Primary disinfection definition

Primary disinfection means a treatment process for achieving inactivation of Giardia lamblia cysts, viruses, or other pathogenic organisms of public health concern to comply with the treatment technique requirements of Part 6 of this chapter.
Primary disinfection means a treatment process for ach- ieving inactivation of Giardia lamblia cysts, viruses, or other patho- genic organisms of public health concern to comply with the treatment technique requirements of Part 6 of this chapter.
Primary disinfection means disinfection to achieve a desired level of inactivation of targeted pathogenic organisms in water by chemical or physical agents as an integral part of the treatment process.

Examples of Primary disinfection in a sentence

  • Instead, the provision purports to regulate the substantive terms that can be included in residential mortgages in the first instance.

  • Primary disinfection" means a treatment process for ach- ieving inactivation of Giardia lamblia cysts, viruses, or other patho- genic organisms of public health concern to comply with the treatment technique requirements of Part 6 of this chapter.

  • TREATMENT PROCESS MONITORINGTREATMENT PROCESS MONITORING * Primary disinfection chlorine monitoring was being conducted at a location approved by Permit, Licence or Approval issued under Part V of the SDWA, or at/near a location wherethe intended CT had just been achieved.The chlorine analyzer used in calculating CT, draws from a point just past the pressure tanks, prior to treated water entering the distribution system.

  • Primary disinfection is achieved through a combination of sodium hypochlorite (chlorine), cartridge pre-filter followed by membrane cartridge filtration through ten (10) parallel filter modules and finished by ultraviolet (UV) light irradiation.

  • Primary disinfection CTs are most applicable to distribution systems if one assumes a single contamination event at any one time, such as from the source of supply, or at a specific storage facility, etc.

  • Primary disinfectionPrimary disinfection provides inactivation and/or reduction of microbial pathogens to meet specific regulatory requirements prior to water entering the distribution system.

  • Primary disinfection occurs through chlorination, and then the treated water is chloraminated, in order to maintain disinfection residual for a longer period of time.

  • Primary disinfection is to provide the initial kill of all bacteria, viruses and protozoa.

  • The following principles should ensure compliance with the UKLA Constitution and charities legislation.

  • Primary disinfection is achieved through CT prior to the first consumer, with the exception of Well 5, which uses ultraviolet disinfection.


More Definitions of Primary disinfection

Primary disinfection means a process or series of processes intended to remove or inactivate human pathogens such as viruses, bacteria and protozoa in water;
Primary disinfection means a treatment pro- cess for achieving inactivation of Giardia lamblia cysts, viruses, or other pathogenic organisms of public health con- cern to comply with the treatment technique requirements of Part 6 of this chapter.
Primary disinfection means a process that is intended to reduce the occurrence of microbiological organisms in drinking water prior to the water entering a water distribution facility;
Primary disinfection means disinfection that kills or inactivates bacteria, viruses, and other potentially harmful organisms in drinking water.
Primary disinfection means the adding of an acceptable primary disinfectant or ultraviolet light irradiation during the treatment process to provide adequate levels of inactivation of bacteria and pathogens. The effectiveness is measured through "CT" values, and the "Total Inactivation Ratio[.]," and the ultraviolet light dose. Acceptable primary disinfectants are, chlorine, ozone, ultraviolet light, and chlorine dioxide (see also "CT" and "CT99.9").
Primary disinfection means the adding of an acceptable primary disinfectant during the treatment process to provide adequate levels of inactivation of bacteria and pathogens. The effectiveness is measured through "CT" values and the "Total Inactivation Ratio." Acceptable primary disinfectants are, chlorine, ozone, and chlorine dioxide (see also "CT" and "CT99.9").

Related to Primary disinfection

  • Disinfection means a process which inactivates pathogenic organisms in water by chemical oxidants or equivalent agents.

  • Disinfection profile means a summary of daily Giardia lamblia inactivation through the treatment plant. The procedure for developing a disinfection profile is contained in s. NR 810.32.

  • Disinfect means to eliminate virtually all germs from inanimate surfaces through the use of chemicals or physical agents (e.g., heat). In the child care environment, a solution of ¼ cup household liquid chlorine bleach added to one gallon of water (or one tablespoon bleach to one quart of water) and prepared fresh daily is an effective disinfectant for environmental surfaces and other objects. A weaker solution of 1 tablespoon bleach to 1 gallon of cool water is effective for use on toys, eating utensils, etc. Commercial products may also be used.

  • explosive actuated fastening device means a tool that is activated by an explosive charge and that is used for driving bolts, nails and similar objects for the purpose of providing fixing;

  • Disinfectant means any oxidant, including but not limited to chlorine, chlorine dioxide, chloramines, and ozone added to water in any part of the treatment or distribution process, that is intended to kill or inactivate pathogenic microorganisms.

  • High global warming potential hydrofluorocarbons means any hydrofluorocarbons in a particular end use for which EPA’s Significant New Alternatives Policy (SNAP) program has identified other acceptable alternatives that have lower global warming potential. The SNAP list of alternatives is found at 40 CFR part 82, subpart G, with supplemental tables of alternatives available at (http://www.epa.gov/snap/ ).

  • Infiltration means water other than wastewater that enters a sewer system (including sewer system and foundation drains) from the ground through such means as defective pipes, pipe joints, connections, or manholes. Infiltration does not include, and is distinguished from, inflow.

  • Membrane filtration means a pressure or vacuum driven separation process in which particulate matter larger than one micrometer is rejected by an engineered barrier, primarily through a size exclusion mechanism, and which has a measurable removal efficiency of a target organism that can be verified through the application of a direct integrity test. This definition includes the common membrane technologies of microfiltration, ultrafiltration, nanofiltration, and reverse osmosis.

  • Residual disinfectant concentration (“C” in CT calculations) means the concentration of disinfectant measured in mg/l in a representative sample of water.

  • Diatomaceous earth filtration means a process resulting in substantial particulate removal in which a precoat cake of diatomaceous earth filter media is deposited on a support membrane (septum), and while the water is filtered by passing through the cake on the septum, additional filter media known as body feed is continuously added to the feed water to maintain the permeability of the filter cake.