Regulatory Compliance a. Monitor compliance with the 1940 Act requirements, including:
Legal and Regulatory Compliance The Consultant shall perform all services and prepare documents in compliance with the applicable requirements of laws, codes, rules, regulations, ordinances, and standards.
Statutory and Regulatory Compliance Contractor shall comply with all laws and regulations applicable to the Community Development Block Grant-Disaster Recovery funds appropriated by the Disaster Relief Appropriations Act, 2013 (Pub. L. 113-2), including but not limited to the applicable Office of Management and Budget Circulars, which may impact the administration of funds and/or set forth certain cost principles, including the allowability of certain expenses.
Program Compliance The School Board shall be responsible for monitoring the program to provide technical assistance and to ensure program compliance.
FERPA Compliance In connection with all FERPA Records that Contractor may create, receive or maintain on behalf of University pursuant to the Underlying Agreement, Contractor is designated as a University Official with a legitimate educational interest in and with respect to such FERPA Records, only to the extent to which Contractor (a) is required to create, receive or maintain FERPA Records to carry out the Underlying Agreement, and (b) understands and agrees to all of the following terms and conditions without reservation:
Certification of Compliance The Owner may permit the use, prior to sampling and testing, of certain materials or assemblies when accompanied by manufacturer's certificates of compliance stating that such materials or assemblies fully comply with the requirements of the contract. The certificate shall be signed by the manufacturer. Each lot of such materials or assemblies delivered to the work must be accompanied by a certificate of compliance in which the lot is clearly identified. Materials or assemblies used on the basis of certificates of compliance may be sampled and tested at any time and if found not to be in conformity with contract requirements will be subject to rejection whether in place or not. The form and distribution of certificates of compliance shall be as approved by the Owner. When a material or assembly is specified by "brand name or equal" and the Contractor elects to furnish the specified "brand name", the Contractor shall be required to furnish the manufacturer's certificate of compliance for each lot of such material or assembly delivered to the work. Such certificate of compliance shall clearly identify each lot delivered and shall certify as to:
Statutory Compliance The Union and the Employer agree to cooperate fully in matters pertaining to the prevention of accidents and occupational disease and in the promotion of the health and safety of all employees. There shall be full compliance with all applicable statutes and regulations pertaining to the working environment.
CEQA Compliance The District has complied with all assessment requirements imposed upon it by the California Environmental Quality Act (Public Resource Code Section 21000 et seq. (“CEQA”) in connection with the Project, and no further environmental review of the Project is necessary pursuant to CEQA before the construction of the Project may commence.
OSHA Compliance To the extent applicable to the services to be performed under this Agreement, Contractor represents and warrants, that all articles and services furnished under this Agreement meet or exceed the safety standards established and promulgated under the Federal Occupational Safety and Health Law (Public Law 91-596) and its regulations in effect or proposed as of the date of this Agreement.