Changes to Deductions Table Sample Clauses

Changes to Deductions Table. Xxxxxxx will notify Contractor in writing of a change to the amount of any item listed or referenced in the Deductions Table. Contrac- tor will not be subject to that change until 30 days after the notice— or, if sooner, the time the third-party vendor has allowed—unless Contractor signs an addendum consenting to the change, in which case the change described in the addendum will go into effect im- mediately upon signing. Otherwise, Contractor’s failure to ob- ject to the change constitutes Contractor’s consent to the change effective as of the date specified in the notice. If Con- tractor notifies Carrier of Contractor’s objection within that period and Contractor and Carrier are unable to resolve the matter to their mutual satisfaction, either party will have the right to terminate this Agreement immediately upon the change becoming effective.
AutoNDA by SimpleDocs

Related to Changes to Deductions Table

  • Changes to Fees Modernizing Medicine may change the fees and discounts set forth in this Agreement by providing at least thirty (30) days prior written notice (the “Notice Period”) of such change to Medical Practice. Any such change shall take effect at the beginning of the next Renewal Term after the expiration of the Notice Period.

  • Table 2 (definition of “Casino Gross Revenue”) 15(e) 2 (definition of “Commissioning”) 19 2 (definition of “Committee’s Nominated Representative) 20(1) 6(1)(c) 20(2) 7(8)(a) 21(d) 11(1) 21(e) 11(2) 22(2) 11(3) 23(b) 14(d) 33(2) 15(a)(B) 35(1) 15(b)(i) 35(2) 15(c) 36(b) 15(d) 36(c)

  • Classification Definitions Note: The following classification definitions should be read in conjunction with: • the stream and field definitions in subclause 1.4.3 and 1.4.75 respectively: • the definitions of “or equivalent”, “work within the scope of this level” and “Engineering Associate” at the end of this Schedule; • the National Metal and Engineering Competency Standards Implementation Guide especially Table 2 of that Guide which shows the alignment between old and new titles under the Australian Qualifications Framework. For example Advanced Certificates are now known as National Diplomas and Associate Diplomas as National Advanced Diplomas; • Clause 5.1.3 (f) Points. Trainer/Supervisor/Coordinator - Level 1 A Trainer/Supervisor/Coordinator - Level I is an employee who is responsible for the work of other employees and/or provision of structured on-the-job training. Such an employee has completed a qualification at AQFIII level or above, of which at least one third of the competencies are related to supervision/training, or equivalent. Notwithstanding the above definition an employee who is mainly engaged to perform work supervising or coordinating the work of other employees and who has sufficient additional training beyond that of those coordinated or supervised so as to enable the employee to perform work within the scope of this level shall be classified at this level. Trainer/Supervisor/Coordinator - Level II A Trainer/Supervisor/Coordinator - Level II is an employee who is responsible for the supervision and/or training of Trainers/Supervisors/Coordinators - Level I. Such an employee has completed an AQF IV or V qualification or equivalent of which at least 50% of the competencies are in supervision/training. WAGE GROUP: C14 Engineering/Production Employee - Level I As Engineering/Production Employee - Level I is an employee who is undertaking up to 38 hours induction training which may include information on the enterprise, conditions of employment, introduction to supervisors and fellow workers, training and career path opportunities, plant layout, work and documentation procedures, occupational health and safety, equal employment opportunity and quality control/assurance. An employee at this level performs routine duties essentially of a manual nature and to the level of his/her training:

  • Changes to Service We may, from time to time, modify the Service to reflect improvements and other changes and modifications to our network. In addition, we reserve the right to discontinue or limit Service as required to comply with or satisfy our obligations under applicable laws or regulations, including when changes to or interpretations of such laws and regulations have a material, adverse effect on the business, technical or economic feasibility of providing Service, as determined by us in our reasonable judgment.

  • Changes to Prices Subject to the requirements of this section, Vendor may change the price of any product or service at any time, based upon changes to the MSRP, but discount levels shall remain consistent with the discount levels specified in this Contract. Vendor may revise its pricing (but not its discount rate, if any, and not the products or services on its contract pricing list) by posting a revised pricing list. Such revised pricing lists are subject to review by DIR. If DIR finds that a product’s or service’s price has been increased unreasonably, DIR may request Vendor to reduce its pricing for the product or service to the level published before the revision. Vendor must reduce its pricing, or remove the product from its pricing list. Failure to do so will constitute an act of default by Vendor.

  • Table 2 Software Subscription Use Case OpenShift Enterprise OpenShift Enterprise Broker Infrastructure OpenShift Enterprise is intended to be used as a platform as a service and will be supported only when used in that capacity. OpenShift Enterprise is not supported on non-server hardware such as desktops or workstations. OpenShift Enterprise is intended for use on a dedicated Physical Node or Virtual Guest; running other applications and/or programs of any type on the Physical Node or Virtual Guest can have a negative impact on the function and/or performance. Red Hat JBoss Enterprise Application Platform for OpenShift and/or Red Hat JBoss EAP for xPaaS will be supported in accordance with the terms of Exhibit 1.B.

  • Changes to tariffs and charges (a) If we vary our standing offer prices, we will publish the variation in a newspaper and on our website at least 10 business days before it starts. We will also include details with your next bill if the variation affects you.

  • Calculation of Annual Leave Pay Annual leave shall be paid at the employee’s ordinary weekly wage rate for ordinary hours for the period of annual leave (excluding shift allowances and weekend payments but including leading hand allowance); plus an amount equal to 17.5% of the amount

  • Long Term Cost Evaluation Criterion # 4 READ CAREFULLY and see in the RFP document under "Proposal Scoring and Evaluation". Points will be assigned to this criterion based on your answer to this Attribute. Points are awarded if you agree not i ncrease your catalog prices (as defined herein) more than X% annually over the previous year for years two and thr ee and potentially year four, unless an exigent circumstance exists in the marketplace and the excess price increase which exceeds X% annually is supported by documentation provided by you and your suppliers and shared with TIP S, if requested. If you agree NOT to increase prices more than 5%, except when justified by supporting documentati on, you are awarded 10 points; if 6% to 14%, except when justified by supporting documentation, you receive 1 to 9 points incrementally. Price increases 14% or greater, except when justified by supporting documentation, receive 0 points. increases will be 5% or less annually per question Required Confidentiality Claim Form Required Confidentiality Claim Form This completed form is required by TIPS. By submitting a response to this solicitation you agree to download from th e “Attachments” section, complete according to the instructions on the form, then uploading the completed form, wit h any confidential attachments, if applicable, to the “Response Attachments” section titled “Confidentiality Form” in order to provide to TIPS the completed form titled, “CONFIDENTIALITY CLAIM FORM”. By completing this process, you provide us with the information we require to comply with the open record laws of the State of Texas as they ma y apply to your proposal submission. If you do not provide the form with your proposal, an award will not be made if your proposal is qualified for an award, until TIPS has an accurate, completed form from you. Read the form carefully before completing and if you have any questions, email Xxxx Xxxxxx at TIPS at xxxx.xxxxxx@t xxx-xxx.xxx

  • Calculation of Pay Each institution will review its division of annual pay into pay periods to ensure that employees receive the full or pro-rated (as applicable) gross annual salary in the Provincial Salary Scale in Appendix A.

Time is Money Join Law Insider Premium to draft better contracts faster.