CCTV Camera and Housing Sample Clauses

CCTV Camera and Housing. For the system’s camera and housing, verify the following  Camera/lens focus and auto iris is adjusted properly.  Camera field of view is adjusted to customer’s requirements.  Camera/housing viewing window is clean, inside and out.  Camera lens is dust free.  Interior of camera enclosure is clean and dry.  Check operation of pan tilt and zoom focus. Use controller in control room to check all these operations. Wiring & Cables For the system’s wiring and cables, verify the following  Check wiring and cable harnesses for wear and fray.  Check to make sure cable is dressed properly.  Check connectors and cable entry points for loose wiring.  Check that the coaxial cable is transmitting an adequate video signal to control room. Signal should be free of distortion, tearing, hum-bars, EMI, and rolling.  Make sure all coaxial connectors are insulated from conduit and pull boxes.  Measure voltage supplied at each camera Quarterly
AutoNDA by SimpleDocs

Related to CCTV Camera and Housing

  • Skidding and Yarding Methods of skid- ding or yarding specified for particular areas, if any, are indicated on Sale Area Map. Outside Clearcutting Units and construction clearings, insofar as ground conditions permit, products shall not be skidded against reserve trees or groups of reproduction and tractors shall be equipped with a winch to facilitate skidding. B6.421 Rigging. Insofar as practicable, needed rigging shall be slung on stumps or trees desig- nated for cutting.

  • Telephone Monitoring and Recording You consent to and authorize us and any of our affiliates, agents and marketing associates to monitor and/or record any of your telephone conversations with any of our or their representatives for quality control, training and other lawful purposes.

  • Open and Transparent Consistent with ICANN’s expressed mission and core values, ICANN shall operate in an open and transparent manner.

  • Dewatering 4.7.1 Where a part of a site is affected by surface water following a period of rain, thus rendering some areas unsafe for productive work, consistent with the Employer’s obligations under the OH&S Act, all non- trades employees shall assist in ‘dewatering’ their own work site or area if it is so affected. Such work to be paid at single time rates. Productive work will continue in areas not so affected.

  • Where BellSouth uses Integrated Digital Loop Carrier (IDLC) systems to provide the local loop and BellSouth has a suitable alternate facility available, BellSouth will make arrangements to permit OnePoint to order a contiguous local loop. To the extent it is technically feasible, these arrangements will provide OnePoint with the capability to serve end users at a level that is at parity with the level of service BellSouth provides its customers. If no alternate facility is available, BellSouth will utilize its Special Construction (SC) process to determine the additional costs required to provision the loop facilities. OnePoint will then have the option of paying the one-time SC rates to place the loop facilities or OnePoint may chose some other method of providing service to the end-user (e.g., Resale, private facilities, etc.).

  • Stormwater Management The Owner agrees that stormwater management measures shall be applicable to the development of the Lands, in a manner which is in accordance with the provisions of The Drainage Act, R.S.O. 1990, c.D.17 and amendments thereto, and to the satisfaction of the Municipality's Engineer.

  • Irrigation Systems The Project Area either has no irrigation system or a low-volume drip irrigation system. If a watering system is used, it is a drip irrigation system equipped with a filter, pressure regulator and emitters rated at twenty (20) gallons per hour (gph) or less. The system is maintained free of leaks and malfunctions. No spray irrigation is applied to the Project Area, including spray from irrigation systems adjacent to the Project Area.

  • Foreign-Owned Companies in Connection with Critical Infrastructure If Texas Government Code, Section 2274.0102(a)(1) (relating to prohibition on contracts with certain foreign-owned companies in connection with critical infrastructure) is applicable to this Contract, pursuant to Government Code Section 2274.0102, Contractor certifies that neither it nor its parent company, nor any affiliate of Contractor or its parent company, is: (1) majority owned or controlled by citizens or governmental entities of China, Iran, North Korea, Russia, or any other country designated by the Governor under Government Code Section 2274.0103, or (2) headquartered in any of those countries.

  • Erosion and Sediment Control The Contractor shall install and maintain erosion and sediment control devices to prevent adjacent streets, storm drains and property from accumulations of soil, sediment, or dust which result from his work. Devices installed to control sediment and prevent erosion shall comply with the requirements of the Georgia Tech Project Superintendent. The Contractor is responsible for monitoring downstream conditions throughout the construction period and clearing any debris, sediment, and dust caused by the progress of the Work. The Contractor shall inspect, maintain, and clear erosion and sediment control devices at least weekly unless otherwise directed by the Georgia Institute of Technology Construction Manager. At the conclusion of the Work, the Contractor shall remove all installed devices and restoring the site to the satisfaction of the Georgia Tech Construction Manager.

  • Anti-slavery and human trafficking 22.1 The Supplier shall:

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!