarter round privacy screen made of 25mm thick prelaminated particle board provided on both sides.The Workstation shall be supported with Drawer unit having overall size 380x500x725ht.
Drawer unit, hardware, and suspension same as specified for base unit drawers.
The drawer shall be provided in the following sizes.375x550x725mm 450x550x725mm Pencil DrawerProviding & fixing pencil Drawer unit of size 300 x 300 x 75mm made of body in steel duly powder coated and facia in 18mm thick prelaminated particle board (Refer Drawing) Pedestal DrawerProviding & Fixing pedestal drawer unit of size 450x500x725mm having 1 drawer at top and bottom open for CPU, made of 18mm thick prelaminated particle board.
Running counter shall have Drawer unit comprising of a sliding drawers on telescopic channels and bottom openable shutter with all hardware as per schedule of interiors, furniture & finishes.
Drawer unit should be made from prime quality CRCA sheets confirming to IS 5131986.Steel frame and sheet metal component should be powder coated.
Drawer unit running on side runner & rest in shutter (18mm block with both ends half round rounded off post formed with flex as per manufactures specification.
The Contractor shall provide and maintain a temporary, watertight office building not less than 10'x 10', containing plan and shop drawing storage racks (4 Drawer unit) and a smooth, sloped top table or examination of plans.