System Description The wet detention basin is designed to trap 80% of sediment in runoff and maintain pre-development downstream peak flows. The basin has two forebays (smaller ponds) located at the low end of two grass xxxxxx. In addition to runoff conveyance, the grass xxxxxx also allow infiltration and filtering of pollutants, especially from smaller storms. The forebays are each 4 feet deep. They are connected to the main pool by 18 and 24-inch metal pipes that outlet onto a rock chute. The forebays will trap coarse sediments in runoff, such as road sands, thus reducing maintenance of the main basin. The main pool will trap the finer suspended sediment. To do this, the pond size, water level and outlet structures must be maintained as specified in this Agreement (see Figures 1, 2 and 3). The main basin receives runoff from a 67.1 acre drainage area (41.2 acres within the subdivision and 25.9 acres off-site drainage coming from the east). During high rainfall or snow melt events, the water level will temporarily rise and slowly drain down to the elevation of the control structure. The water level is controlled by a 12-inch concrete pipe extending through the berm in the northwest corner of the basin (see Figures 1 and 3). On the face of the 12-inch pipe, there is metal plate with a 3-inch drilled hole (orifice) with stone in front of it. This orifice controls the water level and causes the pond to temporarily rise during runoff events. Washed stone (1- 2” diameter) is placed in front of the orifice to prevent clogging. High flows may enter the grated concrete riser or flow over the rock lined emergency spillway. “As-built” construction drawings of the basin, showing actual dimensions, elevations, outlet structures, etc. will be recorded as an addendum(s) to this agreement within 60 days after [Municipality Name] accepts verification of construction from the project engineer.
Program Description The employer agrees to provide a vision benefit to eligible employees and dependents. The vision benefit provided by the State shall have an employee co-payment of $10 for the comprehensive annual eye examination and $25 for materials.
Short Description Post-Bachelor's
Service Description 2.1 General
Task Description This task includes activities associated with permit-required monitoring conducted in accordance with the conditions specified by state or federal regulatory agencies. All monitoring tasks must be located within or adjacent to the Project area and follow the Department’s Regional Coastal Monitoring Program and FWC's marine turtle and shorebird monitoring programs. Guidance for monitoring of nearshore resources is available in the Department's Standard Operation Procedures For Nearshore Hardbottom Monitoring Of Beach Nourishment Projects. The Local Sponsor must submit work products directly to the appropriate state or federal regulatory agencies in accordance with permit conditions to be eligible for reimbursement under this task, unless otherwise directed.
Service Descriptions Credit Card processing services: Global Direct’s actions to the appropriate card associations and/or issuers (e.g., Visa, MasterCard, Diners, Discover); settlement; dispute resolution with cardholders’ banks; and transaction-related reporting, statements and products. Debit/ATM Processing Services: Global Direct has connected to the following debit card networks (“Networks”): Accel, AFFN, Interlink, MAC, Maestro, NYCE, Pulse, Star, and Tyme. Global Direct will provide Merchant with the ability to access the Networks that Global Direct has connected to for the purpose of authorizing debit card transactions at the point of sale from cards issued by the members of the respective Networks. Global Direct will provide connection to such Networks, terminal applications, settlement and reporting activities. EBT Transaction Processing Services: Global Direct offers electronic interfaces to Electronic Benefits Transfer (“EBT”) networks for the processing of cash payments or credits to or for the benefit of benefit recipients (“Recipients”). Global Direct will provide settlement and switching services for various Point of Sale transactions initiated through Merchant for the authorization of the issuance of the United States Department of Agriculture, Food and Nutrition Services (“FNS”) food stamp benefits (“FS Benefits”) and/or government delivered cash assistance benefits (“Cash Benefits, ”with FS Benefits, “Benefits”) to Recipients through the use of a state-issued card (“EBT Card”). With respect to Visa and MasterCard products, Merchant agrees to pay and Merchant's account(s) will be charged pursuant to Section 5 of this Agreement for any additional fees incurred as a result of Merchant's subsequent acceptance of transactions with any Visa or MasterCard product that it has not elected to accept.
Investment Description Each Fund will invest and reinvest its assets in accordance with the investment objective(s), policies and limitations specified in the prospectus (the “Prospectus”) relating to such Fund filed with the Securities and Exchange Commission (the “SEC”) as part of the Fund’s Registration Statement on Form N-1A, as it may be periodically amended or supplemented and in accordance with exemptive orders and no-action letters issued to the Trust by the SEC and its staff.
Topic Description Notices All notices must be in writing (with electronic mail or Xxxxxx Xxx postings to Xxxxxx Mae internet sites deemed to be a "writing" for this purpose) and delivered by (a) hand, (b) a reputable overnight courier (fees prepaid), (c) first class United States mail, registered or certified mail, return receipt requested (postage prepaid), (d) electronic mail, or (e) posting by Xxxxxx Xxx to an applicable Xxxxxx Mae internet site. Any notice directed to Xxxxxx Xxx shall be addressed to "Xxxxxx Mae Legal Department, Attn: Official Contract Notice,” at Xxxxxx Mae’s corporate headquarters or to an e‐mail address confirmed in writing by Xxxxxx Mae as valid for receipt of notices. Except as provided in (e) above, any notice directed to Licensee shall be addressed to a Corporate Administrator at an address or electronic mail address provided to Xxxxxx Xxx by Licensee or Licensee’s corporate headquarters. Issued Bulletins; Amendments Xxxxxx Mae may issue hard‐copy bulletins or electronic bulletins (via electronic mail or posted to an applicable Xxxxxx Xxx internet site) amending the Agreement on a prospective basis, effective on the date specified by Xxxxxx Mae in the bulletin. Each bulletin will be issued at least 20 calendar days before its effective date, except for bulletins granting license rights in additional licensed applications and those relating to software and other materials provided by Third‐Party Licensors, which may be issued at any time prior to their effective date. Licensee may reject any bulletin by providing written notice to Xxxxxx Xxx within 15 calendar days after receipt of such bulletin, in which case Xxxxxx Mae may terminate the Agreement or any affected Schedule(s) effective as of the effective date of the bulletin. Unless Licensee provides such rejection notice within the 15‐ day period, Licensee is deemed to have accepted such amendments, and such amendments will form part of the Agreement as of the effective date of such bulletin. Licensee’s continued use of any affected Licensed Application is an acknowledgment of its acceptance. Otherwise, the terms of the Agreement may be amended solely by a writing executed by a duly authorized representative of each party to be bound thereby. The Agreement may not be amended by any purchase order or other written instrument submitted by Licensee, whether or not formally rejected by Xxxxxx Xxx. Entire Agreement; Priority The Agreement constitutes the complete and exclusive statement of the agreement between the parties regarding the subject matter of each Schedule (or, if no Schedule has been entered into, regarding access to Xxxxxx Mae’s Topic Description technology and systems), and supersedes all prior or contemporaneous communications, proposals or agreements, oral or written, relating to the subject matter of the Agreement. Without further action on the part of either party, any (a) schedules entered into pursuant to such agreement(s) are deemed to be Schedules under the Master Terms and (b) references in any Schedules and associated forms to “Licensed Software” are deemed to be references to “Licensed Application.” If there is any conflict between a term or condition of any Schedule and the Master Terms, the term or condition contained in the Schedule will take precedence over the conflicting term or condition of the Master Terms, but only in connection with the Licensed Materials that are governed by that Schedule. Jurisdiction; Waiver of Jury Trial All disputes between the parties that cannot be settled by mutual agreement must be resolved solely and exclusively in the courts located within the state of New York, and Licensee hereby consents to the jurisdiction of such courts and irrevocably waives any objections thereto, including on the basis of improper venue or forum non conveniens. EACH OF THE PARTIES IRREVOCABLY WAIVES ALL RIGHT TO TRIAL BY JURY IN ANY LEGAL PROCEEDING ARISING OUT OF OR RELATING TO THE AGREEMENT. Third‐Party Beneficiaries Applicable Third‐Party Licensors are intended beneficiaries of the Agreement and may rely upon and directly enforce the terms and conditions of the Agreement to the extent it affects their rights or obligations. There are no other third party beneficiaries of the Agreement. U.S. Government If Licensee is any unit or agency of the U.S. Government, the Licensed Materials are provided as “commercial computer software” and “commercial computer software documentation,” respectively, under FAR 12.212 and, accordingly, use, duplication, and disclosure of the Licensed Materials by the U.S. Government is subject to restrictions set forth in the Agreement. Foreign Users Licensee is responsible for ensuring that the Licensed Materials are not used by any national (citizen or lawful permanent resident) of “Country Group E,” as that term is defined by the Export Administration Regulations, 15 C.F.R. 740 et. seq., nor may Licensee take any steps to facilitate such use. No Implied Waiver No term, provision or clause of the Agreement will be deemed waived and no breach excused unless such waiver or excuse is in writing and executed by a duly authorized representative of the party to be bound by it. Any waiver by a party of a breach by the other does not constitute a consent to, waiver of, or excuse for any different or subsequent breach. Independent Parties The parties are independent contractors. Nothing in the Agreement will be construed to make the parties partners, joint venturers, representatives or agents of each other, nor may either party so represent to any third person. Third‐Party Providers and Xxxxxx Xxx are not partners, joint venturers, representatives or agents of each other.
Work Description T-804 Opening Roads - Removal of closure devices, cleaning ditches, removing berms, and blading the traveled-way T-811 Closing Roads - Entrance treatment for 150' cross-rip; debris block (slash, earth, berm, rocks, etc.) + seed + water bar T-811 Closing Roads - Water bar frequency per BMPs for remainder of road T-811 Closing Roads - Engineering Rep. or Construction Inspector must be notified prior to performing closeout ple S am 76P Single Lane / Level 1 76 0.00 Ending 0.30
Overtime Description Time and one half the regular rate for Saturday for the first eight hours worked. Double time the regular rate for Saturday for work performed in excess of eight hours. Overtime Time and one half the regular rate after an 8 hour day. Double time the regular rate for Sunday. Double time the regular rate for work on the following holiday(s). Paid Holidays New Year's Day Xxxxxxx's Birthday President's Day Memorial Day Independence Day Labor Day Columbus Day Veteran's Day Thanksgiving Day Christmas Day Employees must work at least one day in the payroll week in which the holiday occurs to receive the paid holiday (Operating Engineer Local #15-D) ENGINEER - OPERATING Back Filling Machines, Cranes, Mucking Machines and Dual Drum Paver. Effective Period: 7/1/2015 - 6/30/2016 Wage Rate per Hour: $71.75 Backhoes, Power Shovels, Hydraulic Clam Shells, Steel Erection, Moles and machines of a similar nature. Effective Period: 7/1/2015 - 6/30/2016 Wage Rate per Hour: $74.29 Mine Hoists, Cranes, etc. (Used as Mine Hoists) Effective Period: 7/1/2015 - 6/30/2016 Wage Rate per Hour: $76.67 Gradealls, Keystones, Cranes on land or water (with digging buckets), Bridge Cranes, Vermeer Cutter and machines of a similar nature, Trenching Machines. Effective Period: 7/1/2015 - 6/30/2016 Wage Rate per Hour: $74.84 Pile Drivers & Rigs (employing Dock Builder foreperson): Xxxxxxx Xxxxx, Tunnel Shovels. Effective Period: 7/1/2015 - 6/30/2016 Wage Rate per Hour: $73.36 Mixers (Concrete with loading attachment), Concrete Pavers, Cableways, Land Derricks, Power Houses (Low Air Pressure Units). Effective Period: 7/1/2015 - 6/30/2016 Wage Rate per Hour: $69.69 Barrier Movers , Barrier Transport and Machines of a Similar Nature. Effective Period: 7/1/2015 - 6/30/2016 Wage Rate per Hour: $56.25 Utility Compressors Effective Period: 7/1/2015 - 6/30/2016 Wage Rate per Hour: $43.63 Horizontal Boring Rig Effective Period: 7/1/2015 - 6/30/2016 Wage Rate per Hour: $66.26 Elevators (manually operated as personnel hoist). Effective Period: 7/1/2015 - 6/30/2016 Wage Rate per Hour: $60.89 Compressors (Portable 3 or more in battery), Driving of Truck Mounted Compressors, Well-point Pumps, Tugger Machines Well Point Pumps, Churn Drill. Effective Period: 7/1/2015 - 6/30/2016 Wage Rate per Hour: $47.28
