Operating temperatures definition

Operating temperatures means maximum values of the temperature ranges, indicated in Annex 5O, at which safe and good functioning of the specific component is ensured and for which it has been designed and approved.

Operating temperatures means maximum values of the temperature ranges, indicated in Annex 5O, at which safe and good functioning of the specific component is ensured and for which it has been designed and approved. 1 As defined in the Consolidated Resolution on the Construction of Vehicles (R.E.3.), document ECE/TRANS/WP.29/78/Rev.2, para. 2. - xxx.xxxxx.xxx/xxxxx/xxxx/xx00/xx00xxx/xx00xxx/xx00xxxxxxxxxxx.xxxx

Examples of Operating temperatures in a sentence

• Operating temperatures should be kept as low as possible to minimise fume generation.

• Operating temperatures above 135oF will further accelerate the build-up of lime scale and may shorten the service life of the water heater.Water that is classified as hard and very hard must be softened to avoid water heater failure.

• Operating temperatures are now reported at 2500°F (1350°C) [ 16], which is above the maximum allowable blade metal temperature of modern superalloys.Therefore gas turbine designers have invested their efforts into two parallel research approaches.

• Operating temperatures above 135oF will further accelerate the build-up of lime scale and may shorten the service life of the water heater.Water that is classified as hard and very hard must be softened to avoid water heater failure.If the hardness of the water exceeds the maximum level of 7 grains per gallon, the water should be softened to a hardness level no lower than 5 grains per gallon.

• National Organization for Women.http://www.now.org/issues/title_ix/index.

• Operating temperatures depends on the moisture content of the incoming wood particles.After drying, all particles pass through sieves to remove some portion of these fragments, which are not included in the desired limits of the particle size.

• While the reactions depend on the operating conditions of the plant, the primary reactions are the following:Ammonia Combustion/Oxidation:4NH3 + 5 O2 🡪 4NO + 6H2O2NO + O2 🡪 2NO2 🡨🡪 N2O4 Absorption Reaction:3NO2 + H2O 🡪 2HNO3 + NO Overall Reaction:NH3 + 2O2 🡪 HNO3 + H2O Operating temperatures, pressures, and the concentration of the final acid product represent the largest difference between plants, with some differences in catalysts as well.

• Operating temperatures inside a reactor are in the range of 900-1,200ºC.

• Operating temperatures are obtained from the conversion of the pumping power into heat, as well as from external heaters.

• Operating temperatures range from near-ambient to 1,800°F, and electrical generating efficiencies range from 30 percent to over 50 percent on a Higher Heating Value (HHV) basis.