Commitment to Good Faith in Scheduling Sample Clauses

Commitment to Good Faith in Scheduling. Consistent with the Union’s commitment to professional labor relations, the Union shall exercise the rights afforded it above at all times in good faith and Flight Attendant schedules will be modified in such a manner so as to minimize any unnecessary disruption of the Company’s business. END OF SECTION 17
AutoNDA by SimpleDocs

Related to Commitment to Good Faith in Scheduling

  • STRS PICK-UP A. The Board shall pick-up contributions to the State Teachers’ Retirement System paid on behalf of the employees in the bargaining unit utilizing the salary reduction method under the following terms and conditions:

  • Reduction in Scope of the Project 16.6.1 If the Concessionaire shall have failed to complete any Construction Works on account of Force Majeure or for reasons solely attributable to the Authority, the Authority may, in its discretion, require the Concessionaire to pay 80% (eighty percent) of the sum saved therefrom, and upon such payment to the Authority, the obligations of the Concessionaire in respect of such works shall be deemed to have been fulfilled. For the avoidance of doubt, it is agreed that in the event such reduction in Scope of the Project causes or will cause a reduction in net after-tax return of the Concessionaire, the Parties shall meet, as soon as reasonably practical, and agree on a full or partial waiver of the aforesaid payment of 80% (eighty per cent) so as to place the Concessionaire in the same financial position as it would have enjoyed had there been no reduction in Scope of the Project. It is further agreed that the liability of the Authority under this Clause 16.6 shall not extend beyond waiver of the aforesaid 80% (eighty per cent). It is also agreed that in the event of a dispute, the Dispute Resolution Procedure shall apply.

  • SERS PICK-UP A. For purposes of this Article, total annual salary and salary per pay period for each member shall be the salary otherwise payable under this Agreement, as amended. The total annual salary and salary per pay period of each member shall be payable by the Board in two parts: (1) deferred salary and (2) cash salary. A member’s deferred salary shall be equal to that percentage of said member’s total annual salary or salary per pay period which is required from time to time by the State Employment Retirement System (“SERS”) to be paid as an employee contribution by said member and shall be paid by the Board to SERS on behalf of said member as a “pickup” of the SERS employee contribution otherwise payable by said member. A member’s cash salary shall be equal to said member’s total annual salary or salary per pay period less the amount, subject to applicable payroll deductions, to said member. The Board’s total combined expenditures for members’ total annual salaries otherwise payable under this Agreement, as amended, (including pickup amounts) and its employer contributions to SERS shall not be greater than the amounts it would have paid for those items had this provision not been in effect.

  • Working Xxxxxxx An employee who is in charge of a crew not more than five men including himself, engaged in line clearance work. (In the application of Article X, the Company need not consider the application for promotion to this classification from any employee having less than one year of experience in the Climber classification.)

  • Reductions in Scope of Work City may independently, or upon request from Consultant, from time to time, reduce the Required Services to be performed by the Consultant under this Agreement. Upon doing so, City and Consultant agree to meet and confer in good faith for the purpose of negotiating a corresponding reduction in the compensation associated with the reduction.

  • Four Day Work Week Schedule i. When working under the four (4) day work week schedule, Employees shall be paid at double time (2x) the regular hourly rate for all hours worked in excess of the regular ten (10) hours per day Monday through Thursday.

  • Five Day Work Week Schedule When working under the five (5) day work week schedule, Employees shall receive one and one-half (1.5x) times their regular rate of pay for the first two (2) hours of overtime Monday through Friday. All other overtime Monday through Friday shall be paid at double time (2x).

  • In-Scope Projects Project Based Information Technology (IT) Consulting Services required by an Authorized User must be obtained via a Mini-Bid process under this Contract. The Authorized User shall issue a Mini-Bid with a SOW for the required Project Based IT Consulting Services. A Mini-Bid may include, but will not be limited to, projects requiring: analysis, data classification, design, development, testing, quality assurance, security and associated customized training for IT based applications. Additional examples of in-scope projects include, but are not limited to:  Technical architecture advisory services;  Business analysis for project development;  Proprietary software application development/customization, programming and integration;  Data information management (including data migration, data conversion, data manipulation, data integration);  Project management project support services - including, but not limited to; project management, project quality assurance and control, and Independent Verification & Validation (IV&V);  Disaster recovery/business continuity and testing;  Quality assurance;  Continuity of operations planning (COOP);  Data categorization; and  Open-source software implementation. Out-of-Scope Work There are service offerings expressly excluded from the scope of these contracts. In many instances, such services and/or offerings are (or will be) covered by another OGS Centralized Contract. Examples include:  Staff augmentation services;  Time and material services;  Web hosting;  Automated network monitoring or any other service provided principally through an automated process;  Hardware maintenance and support;  Software maintenance and support;  Ongoing maintenance and support;  Services priced on a per asset basis;  Services priced on a contingency basis;  Equipment maintenance;  Prepackaged training courses;  E-Learning;  Managed services;  Acquisition of equipment (hardware)  Acquisition of software, either Commercial off-the-shelf (COTS) software or pre-existing software;  Acquisition of non-consulting services, such as network provisioning, voice services (local, long- distance), or video bridging;  Cloud based or “As a Service” offerings, including but not limited to SaaS, IaaS, PaaS, and XaaS;  Any offering that is a combination of equipment, hardware, software, cloud or “as a service offerings”; and  Consulting or other installation work which is considered Public Works is excluded from purchase under the scope of this Contract. Historically, the New York State Bureau of Public Works has maintained that installation, maintenance and repair of equipment attached to any wall, ceiling or floor or affixed by hard wiring or plumbing is public work. In contrast, installation of a piece of equipment which is portable or a “plug-in” free-standing unit would not be considered public work. Thus, this Contract does not authorize installation where the equipment becomes a permanent part of the building structure, or is otherwise incorporated into the fabric of the building (i.e. installation on a wall, ceiling or floor in a fixed location, or affixed by hard- wiring or plumbing). See Appendix A, Clause 6, Wage and Hours Provisions. For questions about whether a proposed work constitutes public work, please contact the New York State Department of Labor’s Bureau of Public Work District Office in a specific area. A listing of district offices and contact information is available at xxxx://xxx.xxxxx.xx.xxx/workerprotection/publicwork/PWContactUs.shtm. Definitions Additional definitions applicable to this Contract can be found in Appendix B. Term Definition Authorized User Agreement The document resulting from the transactional Mini-Bid process, which sets forth the specifics regarding the services to be provided by the Contractor to the Authorized User, under the Project Based Information Technology Consulting Contract. Best Value The basis for awarding all service and technology contracts to the offerer that optimizes quality, cost and efficiency, among responsive and responsible offerers. Such basis shall be, wherever possible, quantifiable (State Finance Law §163 (1) (j)). Billing Contact The name, phone number, e-mail, and billing address a customer uses on a xxxx for contact information. Consultant Disclosure Legislation Chapter 10 of the Laws of 2006 amends State Finance Law § 8 and § 163 by requiring: that the Office of the State Comptroller (OSC) include in the Consulting Services Report it compiles annually on contracts issued by state agencies for consulting services during the previous fiscal year. xxxx://xxx.xxx.xxxxx.xx.xx/agencies/guide/MyWebHelp/Content/XI/18/C.htm Deliverables All services or products created during the performance or provision of Services hereunder or identified as a “Deliverable” in an applicable Mini-Bid. A Deliverable is a building block of an overall project. For the purposes of this Solicitation and the resulting Contract, a deliverable shall not be set forth as a status report, meeting attendance, a block of staff hours, or an invoice submission. Fixed Price Authorized User Agreement An agreement pursuant to the Centralized Contract that provides for a fix cost for a defined project. Government Contract A contract let by a Federal, State, or Local governmental body within the continental United States. Government Entity An entity at the federal, state, county, city or provincial level. Joint Venture A contractual agreement joining together two or more business enterprises for the purpose of performing on a State Contract. Knowledge Transfer The transfer of knowledge from the Contractor to the Authorized User. Knowledge Transfer can include full written system documentation including all system changes, training classes, manuals and other items. Depending on the scope of the transaction, there may or may not be a deliverable cost associated. All materials will be the property of the Authorized User unless specifically negotiated during the award process. May Denotes the permissive in a contract clause or specification. Refers to items or information that the State has deemed are worthy of obtaining, but not required or obligatory. Also see “Should”. Mini-Bid A type of Bid Document used by the Authorized User to obtain Services under the Project Based IT Consulting Services Contracts. Not To Exceed Rates (NTE) Refers to the New York State contract price set forth in Appendix D. Amounts proposed by the Contractor at the transactional level shall not exceed the hourly rates provided under this Contract (which will be defined values in US Dollars). Prime Contractor For the purposes of Technical qualifications, the business entity with whom a government entity directly has a contract. Project Based IT Consulting Services An OGS Centralized Contract which will provide a set of standardized terms and conditions, guidelines, processes, and templates for the development, distribution and award of specific deliverable-based and fixed-price Information Technology projects. Project Plan A formal, approved document used to guide both project execution and project control. The primary uses of the project plan are to document planning assumptions and decisions, facilitate communication among stakeholders, and document approved scope, cost, and schedule baselines. Retainage A portion of the Authorized User and Contractor fixed-price agreement amount that is held back by the Authorized User until the deliverable or project is satisfactorily finished. Should Denotes the permissive in a contract clause or specification. Refers to items or information that the State has deemed are worthy of obtaining, but not required or obligatory. Also see “May”. Term Definition Solicitation A non-competitive periodic recruitment solicitation (“Solicitation”) for vendors that provide Project Based Information Technology Consulting Services. Vendor An enterprise that sells goods or services. Vendor Submission The complete response to this Solicitation submitted by a Vendor to provide, as applicable , the Product and services described in the Solicitation

  • SUBSEQUENT PERIODIC RECRUITMENT During the term of the Contract, the State reserves the right to conduct subsequent future Periodic Recruitments. The purpose of future periodic recruitments will be to:  Add new Lots for additional and/or emerging technologies  Add new Contractors to existing and new Lots OGS will formally announce when a Periodic Recruitment Solicitation is issued. Periodic Recruitments will be issued at the discretion of the OGS. A Contractor shall be required to submit such Submission documentation as required by OGS, which may include additional applicable statutory requirements currently in effect at the time of the Periodic Recruitment.

  • Change in Scope of Work Any change in the scope of the Work, method of performance, nature of materials or price thereof, or any other matter materially affecting the performance or nature of the Work shall not be paid for or accepted unless such change, addition, or deletion is approved in advance and in writing by a valid change order executed by the District. Contractor specifically understands, acknowledges, and agrees that the District shall have the right to request any alterations, deviations, reductions, or additions to the Project or Work, and the cost thereof shall be added to or deducted from the amount of the Contract Price by fair and reasonable valuations. Contractor also agrees to provide the District with all information requested to substantiate the cost of the change order and to inform the District whether the Work will be done by the Contractor or a subcontractor. In addition to any other information requested, Contractor shall submit, prior to approval of the change order, its request for a time extension (if any), as well as all information necessary to substantiate its belief that such change will delay the completion of the Work. If Contractor fails to submit its request for a time extension or the necessary supporting information, it shall be deemed to have waived its right to request such extension.

Time is Money Join Law Insider Premium to draft better contracts faster.