Examples of Total PCBs in a sentence
If multiple Aroclors are detected, they should be summed and reported as Total PCBs. If congener specific analysis is done using Method 8082A, clean up steps of the extract shall be performed as necessary to remove interference and to achieve as close to a limit of detection of 0.003 mg/kg as possible for each congener.
If multiple Aroclors are detected, they should be summed and reported as Total PCBs. If the LOD cannot be achieved after using the appropriate clean up techniques, a reporting limit that is achievable for the Aroclors or each congener for the sample shall be determined.
For the purpose of reporting on the Discharge Monitoring Reports, the permittee shall calculate concentration and loading levels of Total PCBs in this same manner; however, the result of any individual aroclor measurement less than the quantification level but greater than the detection level shall be reported on the Daily Discharge Monitoring Reports (see Part II.C.2.).
The permittee shall analyze the sludge for Total PCBs one time during 2021.
Total PCBs is defined as the sum of any identified Aroclors, including, but not limited to, Aroclors 1242, 1248, 1254 and 1260.
Consistent with the federal requirement and with the NPDES Permit Writer’s Manual (EPA-833-K-10-001, September 2010), Average Monthly and Annual Average effluent limitations have been included in this Order/Permit for DDT and Total PCBs for which WLAs have been assigned to HTP through the Santa Monica Bay TMDL for DDT and PCBs.
The Santa Monica Bay TMDL for DDT and PCBs includes WLAs for DDT (10.1 ng/L and 5,850 g/yr) and for Total PCBs (0.271 ng/L and 157 g/year) for HTP.
The sampling procedures, preservation and handling, and analytical protocol for compliance monitoring for Total PCBs shall be in accordance with EPA Method 608.
The permittee shall analyze the sludge for Total PCBs one time during 2025.
The permittee shall analyze the sludge for Total PCBs one time during 2026.