Masonry Walls Sample Clauses
Masonry Walls. Masonry walls will be designed and reinforced in accordance with the applicable local and industry codes and standards.
Masonry Walls. City Engineer to establish requirements. In addition, long uninterrupted expanses of walls greater than 300’ are discouraged while offsets and open views into subdivisions at points where siding conditions exist are encouraged.
Masonry Walls. 2.01.1 Only best quality "franka" stone from a quarry and a bed approved by the Architect, free from all defects, shall be used. Any stone showing blue marks (swaba) and/or other defects on the exposed face, or whose edges or corners have been chipped, shall be rejected. Should any such stones be used, the Architect in charge shall have the power to remove and replace any such work at the Contractor's expense. The Contractor shall also be bound to replace any defective materials in all or parts of the existing works by proper materials and/or workmanship as directed by the Architect. Once the quarry and bed are selected, these shall not be changed without the approval of the Architect.
2.01.2 Mortar for laying masonry is to be composed of one part cement, three parts Upper Coralline sand and twelve parts Globigerina limestone dust, prepared in bulk with fresh water, well mixed and allowed to mature before use.
Masonry Walls. Coordinate installation of frames to allow for solidly filling space between frames and masonry with mortar as specified in Division 4 Section "Unit Masonry Assemblies."
5. In-Place Gypsum Board Partitions: Secure frames in place with post installed expansion anchors through floor anchors at each jamb. Countersink anchors, and fill and make smooth, flush, and invisible on exposed faces.