CFP8 Insertion & Extraction Sample Clauses

CFP8 Insertion & Extraction. As described in Section 1, the CFP8 module shall be hot pluggable. A consequence of the CFP8 module being hot pluggable is that an end user be equipped to insert and extract the module in the field. The required forces are specified below in Table 5-2. Table 5-2: CFP8 Module Insertion, Extraction Forces Max. Unit Notes Maximum Insertion Force 80 N Without Heat Sink Maximum Extraction Force 50 N Without Heat Sink Minimum Module Retention Force 90 N No damage to module below 90 N Minimum Cage Retention Force 180 N No damage to cage latch below 180 N Minimum rating for host/module connector insertion/extraction is 200 cycles. * Typical increase in those forces by adding heat sink is below 5N.
Sample 1Sample 2
AutoNDA by SimpleDocs

Related to CFP8 Insertion & Extraction

  • Minimum Site Requirements for TIPS Sales (when applicable to TIPS Sale). Cleanup: When performing work on site at a TIPS Member’s property, Vendor shall clean up and remove all debris and rubbish resulting from their work as required or directed by the TIPS Member or as agreed by the parties. Upon completion of work, the premises shall be left in good repair and an orderly, neat, clean and unobstructed condition. Preparation: Vendor shall not begin a project for which a TIPS Member has not prepared the site, unless Vendor does the preparation work at no cost, or until TIPS Member includes the cost of site preparation in the TIPS Sale Site preparation includes, but is not limited to: moving furniture, installing wiring for networks or power, and similar pre‐installation requirements. Registered Sex Offender Restrictions: For work to be performed at schools, Vendor agrees that no employee of Vendor or a subcontractor who has been adjudicated to be a registered sex offender will perform work at any time when students are, or reasonably expected to be, present unless otherwise agreed by the TIPS Member. Vendor agrees that a violation of this condition shall be considered a material breach and may result in the cancellation of the TIPS Sale at the TIPS Member’s discretion. Vendor must identify any additional costs associated with compliance of this term. If no costs are specified, compliance with this term will be provided at no additional charge. Safety Measures: Vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage. Smoking: Persons working under Agreement shall adhere to the TIPS Member’s or local smoking statutes, codes, ordinances, and policies.

Time is Money Join Law Insider Premium to draft better contracts faster.