Wheel base definition

Wheel base means the distance between the perpendicular lines constructed to the longitudinal median plane (of the vehicle) from the previously defined points A or B corresponding to two consecutive wheels situated on the vehicle, according to ISO Standard 612-1978, term No.6.4.
Sample 1Sample 2Sample 3
Wheel base means the distance from the centre of the front wheel to the centre of the rear wheel and in case the vehicle is fitted with more than one rear axle the distance measured in accordance with regulation 21(11).
Sample 1Sample 2
Wheel base means the dimension measured horizontally and parallel to the longitudinal axis of the vehicle between the front and the rear wheel centrelines at unladen mass and—
Sample 1Sample 2

Examples of Wheel base in a sentence

  • Wheel base is measured from back of rear rim to back of front rim.

  • Chassis must have a minimum Wheel base of 280 (two hundred and eighty) inches.

  • In 2015, other S-Class variants (i.e. Standard Wheel base W222, Long Wheel Base V222, Maybach S600 X222 and the Maybach Pullman Limousine) began offering Magic Sky Control™ as an option.

  • Rates for "Hill Route with load restriction" will apply only on routes where restrictions are imposed by the Government authorities on Axle load and/or Wheel base.

  • The design of a taxiway shall be such that, when the cockpit of the aeroplane for which the taxiway is intended remains over the taxiway centre line markings, the clearance distance between the outer main wheel of the aeroplane and the edge of the taxiway shall be not less than that given by the following tabulation: Note: Wheel base means the distance from the nose gear to the geometric centre of the main gear.

  • In addition to its existing authority, the Board may establish by order or rule a volumetric charge to customers for the support of energy efficiency programs that meet the requirements of section 218c of this title.

  • Maximum length: 590 mmMaximum width: 310 mm, including wheels Wheel base: between 320 - 370 mmMinimum height: 155 mm with chassis plate on 20 mm blocks.

  • Maximum length: 590 mmMaximum width: 310 mm, including wheels Wheel base: between 320 - 379 mmMinimum height: 155 mm with chassis plate on 20mm blocks.

  • A sketch showing plan/elevation of RCRV-MFBW machine(After road vehicle is converted to RCRV-MFBW machine) with salient dimensions: i) Overall length of the carrier vehicle :: ii) Wheel base: ii) Overall height: iv) Overall width.

  • Wheel base datum points must remain within 25mm of the standard specification.

Related to Wheel base

  • Capital Base means capital as specified by the central bank from time to time;

  • Load Factor means the ratio of average demand for a designated time period (usually one month) to the maximum demand occurring in that period;

  • Vapor balance system means a combination of pipes or hoses which create a closed system between the vapor spaces of an unloading tank and a receiving tank such that vapors displaced from the receiving tank are transferred to the tank being unloaded.

  • Stress Factor means 2.25.

  • Baseline area means any intra- state area (and every part thereof) des- ignated as attainment or unclassifiable under section 107(d)(1)(A)(ii) or (iii) of the Act in which the major source or major modification establishing the minor source baseline date would con- struct or would have an air quality im- pact for the pollutant for which the baseline date is established, as follows: equal to or greater than 1 μg/m3 (an- nual average) for SO2, NO2, or PM10; or equal or greater than 0.3 μg/m3 (annual average) for PM2.5.(ii) Area redesignations under section 107(d)(1)(A)(ii) or (iii) of the Act cannot intersect or be smaller than the area of impact of any major stationary source or major modification which:

  • total system means the transmission system and the distribution system of the Board taken together;

  • Average Monthly Limit means the maximum allowable "Average Monthly Concentration" as defined in Section 22a-430-3(a) of the RCSA when expressed as a concentration (e.g. mg/l); otherwise, it means "Average Monthly Discharge Limitation" as defined in Section 22a-430-3(a) of the RCSA.

  • Model Year means the CI engine manufacturer’s annual production period, which includes January 1st of a calendar year, or if the manufacturer has no annual production period, the calendar year.

  • Diameter at breast height (dbh) means the diameter of a tree at 4 1/2 feet above the ground measured from the uphill side.

  • Total Revenues means revenues from all taxes and fees, excluding revenue from funds managed by local government on behalf of a specific third party, and does not include the proceeds from borrowing or asset sales.

  • Worst Value means, in respect of a SPS Valuation Date, the lowest Underlying Reference Value for any Underlying Reference in the Basket in respect of such SPS Valuation Date.

  • MONTHLY KILOMETREAGE STATEMENT CUM BILL means the format specified by the Company.

  • Unrecovered Initial Unit Price means at any time, with respect to a Unit, the Initial Unit Price less the sum of all distributions constituting Capital Surplus theretofore made in respect of an Initial Common Unit and any distributions of cash (or the Net Agreed Value of any distributions in kind) in connection with the dissolution and liquidation of the Partnership theretofore made in respect of an Initial Common Unit, adjusted as the General Partner determines to be appropriate to give effect to any distribution, subdivision or combination of such Units.

  • Total Revenue bears the same meaning assigned to this expression in the Codes of Good Practice on Black Economic Empowerment, issued in terms of section 9(1) of the Broad-Based Black Economic Empowerment Act and promulgated in the Government Gazette on 9 February 2007;

  • Life-cycle cost means the expected total cost of ownership during the life of a product, including disposal costs.