RECIPROCITY AND SANCTIONS PROVISIONS Bidders are hereby notified that if their principal place of business is located in a country, nation, province, state or political subdivision that penalizes New York State vendors, and if the goods or services they offer will be substantially produced or performed outside New York State, the Omnibus Procurement Xxx 0000 and 2000 amendments (Chapter 684 and Chapter 383, respectively) require that they be denied contracts which they would otherwise obtain. NOTE: As of May 15, 2002, the list of discriminatory jurisdictions subject to this provision includes the states of South Carolina, Alaska, West Virginia, Wyoming, Louisiana and Hawaii. Contact NYS Department of Economic Development for a current list of jurisdictions subject to this provision.
Publicity and Reports Company, Bank, and Seller shall coordinate all publicity relating to the transactions contemplated by this Agreement and no Party shall issue any press release, publicity statement or other public notice relating to this Agreement or any of the transactions contemplated hereby without obtaining the prior consent of the other Party, except to the extent that legal counsel to any Party shall deliver a written opinion to the other Party to the effect that a particular action is required by applicable Rules.
Domain and Designation The Top-‐Level Domain to which this Agreement applies is .sew (the “TLD”). Upon the Effective Date and until the earlier of the expiration of the Term (as defined in Section 4.1) or the termination of this Agreement pursuant to Article 4, ICANN designates Registry Operator as the registry operator for the TLD, subject to the requirements and necessary approvals for delegation of the TLD and entry into the root-‐zone.
LOCATION AND DESCRIPTION The subject property is situated about 5 kilometres north-west of PJ new town. The subject property compromises of a serviced apartment unit identified Developer’s Parcel No. 28-20, Type C1-B, Storey No. 28, The Arcuz @ Kelana Jaya, Phase 3 bearing postal address of Xxxx Xx. 00-00, The Arcuz @ Kelana Jaya, Xxxxx XXX 0X/0X, 00000 Xxxxxxxx Xxxx, Xxxxxxxx. The property will be sold on an “as is where is” basis and subject to a reserve price of RM620,000.00 (RINGGIT MALAYSIA SIX HUNDRED TWENTY THOUSAND ONLY) only and subject to the Conditions of Sale and by way of an Assignment from the above Assignee subject to consent being obtained by the successful bidder ('the Purchaser") from the Developer and other relevant authorities, if any, is required, including all terms, conditions, stipulations and covenants which were and may be imposed by the Developer and the relevant authority. All expenses incurred in obtaining the said consent shall be borne by the Purchaser. Any arrears of quit rent, assessment, service/maintenance charges and sinking fund (including the late penalty interest) which may be lawfully due to any relevant authority or the Developer or Proprietor or relevant third parties entitled thereto up to the date of successful sale of the subject property shall be borne out of the purchase price. The Purchaser shall bear and pay all fees and expenses including but not limited to all legal fees, stamp duty and registration fees in connection with, incidental to or pursuant to the Assignment and all other documents necessary for effecting the transfer or assigning the beneficial ownership in the property to the Purchaser and shall also bear all risks in relation to the purchase of the Property. The sale of the subject property may be subjected to any prevailing tax imposed by the Government of Malaysia. In such event where prevailing tax is payable, it shall be paid by the Purchaser in addition to the purchase price payable by the Purchaser. All intending bidders are required to deposit 10% of the fixed reserve price by bank draft or cashier’s order crossed “A/C Payee only” in favour of OCBC BANK (MALAYSIA) BERHAD prior to the sale with undermentioned Auctioneer and the balance purchase price to be settled within one hundred and twenty (120) days from the date of auction sale to the Assignee. To get a copy of the Conditions of Sale and any further particulars, please contact Messrs Ho, Loke & Koh Solicitors for the Assignee herein whose address is at X-0-0, Xxxxx Xxxxxx 0, 000, Xxxxx Xxx Xxxxx, 00000 Xxxxx Xxxxxx, Xxxxxxxx (Ref.: PLEASE ADVICE, Tel.: 00-0000 0000, Fax: 00- 0000 0000) or the undermentioned Auctioneer at the address below. Suite C-20-3A, Level 20, Block C, Megan Avenue II, / XXXXX XXXXX BIN XXXXXX 00, Xxxxx Xxx Xxxx Xxxx, 50450 Kuala Lumpur (Licensed Auctioneers) Tel No.: 00-0000 0000 Fax No.: 00-0000 0000 Our Ref:UMI/OCBC1396/HLK Website: xxx.xxxxxxxxxxxxxxxx.xxx E-mail: xxxx@xxxxxxxxxxxxxxxx.xxx
USE OF NASA NAME AND NASA EMBLEMS A. NASA Name and Initials Partner shall not use "National Aeronautics and Space Administration" or "NASA" in a way that creates the impression that a product or service has the authorization, support, sponsorship, or endorsement of NASA, which does not, in fact, exist. Except for releases under the "Release of General Information to the Public and Media" Article, Partner must submit any proposed public use of the NASA name or initials (including press releases and all promotional and advertising use) to the NASA Associate Administrator for the Office of Communications or designee ("NASA Communications") for review and approval. Approval by NASA Office of Communications shall be based on applicable law and policy governing the use of the NASA name and initials.
B. NASA Emblems Use of NASA emblems (i.e., NASA Seal, NASA Insignia, NASA logotype, NASA Program Identifiers, and the NASA Flag) is governed by 14 C.F.R. Part 1221. Partner must submit any proposed use of the emblems to NASA Communications for review and approval.
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “
(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “
(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.
Change of Name, Etc Immediately after the Closing, Purchaser will (a) change the name and logo on all documents, Branches and other facilities relating to the Assets and the Assumed Liabilities to Purchaser’s name and logo, (b) notify all persons whose Loans, Deposits or Safe Deposit Agreements are transferred under this Agreement of the consummation of the transactions contemplated by this Agreement, and (c) provide all appropriate notices to the OCC and any other Regulatory Authorities required as a result of the consummation of such transactions. Seller shall cooperate with any commercially reasonable request of Purchaser directed to accomplish the removal of Seller’s signage (or the removal of signage of an Affiliate of Seller, if applicable) by Purchaser and the installation of Purchaser’s signage by Purchaser; provided, however, that (i) all such removals and all such installations shall be at the expense of Purchaser, (ii) such removals and installations shall be performed in an environmentally friendly manner (including the recycling of such materials) and in such a manner that does not unreasonably interfere with the normal business activities and operations of the Branches and Purchaser shall repair any damage to the area altered to its pre-existing condition, (iii) such installed signage shall comply with the applicable Branch Lease and all applicable zoning and permitting laws and regulations, (iv) such installed signage shall have, if necessary, received the prior approval of the owner or landlord of the facility, and such installed signage shall be covered in such a way as to make Purchaser signage unreadable at all times prior to the Closing, but such cover shall display the name and/or logo of Seller (or of its Affiliates) in a manner reasonably acceptable to Seller and (v) if this Agreement is terminated prior to the Closing, Purchaser shall immediately and at its sole expense restore such signage and any other area altered in connection therewith to its pre-existing condition. During the fourteen (14) calendar day period following the Closing, Purchaser shall afford to Seller and its authorized agents and representatives reasonable access during normal business hours to the Branches to allow Seller the opportunity to confirm Purchaser’s compliance with the terms of this Section 7.9.
Use of Name and Reports Without the Advisor’s prior written consent, neither the Company nor any of its affiliates (nor any director, officer, manager, partner, member, employee or agent thereof) shall quote or refer to (i) the Advisor’s name or (ii) any advice rendered by the Advisor to the Company or any communication from the Advisor in connection with performance of their services hereunder, except as required by applicable federal or state law, regulation or securities exchange rule.
Confirmation of Authority; Execution of Releases Without in any manner limiting Agent’s authority to act without any specific or further authorization or consent by Lenders or Documentation Agent (as set forth in Section 11.1(h)(i) and (ii)), each Lender agrees to confirm in writing, upon request by Agent, the authority to release any property covered by this Agreement or the Loan Documents conferred upon Agent under Section 11.1(h)(ii). So long as no Event of Default exists, upon receipt by Agent of confirmation from the requisite percentage of the Lenders of its authority to release any particular item or types of Property covered by this Agreement or the other Loan Documents, and upon at least five (5) Business Days’ prior written request by Borrower Funds Administrator, Agent shall (and hereby is irrevocably authorized by Lenders to) execute such documents as may be necessary to evidence the release of the Liens granted to Agent, for the benefit of the Lender Parties, herein or pursuant hereto upon such Collateral; provided, however, that (A) Agent shall not be required to execute any such document on terms which, in Agent’s opinion, would expose Agent to liability or create any obligation or entail any consequence other than the release of such Liens without recourse or warranty (other than that such Collateral is free and clear, on the date of such delivery, of any and all Liens arising from such Person’s own acts), and (B) such release shall not in any manner discharge, affect or impair the Obligations or any Liens upon (or obligations of the Credit Parties or any Subsidiary of any Credit Party in respect of all interests retained by the Credit Parties or any Subsidiary of any Credit Party, including, without limitation, the proceeds of any sale, all of which shall continue to constitute part of the Property covered by this Agreement or the other Loan Documents).
Limitation on Out-of-State Litigation - Texas Business and Commerce Code § 272 This is a requirement of the TIPS Contract and is non-negotiable. Texas Business and Commerce Code § 272 prohibits a construction contract, or an agreement collateral to or affecting the construction contract, from containing a provision making the contract or agreement, or any conflict arising under the contract or agreement, subject to another state’s law, litigation in the courts of another state, or arbitration in another state. If included in Texas construction contracts, such provisions are voidable by a party obligated by the contract or agreement to perform the work. By submission of this proposal, Vendor acknowledges this law and if Vendor enters into a construction contract with a Texas TIPS Member under this procurement, Vendor certifies compliance.
