Research aircraft definition

Research aircraft means an aircraft which falls in category (b) of Annex II to the Basic EASA Regulation(5);
Sample 1Sample 2Sample 3
Research aircraft means an aircraft which falls in category (b) of Annex II to the Basic F5... Regulation M4;‌
Sample 1

Examples of Research aircraft in a sentence

  • For this, the High Altitude and Long- Range Research aircraft HALO was used.

  • Research aircraft measure along flight trajectories, while the RSVP technique uses stationary ground-based radars monitoring a volume at flight altitude.

  • Research aircraft data provide in situ measurements of several of the satellite- and CIP-derived variables, pilot reports (PIREPS) indicate locations of observed icing conditions, and retrievals from surface-based microwave radiometers estimate liquid water path.

  • HTML KC-135 Operations Facility The KC-135 Low-G Flight Research aircraft (a predecessor of the Boeing 707) is used to fly parabolas to create 20-25 seconds of weightlessness so that the astronauts can...

  • They are now considered as the baseline approach for the German-French methane satellite mission MERLIN and the airborne demonstrator CHARM-F to be flown on the German Research aircraft HALO.

  • NOTE: Research aircraft will accomplish phase inspections at 100 airframe hour intervals versus 200 hours used by the DOD.

  • Research aircraft typically have limitations on deployments of 8-12 hours depending on payloads and base airport altitude, temperature and runway limitations (NASA, 2002; NCAR 2003, 2006).

  • Research aircraft have played a major role in air-sea studies, especially because of their ability to quickly survey small regions of the ocean with measurements of thermodynamic quantities, winds, radiation, aerosols and trace gases.

  • All raw data of these de- vices was time-stamped and recorded using the aircraft’s Figure 1: Research aircraft D-IBUF at Toulouse Airport Table 1: Equipment of Research Aircraft D-IBUF real-time data acquisition and recording system for later post-processing.

  • Approximately one and one-half miles to the northwest of the town is the former United States Naval Auxiliary Landing Field, Crows Landing, which previously served as a practice landing field for Navy, Marine, and NASA Research aircraft.

Related to Research aircraft

  • Commercial aircraft means any civil aircraft used in flight activity for compensation or for hire.

  • Research facility means buildings and structures, including machinery and equipment, used or to be used primarily for research or experimentation to improve or develop new tangible goods or materials or to improve or develop the production processes thereto.

  • Aircraft means any machine that can derive support in the atmosphere from the reactions of the air other than the reactions of the air against the earth’s surface;

  • MSAA Indicator Technical Specifications document means, as the context requires, either or both of the document entitled “Multi-Sector Service Accountability Agreement (MSAA) 2019-20 Indicator Technical Specifications November 5, 2018 Version 1.3” and the document entitled “Multi-Sector Service Accountability Agreement (MSAA) 2019-20 Target and Corridor-Setting Guidelines” as they may be amended or replaced from time to time;

  • Public aircraft means an aircraft used exclusively in the service of any government or of any political subdivision thereof, including the government of any state, territory, or possession of the United States, or the District of Columbia, but not including any government-owned aircraft engaged in carrying persons or property for commercial purposes.

  • Engine Manufacturer means CFM International, Inc.

  • Unmanned aircraft system means an unmanned aircraft and associated elements, including communication links and components that control the unmanned aircraft that are required for the pilot in command to operate safely and efficiently in the national airspace system.

  • Double Phase Aerosol Air Freshener means an aerosol air freshener with the liquid contents in two or more distinct phases that requires the product container be shaken before use to mix the phases, producing an emulsion.

  • Unmanned aircraft means any aircraft operating or designed to operate autonomously or to be piloted remotely without a pilot on board;

  • Research Use shall have the meaning given in Section 2.2.2 of this Agreement.

  • Construction Phase Services means the coordination, implementation and execution of the Work required by this Agreement, which are further defined in Article 8.

  • Tourism destination project means a qualified non-gaming business facility that will be among the most visited privately owned or operated tourism or recreation sites in the State, and which is located within the qualified incentive area and has been determined by the authority to be in an area appropriate for development and in need of economic development incentive assistance, including a non-gaming business within an established Tourism District with a significant impact on the economic viability of that District.

  • large aircraft means an aircraft, classified as an aeroplane with a maximum take-off mass of more than 5 700 kg, or a multi-engined helicopter;

  • Digital audio-visual work means a series of related images which, when shown in succession, imparts an impression of motion, together with accompanying sounds, if any.

  • technical specification means a document that prescribes technical requirements to be fulfilled by a product, process or service;

  • Single Phase Aerosol Air Freshener means an aerosol air freshener with the liquid contents in a single homogeneous phase and which does not require that the product container be shaken before use.

  • Development Phase means the period before a vehicle type is type approved.

  • Manufacturing Facility means buildings and structures, including machinery and equipment, the primary purpose of which is or will be the manufacture of tangible goods or materials or the processing of such goods or materials by physical or chemical change.

  • Manufacturing Facilities means facilities engaged in the mechanical or chemical transformation of materials or substances into new products and shall include:

  • Civil aircraft means any aircraft other than a public aircraft.

  • Technical Specifications A specification in a document defining the characteristics of a product or a service, such as the quality levels, the environmental and climate performance levels, the design for all needs, including accessibility for people with disabilities, and the evaluation of conformity, of product performance, of the use of the product, safety or dimensions, as well as requirements applicable to the product as regards the name by which it is sold, terminology, symbols, testing and test methods, packaging, marking or labelling, instructions for use, the production processes and methods at every stage in the life cycle of the supply or service, as well as the evaluation and conformity procedures;

  • Development Site means any parcel or lot on which exists or which is intended for building development other than the following:

  • Commercial Software means Software developed or regularly used that: (i) has been sold, leased, or licensed to the general public; (ii) has been offered for sale, lease, or license to the general public; (iii) has not been offered, sold, leased, or licensed to the public but will be available for commercial sale, lease, or license in time to satisfy the delivery requirements of this Contract; or (iv) satisfies a criterion expressed in (i), (ii), or (iii) above and would require only minor modifications to meet the requirements of this Contract.

  • Airport Ground Support Equipment means vehicles and equipment used at an airport to service aircraft between flights.

  • New Aircraft Has the meaning specified in the Note Purchase Agreement.

  • Manufacturer means the person or body who is responsible to the approval authority for all aspects of the type approval process and for ensuring conformity of production. It is not essential that the person or body is directly involved in all stage of the construction of the vehicle, system, component or separate technical unit which is the subject of the approval process.