Examples of Microgrid system in a sentence
The MMC is an intelligent power control system designed to manage and automate the operation of the Microgrid system.
The proprietary interest over a Microgrid system is separate and independent from the proprietary interest over the equipment used by the Microgrid to supply Energy Services and/or Other Grid Services.
In developing a Microgrid System pursuant to this Regulation, the owner, operator and/or developer of such Microgrid system shall also ensure to fully comply with any and all applicable legal and regulatory requirements established and enforced by other relevant local, state and federal government entities.
Third-Party Microgrids may sell Energy Services and/or other Grid Services to Customers who are directly connected to the Microgrid system as well as to PREPA, subject to the non-discrimination requirements in Section 5.10 of this Regulation.
The Utility may disconnect the Microgrid, after notice to the responsible party has been provided and a reasonable time to correct, consistent with the conditions, has elapsed, if (a) the Owner has failed to make available records of verification tests and maintenance of his protective devices; (b) the Microgrid system interferes with Utility equipment or equipment belonging to other Owners of the Utility; (c) the Microgrid adversely affects the quality of service of adjoining Owners.
Any Person who fails to comply with any of the requirements set forth in this Regulation may be subject to a Notice of Non-Compliance pursuant to Chapter IV of Regulation 85432 and may, as a result of such non-compliance, lose its status as a 2 Regulation on Adjudicative, Notice of Noncompliance, Rate Review and Investigation Procedures.registered Microgrid system or be subject to any other applicable administrative sanction or penalty deemed appropriate by the Commission.
Microgrid system combines distributed generation, manageable loads, energy storage system and can be applied as an isolated energy system (island operation mode) or along with the main grid (grid-connected mode).
The Microgrid system features the Electronic Power Control and Conditioning (EPCC) module.
The power imbalance in the grid at time t is described as follows: Figure 3.5: A Micro-grid system with 5 main components where∆P (t) = PG(t) + PRE(t) − PD(t) − PEV (t) (3.51) - PG(t) : power output of the conventional power plant at time t- PRE(t): power output of the renewable energy source at time t.- PD(t): load demand at time t.- PEV (t): the total charging or discharging powers of all participating EVs. ΣNPEV (t) = PEV i(t), (3.52)i=1 - PEV i(t): power consumption of vehicle i at time t.
A Microgrid system can control itself by means of microprocessor-based control center and high-speed power electronic devices, which are utilized for fast switching of loads and power generation units (Fedorov, 2007; Narayanan, 2013).