ASSIGNMENT; ADDITIONAL COMPANIES AND FACILITIES Sample Clauses

ASSIGNMENT; ADDITIONAL COMPANIES AND FACILITIES. 31 SECTION 17 AMENDMENT.............................................................................................32
AutoNDA by SimpleDocs

Related to ASSIGNMENT; ADDITIONAL COMPANIES AND FACILITIES

  • Office Space, Equipment and Facilities Provide such office space, office equipment and office facilities as are adequate to fulfill the Adviser’s obligations hereunder.

  • Equipment and Facilities For On-Site Courses, you will supply the facility and equipment as set forth at xxx.xxxxxx.xxx/xxxxxxxx/xxxxxxxxx/xxxxxxxxxxxx.xxxx. If Red Hat agrees to provide the training facilities and hardware, you will be liable for any loss or destruction of this equipment and hardware used in connection with the Training.

  • Access to Properties and Records (a) CCE shall, and shall cause TPC to, afford to ETP and ETP’s accountants, counsel and representatives full reasonable access during normal business hours throughout the period prior to the Closing Date (or the earlier termination of this Agreement pursuant to Article VII hereof) to all of the properties, books, contracts, commitments and records (including all environmental studies, reports and other environmental records and all pipeline cost-of-service and rate-related studies, reports and records related to TPC and, during such period, shall furnish to ETP all information concerning the business, properties, Liabilities and personnel related to TPC as ETP may request, provided, however, that no investigation or receipt of information pursuant to this Section 5.2 shall affect any representation or warranty of CCE or the conditions to the obligations of ETP. To the extent not located at the offices or properties of TPC as of the Closing Date, as promptly as practicable thereafter, CCE shall deliver, or cause its appropriate Affiliates to deliver to ETP all of the books of accounts, minute books, record books and other records (including safety, health, environmental, maintenance and engineering records and drawings) pertaining to the business operations of TPC and all financial and accounting records related to TPC. Such delivery shall include all work papers, pleadings, testimony, exhibits, spread sheets, research, drafts, memoranda, correspondence and other documents related to the TPC Rate Case (“TPC Rate Case Work Product”). TPC Rate Case Work Product has been and will be prepared in contemplation of litigation, and the use of TPC Rate Case Work Product has been and will be under the control of TPC’s attorneys. Notwithstanding anything to the contrary contained in this Agreement, CCE shall not be obligated to provide to ETP any documents or records relating to litigation and regulatory matters in which TPC is involved to the extent that CCE reasonably believes such documents or records are subject to the attorney-client or other applicable privilege in circumstances in which TPC is not the sole client unless the parties entitled to such attorney-client or other applicable privilege shall consent thereto and enter into an appropriate joint defense agreement for the purpose of preservation of such attorney-client or other applicable privilege. (b) The information contained herein, in the CCE Disclosure Letter or heretofore or hereafter delivered to ETP or its authorized representatives in connection with the transactions contemplated by this Agreement shall be held in confidence by ETP and its representatives in accordance with the Confidentiality Agreement until the Closing Date with respect to information relating to TPC. Following the Closing Date, CCE shall keep confidential all information related to the business and properties of TPC to the same extent as ETP is obligated to keep such information confidential in accordance with the terms of the Confidentiality Agreement (without regard to the preceding sentence) prior to the Closing Date.

  • Office Space and Facilities The Adviser will arrange to furnish the Trust office space in the offices of the Adviser, or in such other place or places as may be agreed upon from time to time, and all necessary office facilities, simple business equipment, supplies, utilities and telephone service required for managing the investments of the Trust.

  • Personnel, Office Space, and Facilities of Manager The Manager at its own expense shall furnish or provide and pay the cost of such office space, office equipment, office personnel, and office services as the Manager requires in the performance of its investment advisory and other obligations under this Agreement.

  • Construction Contracts Item A: Enter the total dollar amount of all contacts awarded on the project/ program. Item B: Enter the total dollar amount of contracts connected with this project/program that were awarded to Section 3 businesses.

  • Construction Phase - Administration of the Construction Contract INDICATE IN STATEMENT OF WORK “NOT APPLICABLE” IF SECTION IS NOT APPLICABLE 1.1.9.1. The Construction Phase will commence with the award of the Construction Contract to a selected vendor (“Contractor”) and will terminate when final payment is made by the State to the Contractor. In any event, the construction phase will not extend 60 days beyond the substantial completion date unless extended by change order. If such extension occurs, additional costs due to the ARCHITECT/ENGINEER shall be negotiated with the State. 1.1.9.2. The ARCHITECT/ENGINEER shall work with the State during the construction of the Project to provide the administration of the contract between the State and the Contractor in accordance with the terms herein and consistent with the contract between the State and the Contractor, and the extent of his/her duties and responsibilities and the limitations of his/her authority as assigned therein shall not be modified without his/her written consent. 1.1.9.3. The ARCHITECT/ENGINEER shall advise and consult with the State, and all of the State's instructions to the Contractor shall be issued through the ARCHITECT/ENGINEER after authorization by the State. 1.1.9.4. The ARCHITECT/ENGINEER shall, at all times, have access to the work wherever it is in preparation or progress. 1.1.9.5. The ARCHITECT/ENGINEER shall make periodic visits to the Project site, at least biweekly, and shall make such further visits when reasonably requested by the State, as to familiarize himself/herself with the progress and quality of the work performed and as to determine, on the basis of such visits, if such progress and quality are in accordance with the Contract Documents. The ARCHITECT/ENGINEER shall be responsible for project meeting minutes. In addition to this, the ARCHITECT/ENGINEER shall periodically report his/her findings thereon to the State, at such times as in the exercise of his/her professional judgment such findings are appropriate and at least monthly, at the conference provided for in Section 1.1.9.6, and further at such times as the State may reasonably request. The ARCHITECT/ENGINEER shall not be required to make exhaustive or continuous on-site inspections, except as required in the exercise of his/her professional judgment for said reports and, except in particular, to fulfill the commissioning requirements. The ARCHITECT/ENGINEER shall not be responsible for construction means, methods, techniques, sequences or procedures or for safety precautions and programs in connection with the work, and he/she shall not be responsible for the Contractor's failure to carry out the work in accordance with the Contract Documents except as provided for herein specifically between the State and the ARCHITECT/ENGINEER. 1.1.9.6. In preparing the bid documents, to the extent that the ARCHITECT/ENGINEER utilizes sub- consultants for their expertise, such as, but not limited to: Landscape Architects, Civil, Structural, Mechanical, and Electrical Engineers, these consultants, in effect, become an extension of the ARCHITECT/ENGINEER. Where the term ARCHITECT/ENGINEER is used in Section 1.1.9.2 as well as 1.1.9.5, it shall include those sub-consultants when work is being performed in their area of expertise. For example, the Mechanical Engineer would inspect the under slab plumbing before it is backfilled, but then wouldn’t necessarily be needed on site until the rest of the mechanical systems are being installed. The sub-consultant shall also be required to periodically inspect the progress of the “As-builts” and verify that they are up-to-date and verify such to the ARCHITECT/ENGINEER, before the ARCHITECT/ENGINEER issues the certificate of payment for that pay period. 1.1.9.7. Based upon his/her determinations and reports made under Section 1.1.9.5 of this Agreement and upon the Contractor's applications for payment, the ARCHITECT/ENGINEER shall once every month, after an on-site conference between the State, the Contractor and the ARCHITECT/ENGINEER, determine the amount then owing to the Contractor and shall then issue a certificate of payment for the amount agreed upon. The issuance of a Certificate for Payment shall constitute a representation by the ARCHITECT/ENGINEER to the State, based on such ARCHITECT/ENGINEER'S determination and report and the data supplied to him/her by the Contractor (without affecting his/her duties defined in Section 1.1.9.5.), that the work has progressed to the point indicated; that the quality of the work is in accordance with the Contract Documents (subject to the results of any specified subsequent tests required by the Contract Documents, to immaterial and insubstantial deviations from the Contract Documents, which will be corrected prior to completion, and to any further specific qualifications stated in the Certificate for Payment); and that the Contractor is entitled to such payment in the amount certified. Provided, however, the issuance of such certificate will not affect any obligations of the Contractor to the State. By issuing a certificate for payment, the ARCHITECT/ENGINEER shall not be deemed to represent that he/she has made any examination to ascertain how and for what purpose the Contractor has used the monies paid on account of the contract sum. ARCHITECT/ENGINEER shall not accept any part of the work on behalf of the State; ARCHITECT/ENGINEER may only recommend acceptance. Final acceptance is a right reserved solely to the State. 1.1.9.8. The ARCHITECT/ENGINEER shall be, in the first instance, the interpreter of the requirements of all Construction Documents, and shall have all requisite authority relating thereto for the purposes of authorizing the Contractor to proceed or stop with any component of the project after consultation and agreement with the State. The ARCHITECT/ENGINEER shall not be liable to the State for any loss or cost incurred by the State arising from delays in the construction schedule caused by any decision made by the ARCHITECT/ENGINEER in the reasonable exercise of professional judgment either to exercise or not to exercise his/her authority to stop the Work. 1.1.9.9. The ARCHITECT/ENGINEER shall review and respond to shop drawings, samples, and other submissions of the Contractor as in conformance with the design concept and information in the Contract Documents and the designs and plans relating to the project until approved or not requiring re-submission. The ARCHITECT/ENGINEER shall also review the submittal log at construction meetings and report to the State, on a monthly basis, their findings thereon. 1.1.9.10. The ARCHITECT/ENGINEER shall prepare all change orders and supporting data for the State's approval. 1.1.9.11. The ARCHITECT/ENGINEER shall conduct inspections to determine the Dates of Substantial Completion and Final Completion and shall receive written guarantees and related documents assembled by the Contractors and shall issue a final certificate of payment in accordance with Section 1.1.9.6. 1.1.9.12. The ARCHITECT/ENGINEER shall be responsible for system commissioning in accordance with the BGS Design Guidelines and as indicated in the BGS Commissioning Guidelines. Please see the BGS website xxxx://xxx.xxxxxxx.xxx/facilities/forms . The ARCHITECT/ENGINEER shall inspect, and document, each and every system to ensure that it complies with design intent, including but not limited to: system installation, system operation, and seasonal changeover. 1.1.9.13. Except in the manner specifically provided for herein, the ARCHITECT/ENGINEER shall not be responsible to the State for the acts or omissions of the Contractor or any of the Contractor’s agents or employees, or any other person not an employee or agent of the ARCHITECT/ENGINEER performing work on the Project. The ARCHITECT/ENGINEER shall be responsible for and shall pay the amount of any increase in the total Contract Price or the total Change Order(s) Price, which increase results from an error, inconsistency, or omission in the Contract Documents or instructions. 1.1.9.14. ARCHITECT/ENGINEER shall furnish to the State, a complete set of marked-up drawings and specifications showing all the changes to the Construction Documents made by Addenda, Change Orders, Shop Drawings, RFIs and other information received from the Clerk; and General Contractor’s As-built markups. The changes to the drawings are to be created on a separate layer in the DWG set and highlighted in a box, cloud or the like in the PDF set. The specifications are also to differentiate the changes made by highlighting in a box, cloud, etc. and be provided in Microsoft Word. These drawings and specifications shall be supplied within three (3) months of the date of Substantial Completion and before final payment. 1.1.9.15. Architect/Engineer (and design team members as required) shall conduct a one-year warranty inspection of the completed construction project between the eleventh and twelfth month from the date of substantial completion and shall issue a list of defective items needing correction to the Contractor.

  • Alterations, Additions, and Improvements Lessee covenants and agrees with Lessor not to permit the Premises to be used for any purpose other than that stated in Section 5 hereof or make or allow to be made any alterations or physical additions in or to the Premises without first obtaining the written consent of Lessor in each such instance. Lessor's consent shall not be required for nonstructural alterations made by Lessee from time to time as necessary to adapt the Premises for the uses and business purposes permitted hereby, provided that such alterations do not affect any part of the Building other than the Premises, are not visible from outside the Building and do not adversely affect any service required to be furnished by Lessor to Lessee or to any other tenant or occupant of the Building. Lessee shall be responsible for any lien filed against the Premises or any portion of the Building for work claimed to have been done for, or materials claimed to have been furnished to Lessee. Any and all such alterations, physical additions, or improvements, when made to the Premises by Lessee, shall be at Lessee's expense and shall at once become the property of Lessor and shall be surrendered to Lessor upon termination of this Lease by lapse of time or otherwise; provided, however, this clause shall not apply to the movable fixtures, office equipment, and other personal property owned by Lessee. Tenant Initials ___________ Landlord Initials___________ 4Section 17. Legal Use and Violations of Insurance Coverage. ----------- ----------------------------------------------- Lessee covenants and agrees with Lessor not to occupy or use, or permit any portion of the Premises to be occupied or used, for any business or purpose which is unlawful, disreputable, or deemed to be extra-hazardous on account of fire, or permit anything to be done which would in any way increase the rate of fire, liability, or any other insurance coverage on the Building and/or its contents.

  • Office and Facilities The Executive shall be provided with appropriate offices and with such secretarial and other support facilities as are commensurate with the Executive's status with the Company and adequate for the performance of the Executive's duties hereunder.

  • Interconnection Facilities Engineering Procurement and Construction Interconnection Facilities, Network Upgrades, and Distribution Upgrades shall be studied, designed, and constructed pursuant to Good Utility Practice. Such studies, design and construction shall be based on the assumed accuracy and completeness of all technical information received by the Participating TO and the CAISO from the Interconnection Customer associated with interconnecting the Large Generating Facility.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!