Application Process The employees wishing to enter into a job share arrangement will apply in writing to the Employer and forward a copy to the Union outlining the proposed commencement date of the job share, how the hours and days of work will be shared and how communication and continuity of work will be maintained. The Employer shall communicate a decision on a job share request in writing to the applicants. Applications to Job Sharing shall not be unreasonably denied.
Application Procedures i) An employee applies for a listing on the system-wide registry through the employee’s Human Resources Department by completing the form in Appendix A. ii) The institution will immediately forward the completed form to the PSEA who will list eligible employees on the system-wide registry. iii) A registrant is responsible to ensure the information is current and to immediately notify the Employer and the local Union if the registrant is no longer available for employment through the Registry.
Application Procedure 7.4.1. Application Priority........................................ 7.4.2. [Reserved].................................................. 7.4.3. Advance Payments............................................
Selection Process The Mortgage Loans were selected from among the outstanding one- to four-family mortgage loans in the Seller's portfolio at the related Closing Date as to which the representations and warranties set forth in Subsection 9.02 could be made and such selection was not made in a manner so as to affect adversely the interests of the Purchaser;
Application Form To apply for a pole attachment or conduit occupancy license under this Agreement, Applicant shall submit to SWBT two signed copies of the appropriate application forms. SWBT represents that the forms specified in subsections (a)-(b) are forms in use prior to the effective date of this Agreement and that SWBT is in the process of revising such forms to conform to the provisions of this Agreement and to streamline the application process. The parties therefore agree that the forms specified in subsections (a) and (b) will be interim forms only. SWBT reserves the right to change the format and content of these forms upon 60 days written notice to Applicant. (a) To apply for a pole attachment license, Applicant shall submit to SWBT two signed copies of SWBT’s Form SW-9434 (“Access Application and Make- Ready Authorization”) together with completed Form SW-9433 (“Pole Attachments”). An application for a pole attachment license will not be complete or subject to processing by SWBT until these forms have been submitted to SWBT; provided, however, that such forms will be deemed to be substantially complete if they contain the information specified in subsections (c)-(h) below, as applicable. Copies of Forms SW-9433 and SW-9434 are attached to this Agreement as parts of APPENDIX III. (b) To apply for a conduit occupancy license, Applicant shall submit to SWBT two signed copies of SWBT’s Form SW-9434 (“Access Application and Make-Ready Authorization”) together with completed Form SW-9435 (“Conduit Occupancy”). An application for a conduit occupancy license will not be complete or subject to processing by SWBT until these forms have been submitted to SWBT; provided, however, that such forms will be deemed to be substantially complete if they contain the information specified in subsections (c)-(h) below, as applicable. Copies of Forms SW-9434 and SW-9435 are attached to this Agreement as parts of APPENDIX III. (c) Each application for a license under this Agreement shall include, at a minimum, the following information: (1) the poles, ducts, and conduits (including all manholes) along Applicant’s proposed route to or within which Applicant desires to attach or place its facilities; (2) a description of the facilities to be attached to SWBT’s poles and a description of the facilities to be placed within each component of SWBT’s conduit system (including but not limited to ducts, conduits, manholes, and handholes) along the proposed route; (3) for poles, the proposed points of attachment; (4) for building entrance or building distribution ducts or conduits or other space within a building, a conspicuous statement, as required by Section 5.06 of this Agreement, that the application pertains to a building entrance or building distribution duct or conduit or other space within a building; (5) if applicable, a conspicuous notation that the space requested is not to be assigned (or billed) to Applicant until SWBT has received Applicant’s written instruction to make such assignment or issued a license authorizing Applicant to occupy the space requested; and (6) if applicable, a conspicuous statement that Applicant intends to occupy the space before the issuance of a license, as provided in Section 8.03 of this Agreement. (d) Facilities descriptions which apply to multiple pole attachments or conduit occupancies need only be described once on any form. Facilities descriptions shall include, at a minimum, the following information: (1) the number and types of cables, including the physical size (diameter) and weight (weight per foot); (2) the number and types of strands, if any, which will be used to support the cables, including the rated holding capacity expressed in thousand pound increments (e.g., 2.2M) of such strands; and (3) sufficient information to identify and describe the physical characteristics (size, dimensions, and weight) of apparatus enclosures and other facilities to be attached to SWBT’s poles or placed in SWBT’s conduit system. (e) When it appears to Applicant that facilities modification, capacity expansion, or make-ready work may be required to accommodate Applicant’s access requests, Applicant shall describe the facilities modification, capacity expansion, or make-ready work which Applicant proposes. Applicant shall also describe its plans, if any, to use any infrequent construction technique or connectivity solution authorized under Section 6.03 to avoid high or unusual expenditures and state its reasons for the use of such technique or solution. (f) Applicant acknowledges that the poles along a particular pole line or route may include poles owned by firms (such as electric utilities) other than SWBT, that it may be necessary for SWBT to rearrange its facilities or perform other make-ready work on poles other than poles it owns or controls in order to accommodate Applicant’s request for access to SWBT’s poles and that, at the time an application is submitted, it may be difficult for Applicant to determine with certainty whether a particular pole is owned or controlled by SWBT or by another entity. Accordingly, the application shall, to the extent feasible, identify all poles utilized by SWBT (without regard to ownership) along Applicant’s proposed route. (g) Each application for a license under this Agreement shall be accompanied by a construction schedule showing Applicant’s projected dates for beginning and completing construction at the sites specified in the application. Information on this schedule may be used by SWBT’s engineering and outside plant construction personnel in scheduling work required to process Applicant’s applications and scheduling such capacity expansions, make- ready work, and facilities modifications, if any, as may be necessary to accommodate Applicant’s facilities. (h) Applicant may include multiple cables in a single license application and may provide multiple services (e.g., CATV and non-CATV services) under the same cable sheath or jacket. When both CATV and non-CATV services are provided under the same cable sheath or jacket, or CATV and non-CATV services are provided using different cables attached or lashed to the same strand or otherwise occupying the same space on a pole or the same duct or inner duct within a conduit, Applicant will so advise SWBT and SWBT shall, if permitted by law, adjust its charges to enable SWBT to charge Applicant the rate applicable to telecommunications carriers rather than the rate applicable to cable television systems solely to provide cable service.
Induction Procedures a) The parties to this Agreement acknowledge that it is in the interests of the industry that all new employees and employers on a building project understand their obligations to this Agreement and are introduced to their jobs in a manner which will help them work safely and efficiently. b) In order to achieve this it is recommended that, in conjunction with the Site Management, Job Xxxxxxx and Safety Supervisor/Safety Committee, new employees and new employers be given an explanation of the following: ⮚ The Rights and Obligations of this Agreement including its disputes/grievance resolution procedures; ⮚ The appropriate issue of work clothing and safety equipment as per this Agreement; ⮚ Safety Rules and Procedures including relevant legislation; ⮚ Superannuation entitlements; ⮚ Long Service Leave provisions; ⮚ Redundancy Pay entitlements; ⮚ Site Emergency procedures; ⮚ Award or Enterprise Agreement rates of pay; ⮚ Site-specific matters such as security, etc. procedures; ⮚ Rights, obligations and benefits of union membership. c) The induction presentation and material shall have regard to the language skills of the employee/employer.
Seniority Verification Process i. The new school district shall provide the employee with the necessary verification form at the time the employee achieves continuing contract status. ii. The employee must initiate the seniority verification process and forward the necessary verification forms to the previous school district(s) within ninety (90) days of receiving a continuing appointment in the new school district. iii. The previous school district(s) shall make every reasonable effort to retrieve and verify the seniority credits which the employee seeks to port.
Selection Procedures In selecting the Loan Assets to be Pledged pursuant to this Agreement, no selection procedures were employed which are intended to be adverse to the interests of the Lenders.
Medicaid Enrollment Treatment Grantees shall enroll as a provider with Texas Medicaid and Healthcare Partnership (TMHP) and all Medicaid Managed Care organizations in Grantee’s service region within the first quarter of this procurement term and maintain through the procurement term.
New Application for Licensure Any time after the three-month period has lapsed from the Effective Date of this Agreement and Respondent has paid the Administrative Penalty set forth in Section III, Paragraph 1 of this Order, Respondent may apply for a new mortgage loan originator license or, as applicable, petition for the reinstatement of an MLO Activity Endorsement in any or all of the Participating States with the understanding that each State Mortgage Regulator reserves the rights to fully investigate such application for licensure or petition for reinstatement of an MLO Activity Endorsement and may either approve or deny such application or petition pursuant to the normal process for such licensing or endorsement investigations. No license application or petition described in this paragraph will be denied solely based on the facts, circumstances, or consensual resolution provided for in this Agreement. Respondent further agrees that Respondent must satisfy the Administrative Penalty provision prior to submitting an application for a new mortgage loan originator license or, as applicable, petition for the reinstatement of an MLO Activity Endorsement.
