Marking and checks. These doors are subject to the integrated BENOR/ATG procedure, which enables the manufacturer to obtain permission to use the BENOR/ATG mark shown below. The BENOR/ATG mark of conformity takes the form of a thin adhesive label (diameter: 22 mm), based on the following model: These marks are numbered. They are issued to the manufacturer exclusively by Bosec. This mark is added (in the recess) in the factory by the manufacturer on the vertical edge of the 3rd component in the lower part of the door leaf. No marks must be displayed on the frame. Only by displaying the above-described XXXXX/ATG mark on a component can the manufacturer certify that this component complies with the relevant description included in this approval document:
