Sampling probe definition

Sampling probe means a thin-walled stainless steel tube designed to extract and transfer a representative portion of aerosol from the sampling tunnel to the measurement system.
Sample 1Sample 2Sample 3

Examples of Sampling probe in a sentence

  • Particulate sampling system— S4: Sampling probe in the dilution tunnel,— Fp: Filter unit consisting of two series-mounted filters; switching arrangement for further parallel-mounted pairs of filters,— Sampling line,— Pumps, flow regulators, flow measuring units.

  • Sampling probe and filter temperatures were regulated at about 125°C.

  • These items include, but are not limited to: Sampling probe, connecting tubing, impingers, and jar containers.

  • Particulate sampling system :S4 Sampling probe in the dilution tunnel FP Filter unit consisting of two series mounted filters:Switching arrangement for further parallel mounted pairs of filters, Sampling line,Pumps, flow regulators, flow measuring units.

  • Legend: 1: Stack with exhaust gas, 2: Hydraulic connection and sensors, 3: Sampling probe, 4: Control unit, 5: Dryer and filter for dilution air, 6: M-DMA, 7: FCE, 8: DMA Controller The particle number distribution was measured by use of a Scanning Mobility Particle Sizer with a Faraday Cup Electrometer (FCE) as counter, abbreviated SMPS+E.

  • Sampling probe shall be inserted into the exhaust pipe to a depth not less than 300 mm and the reading shall be taken after the engine speed stabilises at 2500±200 rpm.

  • Physical measurements and testing methods employed were based on widely used accepted scientific practice, as described in standards and standards monograph.[5] Sampling probe was located between 0.75m to 1.2m from the floor, depends on operator‟s activities.

  • Schematic for measurement of stack gases from starboard engine: A) Sampling probe connected to heated inlet line, B) Cooling unit with water trap, C) Dilution line, D) NO and NOx analyzer (Teledyne T200M), E) CO and CO2 analyzer (Teledyne T300).

  • Sampling probe measurements of NO were significantly lower than laser measurements reported by TU Darmstadt for the H3 flame.

  • Figure 2: Left: Sampling probe of the emission sampling system (ESS) connected to the stack.

Related to Sampling probe

  • Testing means that element of inspection that determines the properties or elements, including functional operation of materials, equipment, or their components, by the application of established scientific principles and procedures.

  • Study means the investigation to be conducted in accordance with the Protocol.

  • Tests means and include such test or tests to be carried out on the part of the contractor as are prescribed in the contract or considered necessary by BHEL, in order to ascertain the quality, workmanship, performance and efficiency of the contractor or part thereof.

  • Yearly (1/Year) sampling frequency means the sampling shall be done in the month of September, unless specifically identified otherwise in the effluent limitations and monitoring requirements table.

  • Screening means the evaluation process used to identify an individual's ability to perform activities of daily living and address health and safety concerns.

  • Batch means a specific quantity of Product that is intended to be of uniform character and quality, within specified limits, and is produced during the same cycle of Manufacture as defined by the applicable Batch Record.

  • Grab sample means an individual sample collected in less than 15 minutes in conjunction with an instantaneous flow measurement.