TO VALIDATION definition

TO VALIDATION means to stamp or write on the passenger ticket an indication that the passenger ticket has been officially issued by carrier.
Sample 1Sample 2Sample 3

Examples of TO VALIDATION in a sentence

  • If necessary, the following office can advise you of the nearest distributor:1931 Thomas Road, Memphis, TN 38134, 901-800-1709 REPLACEMENTS ARE MADE SUBJECT TO VALIDATION BY EVERGREEN UV OF WARRANTY COVERAGE.Any part to be replaced must be made available in exchange for the replacement.

  • This Limited Warranty gives you specific legal Fort Smith, Arkansas 72917-7010 LaMirada, California 90638 rights, and you may also have other rights which vary from state 479-646-4311 866-251-4090 to state.The Manufacturer suggests that you immediately complete theHOWEVER, ANY REPLACEMENTS ARE MADE SUBJECT information at the bottom of this Limited Warranty Certificate TO VALIDATION BY THE MANUFACTURER’S IN-WAR- and retain this Limited Warranty Certificate in the event warran- RANTY COVERAGE.

  • Old Greenwood Road 14300 Alondra BoulevardFort Smith, Arkansas 72917-7010 LaMirada, California 90638479-646-4311 310-860-7761HOWEVER, ANY REPLACEMENTS ARE MADE SUBJECT TO VALIDATION OF IN-WARRANTY COVERAGE.

  • TASKS PRIOR TO VALIDATION OF CONTROL MEASURES Prior to the validation of control measures by the food establishment, it is important to complete certain tasks so that validation can be accomplished effectively and efficiently.

  • It shall be a violation of these rules to allow the discharge of liquids such as fuels, oils, greases, lavatory fluids, or battery acid onto the airfield, apron, or RON areas, even in tenant-controlled areas.

  • If necessary, the following office can advise you of the nearest.ICECOP.O. Box 17010 (FOR CALIFORNIA ONLY) 5600 Old Greenwood Road 14300 Alondra Boulevard Fort Smith, Arkansas 72917-7010 LaMirada, California 90638 479-646-4311 866-251-4090 HOWEVER, ANY REPLACEMENTS ARE MADE SUBJECT TO VALIDATION BY THE MANUFACTURER’S IN-WARRANTY COV-ERAGE.

  • PSDP WORKING GROUP ON POWER SYSTEM DYNAMIC MODELING AND SYSTEM WIDE POWER SYSTEM MODEL VALIDATION PANEL SESSIONAPPROACHES TO VALIDATION OF POWER SYSTEM MODELS FOR SYSTEM PLANNING STUDIES 3414P.

  • Note: the term “pre-empt” might be misleading.ECTL: provide material for TM explaining priority and preemption AeroMACS_VVO_Interop_04 Suggestion to add: APPENDIX TO VALIDATION REPORT: Remind SESAR references and explain that in chapter 4.1 a table refers to the tests related to the VVO.

  • RESPONSE TO VALIDATION COMMITTEE COMMENTS 66References Section Three 75 APPENDIX A BIO SKETCHES...........................................................................

  • Please describe the types of products and/or services your business provides?Does your business accept purchasing card/credit card payments:YesNo?Are discounts offered for early payments:YesNo. If “Yes” list the discounts your business provides:2NOTE: ALL APPLICATIONS ARE SUBJECT TO REVIEW AND INVESTIGATION PRIOR TO VALIDATION A COPY OF YOUR COMPANY’S LETTERHEAD AND A W-9 MUST BE INCLUDED IN ORDER FOR YOUR APPLICATION TO BE COMPLETED.

Related to TO VALIDATION

  • Validation as used in WAC 222-20-016, means the department's agreement that a small forest landowner has correctly identified and classified resources, and satisfactorily completed a roads assessment for the geographic area described in Step 1 of a long-term application.

  • traceability means the ability to trace and follow a food, feed, food-producing animal or substance intended to be, or expected to be incorporated into a food or feed, through all stages of production, processing and distribution;

  • durability means the ability of components and systems to last so that the environmental performance can still be met after a mileage set out in paragraph 2.4. and so that vehicle functional safety is ensured, if the vehicle is used under normal or intended circumstances and serviced in accordance with the manufacturer’s recommendations.

  • Stability means structural stability.

  • Permeability of a space means the ratio of the volume within that space which is assumed to be occupied by water to the total volume of that space.

  • Validate means to determine by checking tolerances the validity of the reading of a meter.

  • Service Component means certain enabling Software, hardware peripherals and associated documentation which may be separately provided by Symantec as an incidental part of a Service.

  • Licensure means the status of a licensee when OCCL issued a child care license when the applicant demonstrated compliance with these regulations and applicable codes, regulations, and laws.

  • Architectural coating means a coating applied to stationary structures and their appurtenances, to mobile homes, to pavements, or to curbs.

  • Standard Methods for the Examination of Water and Wastewater means the most recent edition of Standard Methods for the Examination of Water and Wastewater published jointly by the American Public Health Association, the American Waterworks Association and the Water Environment Federation;

  • Complications of Pregnancy means conditions whose diagnoses are distinct from pregnancy but are adversely affected by pregnancy or are caused by pregnancy. These conditions include acute nephritis, nephrosis, cardiac decompensation, missed abortion and similar medical and surgical conditions of comparable severity. Complications of pregnancy also include nonelective cesarean section, ectopic pregnancy which is terminated and spontaneous termination of pregnancy, which occurs during a period of gestation in which a viable birth is not possible.

  • Repeatability means the range of values within which the repeat results of cigarette test trials from a single laboratory will fall 95 percent of the time.

  • Nonambulatory means a person who immediately and without the aid of another is not physically and mentally capable of traveling a normal path to safety, including the ascent and descent of stairs.

  • In-patient means a person admitted to a hospital as a resident or bed- patient and who is provided at least one day's room and board by the hospital.

  • In Patient Care means treatment for which the insured person has to stay in a hospital for more than 24 hours for a covered event.

  • Thesis means a work involving personal research, that is (a) capable of being recorded in any form or medium, and (b) capable of being evaluated, that is submitted for a doctoral degree and satisfies the requirements specified in the relevant rules.

  • compatibility means compatibility as defined in point (10) of Article 2 of Directive (EU) 2019/770;

  • CEC Certification and Verification means that the CEC has certified (or, with respect to periods before the Project has commenced commercial operation (as such term is defined by and according to the CEC), that the CEC has pre-certified) that the Project is an ERR for purposes of the California Renewables Portfolio Standard and that all Energy produced by the Project qualifies as generation from an ERR for purposes of the Project.

  • Prosthesis means an artificial substitute for a missing body part.

  • Habilitation means the process by which a person is assisted

  • Turbidity means the cloudy condition of water due to the presence of extremely fine particulate materials in suspension that interfere with the passage of light.

  • Affordability means a housing unit that satisfies at least one of the following criteria:

  • FedRAMP means the Federal Risk and Authorization Management Program (see xxx.xxxxxxx.xxx), which is an assessment and authorization process that federal government agencies have been directed to use to ensure security is in place when accessing Cloud computing products and services.

  • Outpatient treatment means mental health or substance abuse treatment services rendered to a

  • Waiver or variance means action by the board which suspends in whole or in part the requirements or provisions of a rule as applied to an identified person on the basis of the particular circumstances of that person. For simplicity, the term “waiver” shall include both a “waiver” and a “variance.”

  • Interoperability means the ability of a Qwest OSS Function to process seamlessly (i.e., without any manual intervention) business transactions with CLEC's OSS application, and vice versa, by means of secure exchange of transaction data models that use data fields and usage rules that can be received and processed by the other Party to achieve the intended OSS Function and related response. (See also Electronic Bonding.)