Guards and Lights The Contractor agrees that during the performance of said work, adequate barricades, guards and warning signs, lights or devices consistent with the requirements contained in the Manual on Uniform Traffic Control Devices shall be provided by Contractor during construction.
Risks and Limits of Liability Contractor shall maintain the following insurance coverages in the following amounts:
Minimum Scope and Limits of Insurance Contractor shall provide coverage with limits of liability not less than those stated below.
Conditions and Limitations The admission of any Person as a Substituted Member or an Additional Member shall be conditioned upon (i) such Person’s written acceptance and adoption of all the terms and provisions of this Agreement, either by (A) execution and delivery of a counterpart signature page to this Agreement countersigned by the Managing Member on behalf of the Company or (B) any other writing evidencing the intent of such Person to become a Substituted Member or an Additional Member and such writing is accepted by the Managing Member on behalf of the Company.
Minimum Scope and Limit of Insurance Coverage shall be at least as broad as:
Indemnities and Limitation of Liability 16.1. In addition to the indemnification provisions contained in this Agreement, Principal agrees to indemnify, defend and hold harmless Custodian and its affiliates providing services under this Agreement, including their respective officers, directors, agents and employees from all taxes, charges, expenses, assessments, claims and liabilities including, without limitation, reasonable attorneys' fees and disbursements and liabilities ("Claims") arising directly or indirectly from any action or omission to act which Custodian takes in connection with the provision of services to Principal. Neither Custodian, nor any of its affiliates, shall be indemnified against any liability (or any expenses incident to such liability) caused by Custodian’s or its affiliates' own willful misfeasance, bad faith, gross negligence or reckless disregard in the performance of Custodian's or its affiliates' activities under this Agreement. The provisions of this Paragraph 15 shall survive termination of this Agreement.
Restrictions and Limitations (a) Except as hereinafter provided, no officer or Trustee of the Trust, no officer, director, or stockholder (or partner of a stockholder) of the investment adviser of the Trust (as that term is defined in the 0000 Xxx) or of any underwriter of the Trust, and no investment adviser or underwriter of the Trust shall take long or short positions in the securities issued by the Trust. The foregoing provision shall not prevent the purchase from the Trust of shares of any series issued by the Trust by any person at the price available to shareholders of the Trust generally at the time of such purchase, or as described in the current Prospectus of the Trust, or prior to commencement of the public offering of shares of the Trust, at the net asset value of such shares.
Exceptions and Limitations For the avoidance of doubt, where Exceptions and Limitations apply to Your use, this Public License does not apply, and You do not need to comply with its terms and conditions.
Limited Warranty and Limitation of Liability A. EBSCO disclaims all warranties, express or implied, including, but not limited to, warranties of merchantability, noninfringement, or fitness for a particular purpose. EBSCO neither assumes nor authorizes any other person to assume for EBSCO any other liability in connection with the licensing of the Database(s) under this Agreement and/or its use thereof by the Licensee and Sites or Authorized Users.
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.