Basic Setting Sample Clauses

Basic Setting. Cut Speed: The speed at which the laser head moves with the laser on. In Varying Speed mode, it is the maximum speed at which the laser head moves with the laser on; Power: The laser power during cutting. You can set it between 1-100%; Cut Reserve: Before finishing cutting a closed loop, turn off the laser a little earlier to avoid the whole part being cut off;

Basic Setting. Speed: The speed at which the laser head moves during engraving; Power: The laser power during engraving. You can set it between 1-100%; Precision: The engraving precision in Y-axis in DPI (Dot Per Inch); Minimum Power: The minimum value of the laser power setting, when the system tries to compensate laser power for different speed; Optimized: Engrave the graphics in the best path; Vertical Engraving: Engrave vertically instead of horizontally; Uni-Directional: The laser will be only when the laser head moves from left to right.（Apply to very fine graphics, such as below 3mm text and precision above E level shape code); Return Speed: The return speed when the laser moves back from right to left in Uni-Directional mode with the laser being off; Stamp Mode: In stamp mode, you will see slope at the edge of engraved graphic.Also called slope mode. To grantee the better result of slope, it better set the engrave power ad 100%; Pitch: The length of slope in Stamp Mode. You can set it between 0-4mm; Xxxx: Control on the blowing for the device, select the option, it means that the engraving have to being blowing, otherwise, it means not to blow; Xxxx delay:The time of xxxx switch changes the status. （2）.Advanced Setting (Fig.3-6-34) Laser head setting: used to select which laser head need to use during the operation, it‟s effective only for the device with double head, if for single-head device, please select the “dual laser head”or “left laser head”;