Evapotranspiration rate definition

Evapotranspiration rate means the quantity of water evaporated from adjacent soil and other surfaces and transpired by plants during a specified time.
Evapotranspiration rate means the sum total of plant transpiration, evaporation off of the soil surface, and water used for plant growth.
Evapotranspiration rate means the inches of water per day.

Examples of Evapotranspiration rate in a sentence

  • The signal typically comes from a local weather station (or series of weather stations) and usually updates the current Evapotranspiration rate to the controller.

  • Evapotranspiration rate in the Kabul City is high reaching its maximum value of 240 millimeters per month in July.

  • Evapotranspiration rate may decrease by up to 10% and surface temperature may increase by up to 0.5 °C in the grid boxes Acta Silv.

  • Meteorological conditions in BTC is similar to the rest of the Delta region as reflected in section 4.1.1.5, with the minor exception that Evapo-transpiration rate (ETo) is an average of 1540 and 1680 mm/year in Kafr El Sheikh and Gharbiya governorates, respectively.

  • These sources are briefly described below: Evapotranspiration Rate Evapotranspiration rate was obtained from Accuweather measurement station located in Lincoln, Nebraska.

  • The Evapo-transpiration rate from a reference surface, not short of water, is called the Reference crop Evapo-transpiration or reference Evapo-transpiration and is denoted as ETo. The reference surface is a hypothetical grass reference crop with specific characteristics.

  • During the hottest days of the year the Evapotranspiration rate often exceeds the plants ability to draw water in from the soil.

  • The Actual Evapotranspiration rate depends on the available solar energy, weather conditions (air temperature, humidity and wind speed), and the moisture content in the soil.

  • Water budgets are determined by the individual needs of the customer using site-specific factors including, but not limited to, persons per household, irrigated area, weather (expressed as Evapotranspiration rate), plant factor, and days of service.

  • Contractor is to adjust the watering schedule equal to the Evapotranspiration rate each plant is capable of receiving based on topography, soil type, plant material, season or climatic factors.


More Definitions of Evapotranspiration rate

Evapotranspiration rate means the quantity of water evaporated from adjacent
Evapotranspiration rate means the quantity of water evaporated from adjacent soil and other surfaces andtranspired by plants during a specifiedtime.
Evapotranspiration rate. (ETo) means the quantity of water evaporated from adjacent soil and other surfaces and transpired by plants during a specified time. The monthly and annual evapotranspiration rate used for the City of Chino Hills is as follows:
Evapotranspiration rate means the quantity of water evaporated from adjacent soil and other surfaces and transpired by plants during a specified time period. "Reference evapotranspiration” (ETo) means a standard measurement of environmental parameters which affect the water use of plants. ETo is expressed in inches per day, month, or year and is an estimate of the evapotranspiration of a large field of four-inches to seven-inches tall, cool season grass that is well watered. Reference evapotranspiration is used as the basis of determining the MAWA so that regional differences in climate can be accommodated.

Related to Evapotranspiration rate

  • Reference evapotranspiration or “ETo” means a standard measurement of environmental parameters which affect the water use of plants. ETo is given expressed in inches per day, month, or year as represented in Appendix C of these Guidelines, and is an estimate of the evapotranspiration of a large field of four to seven-inch tall, cool-season grass that is well watered. Reference evapotranspiration is used as the basis of determining the Maximum Applied Water Allowances.

  • Infiltration rate means the rate of water entry into the soil expressed as a depth of water per unit of time (e.g., inches per hour).

  • Stress Factor means 2.25.

  • Measurement Point means the emission source for which continuous emission measurement systems (CEMS) are used for emission measurement, or the cross-section of a pipeline system for which the CO2 flow is determined using continuous measurement systems;

  • Capitation rate means the fee the department pays monthly to an HMO for each enrolled recipient for the provision of covered medical and health services whether or not the enrolled recipient received services during the month for which the fee is intended.

  • Barrier Level means the Barrier Level as specified in § 1 of the Product and Underlying Data.

  • Baseline Period means the period used to determine the baseline emission rate for each regulated pollutant under OAR 340 division 222.

  • Percolation test means a subsurface soil test at the depth of a proposed absorption system or similar component of an OWTS to determine the water absorption capability of the soil, the results of which are normally expressed as the rate at which one inch of water is absorbed. The rate is expressed in minutes per inch.

  • Lowest achievable emission rate (LAER) means for any source, that rate of emissions which reflects the most stringent emission limitation which is contained in the implementation plan of any State for such class or category of source, unless the owner or operator of the proposed source demonstrates that such limitations are not achievable, or the most stringent emission limitation which is achieved in practice by such class or category of source, whichever is more stringent. In no event shall the application of this term permit a proposed new or modified source to emit any pollutant in excess of the amount allowable under applicable New Source Standards of Performance.

  • Generator Forced Outage means an immediate reduction in output or capacity or removal from service, in whole or in part, of a generating unit by reason of an Emergency or threatened Emergency, unanticipated failure, or other cause beyond the control of the owner or operator of the facility, as specified in the relevant portions of the PJM Manuals. A reduction in output or removal from service of a generating unit in response to changes in market conditions shall not constitute a Generator Forced Outage.

  • Yearly (1/Year) sampling frequency means the sampling shall be done in the month of September, unless specifically identified otherwise in the effluent limitations and monitoring requirements table.

  • Low-level radioactive waste or “waste” means radioactive material that consists of or contains class A, B, or C radioactive waste as defined by 10 C.F.R. 61.55, as in effect on January 26, 1983, but does not include waste or material that is any of the following:

  • Yearly (1/Year) sampling frequency means the sampling shall be done in the month of September, unless specifically identified otherwise in the effluent limitations and monitoring requirements table.

  • Anaerobic digestion ’ means a controlled process involving microbial decomposition of organic matter in the absence of oxygen ;

  • Applicable Measurement Period means the most recently completed four consecutive fiscal quarters of the Issuer immediately preceding the Applicable Calculation Date for which internal financial statements are available.

  • Inflation rate means that term as defined in section 34d.

  • Shift Cycle means the period of time when the shift schedule repeats itself. In those instances where the schedule does not repeat itself, the term "Shift Cycle" shall be understood to mean a period of time not exceeding twelve (12) weeks.

  • Maximum contaminant level goal or “MCLG” means the maximum level of a contaminant in drinking water at which no known or anticipated adverse effect on the health of persons would occur, and which allows an adequate margin of safety. MCLGs are nonenforceable health goals.

  • Semi-annual (2/Year) sampling frequency means the sampling shall be done during the months of June and December, unless specifically identified otherwise.

  • Anaerobic digester means a liquid manure storage area that is constructed with the intent to capture and combust gas emissions resulting from the digestion of waste by microbes in anaerobic conditions. An anaerobic digester is a LMSA and is required to comply with all requirements applicable to LMSAs. Requirements specific to anaerobic digesters will be noted when applicable.

  • Semi-annual (2/Year) sampling frequency means the sampling shall be done during the months of June and December, unless specifically identified otherwise.

  • HICP Daily Inflation Reference Index means (A) in relation to the first day of any given month, the HICP Monthly Reference Index of the third month preceding such month, and (B) in relation to a day (D) (other than the first day) in any given month (M), the linear interpolation of the HICP Monthly Reference Index pertaining respectively to the third month preceding such month (M - 3) and the second month preceding such month (M - 2) calculated in accordance with the following formula:

  • Lowest Achievable Emission Rate (LAER) means, for any source, the more stringent rate of emissions based on the following:

  • High global warming potential hydrofluorocarbons means any hydrofluorocarbons in a particular end use for which EPA’s Significant New Alternatives Policy (SNAP) program has identified other acceptable alternatives that have lower global warming potential. The SNAP list of alternatives is found at 40 CFR Part 82 subpart G with supplemental tables of alternatives available at (http://www.epa.gov/snap/).

  • Quality factor (Q) means the modifying factor, listed in Tables I and II of 38.4(4), that is used to derive dose equivalent from absorbed dose.

  • SONIA Compounded IndexStart means, with respect to an Interest Accrual Period, the SONIA Compounded Index determined in relation to the day falling the Relevant Number of London Banking Days prior to the first day of such Interest Accrual Period; and