Expansion Joints definition

Expansion Joints. Diamond Dowel System: ¼” thick stainless steel plate, 4.5” x 4.5” square at 24 inches on center with Diamond Dowel pocket former as manufactured by PNA Construction Technologies.
View Source
Expansion Joints. The bridge shall utilize the following expansion joint: Specifier select one:  Steel Backwall Plate  Sliding Angle on Backwall Angle  Sliding Plate on Backwall Angle  Neoprene Strip Seal  Neoprene Compression Seal  Polymer Modified Asphalt (Plug) Expansion Joint  Steel channel gutters (attached to backwall)  Chain link (galvanized)  Chain link (vinyl coated)  Architectural grade, anti-climb (vinyl coated) and shall be straight or J-shaped as is applicable for either roadway or sidewalk, and as shown in the Contract Documents.
View Source
Expansion Joints has the meaning set out in Section 40 23 00 of Appendix 6-2 [Technical Specifications];
View Source

Examples of Expansion Joints in a sentence

  • Expansion Joints in concrete structures shall be provided at specified places as indicated in the drawings.

  • Expansion Joints shall be provided in the buildings wherever required.

  • Expansion Joints in the wall shall be covered from inside with 14 gauge aluminium sheet 150 mm wide fixed with appropriate fastener on one side of the wall.

  • General Cement Admixtures Water Fine Aggregate Coarse Aggregate Samples of Aggregate Classes of Concrete Quality and Proportioning of Concrete Determining Proportions Consistency of Concrete Measuring Materials Mixing Concrete Ready-Mixed Concrete Forms Embedded Work in Concrete Placing Concrete Curing and Protection Finishing Concrete Trimming and Repairs Expansion Joints Construction Joints Weep Holes All concrete shall be site-mixed or ready-mixed as produced by a plant acceptable to the Engineer.

  • Expansion Joints with softboard between vertical concrete surfaces: 5 10mm Joints with top corners finished 5mm radius not exceeding 300mm high.

  • All Expansion Joints {Steel type} will have two views, one at marriage point and one overall showing entire length of steel tested.

  • The General Trade Contractor shall furnish and install ALL INTERIOR AND EXTERIOR WOOD AND METAL BLOCKING AND BACKING, including but not limited to, general wood blocking, all roofing blocking and nailers required to form Fascias, Parapets, ▇▇▇▇▇, Expansion Joints, etc., as shown on the drawings.

  • Expansion Joints: 2” Emseal expansion joint system at the transition from grade to structure at vehicle\pedestrian entries and were asphalt meets structed parking at P1 level.

  • The third bid item under Section 6-02.5 is supplemented with the following: All costs in connection with *** Bridge Deck, Bearings, Girders, Diaphragms, Transverse Stop Bearings, Traffic Barrier, Expansion Joints and other items as listed above and minor items as described below *** shall be included in the lump sum contract price for “Superstructure - McDonald Creek Bridge”.

  • KAISER 17,684.00 Structural KAISER 3,487.00 Expansion Joints KAISER 14,865.00 Pipe/Fittings/Etc.

Related to Expansion Joints

  • Expansion Project has the meaning set forth in Section IV.3.a of this Agreement.

  • Expansion means the addition of buildings, structures, machinery or equipment for purposes of increasing production capacity.

  • Expansion Space means any space in the Building which, at any time during the Lease Term, is occupied by a Person other than Landlord under a written lease with Landlord, and the term “Tenant’s Expansion Space” means Expansion Space which Tenant has elected to lease as provided in this paragraph. Landlord agrees to notify Tenant promptly after Landlord learns that any Expansion Space is or will become available. Subject to the prior rights of other tenants to whom Landlord has granted substantially similar rights, Tenant has the option to lease any Expansion Space which Landlord notifies Tenant is or will become available. If Tenant gives Landlord notice of its exercise of this option within thirty (30) days after notification from Landlord of the availability of the Expansion Space and if no Event of Default exists when Tenant’s notice is given, this Lease will be deemed to be amended to include Tenant’s Expansion Space as part of the Premises for the remainder of the Lease Term upon all of the same terms contained in this Lease except that (i) the Rentable Area of the Premises will be amended to include Tenant’s Expansion Space; (ii) Tenant’s Share will be increased to include the rentable area of Tenant’s Expansion Space; (iii) the Term Commencement Date with respect to Tenant’s Expansion Space will be the earlier of sixty (60) days after the date on which Tenant’s Expansion Space becomes vacant and ready for occupancy (provided that date is at least sixty (60) days after Tenant exercises its option to lease the Expansion Space), or the date on which the Expansion Space is first occupied by Tenant; (iv) if Tenant’s Expansion Space contains a rentable area of 10,000 square feet or more, and if there are less than three (3) Lease Years remaining in the Lease Term, the Lease Term will be extended to include three (3) full years from the Term Commencement Date with respect to Tenant’s Expansion Space; and (v) subject to adjustment during each Fixed Rental Period as provided in Exhibit E, Basic Rent for each year of the remaining Lease Term (as it may be extended) will be the greater of (a) the Basic Rent last paid by the Person most recently occupying Tenant’s Expansion Space or (b) Market Rent determined as provided in the Rent Rider attached as Exhibit E. If Tenant exercises this option, Tenant’s Expansion Space will be leased to Tenant in its “as is” condition and Tenant will, at its expense and in compliance with the provisions of Section 7.06, design and construct all Improvements desired by Tenant for its use and occupancy. Landlord and Tenant agree to execute such amendments to this Lease and other instruments as either of them considers necessary or desirable to reflect Tenant’s exercise of this option.

  • New Project means (a) each facility which is either a new facility, branch or office or an expansion, relocation, remodeling or substantial modernization of an existing facility, branch or office owned by the Borrower or its Subsidiaries which in fact commences operations and (b) each creation (in one or a series of related transactions) of a business unit to the extent such business unit commences operations or each expansion (in one or a series of related transactions) of business into a new market.

  • Lateral expansion means a horizontal expansion of the waste boundaries of an existing MSW landfill. A lateral expansion is not a modification unless it results in an increase in the design capacity of the landfill.