Company Issued Work Clothing. The Company agrees to supply and launder Company issued work clothing where the Joint Health and Safety Committee mutually agree they are necessary.
Company Issued Work Clothing Sample Clauses
Related to Company Issued Work Clothing
WORK CLOTHING Two sets of cotton drill protective clothing will be issued to all employees, upon request, within two weeks of commencing work with the Company. Employees will be made aware of these entitlements at the time of employment. A set of clothing will consist of either: • Two pairs of overalls; or • Two combination bib and brace; or • Two pairs of long trousers and two long sleeved shirt; or • Work denims at cost no greater than the above three choices • Clothing and footwear will be replaced on a fair wear and tear basis.
NO HARDSTOP/PASSIVE LICENSE MONITORING Unless an Authorized User is otherwise specifically advised to the contrary in writing at the time of order and prior to purchase, Contractor hereby warrants and represents that the Product and all Upgrades do not and will not contain any computer code that would disable the Product or Upgrades or impair in any way its operation based on the elapsing of a period of time, exceeding an authorized number of copies, advancement to a particular date or other numeral, or other similar self-destruct mechanisms (sometimes referred to as “time bombs,” “time locks,” or “drop dead” devices) or that would permit Contractor to access the Product to cause such disablement or impairment (sometimes referred to as a “trap door” device). Contractor agrees that in the event of a breach or alleged breach of this provision that Authorized User shall not have an adequate remedy at law, including monetary damages, and that Authorized User shall consequently be entitled to seek a temporary restraining order, injunction, or other form of equitable relief against the continuance of such breach, in addition to any and all remedies to which Authorized User shall be entitled.
Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning): 1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises. 2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated. 3. If capacity exists, provide "side-door" porting through the switch. 4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch). 2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases. 2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.
Employee Training The Provider shall provide periodic security training to those of its employees who operate or have access to the system. Further, Provider shall provide LEA with contact information of an employee who LEA may contact if there are any security concerns or questions.
Contractor Licensing, etc. Notwithstanding Section 14.c, District may terminate this Contract immediately by written notice to Contractor upon denial, suspension, revocation, or non-renewal of any license, permit, or certificate that Contractor must hold to provide services under this Contract.
Information Technology Enterprise Architecture Requirements If this Contract involves information technology-related products or services, the Contractor agrees that all such products or services are compatible with any of the technology standards found at xxxxx://xxx.xx.xxx/iot/2394.htm that are applicable, including the assistive technology standard. The State may terminate this Contract for default if the terms of this paragraph are breached.
First Aid Training In the interests of the occupational safety and health of employees, the Employer will undertake an in-service program of first aid training aimed at providing a first aid officer for each department.
Reverse Engineering The Customer must not reverse assemble or reverse compile or directly or indirectly allow or cause a third party to reverse assemble or reverse compile the whole or any part of the software or any products supplied as a part of the Licensed System.
School Closures The District may close schools for academic purposes or reduce programming due to public health, safety, severe weather or any other purpose as determined by the District. The District shall not owe Provider any compensation for times when services of Therapists are canceled, declined, or not required due to closure, reduction in programming, or exclusion of Therapists due to health risk assessment screenings or any other reason, and Provider agrees to indemnify District for Therapist claims arising from all such actions. Notwithstanding the foregoing, to the extent required by Section 10-20.56(d-15) of the School Code (105 ILCS 5/10-20.56(d-15)), when enforceable under law, the Parties understand that the District may determine it is required to pay Provider the daily, regular rate of pay and benefits for Therapists for any day of school closure or e-learning day if such closure precludes the Provider’s employees from performing its regularly scheduled duties and employees would have reported for work but for the closure, unless the day is rescheduled and the employees will be paid their daily, regular rate of pay and benefits for the rescheduled day when services are rendered. The Parties agree such payment constitute full satisfaction of Section 10-20.56(d-15). As a precondition to these payments being made, Provider shall provide an invoice for the foregoing pay and benefits costs; however, Provider will not include such pay and benefits costs for any school closure or e-learning day on any invoices until the last invoice of the school year in order to allow the District the opportunity to determine if the day will be rescheduled. When a payment is to be made by the District under this provision, Provider represents and warrants that it shall pay its employees their daily, regular rate of pay and benefits for any such school closure or e-learning day. Upon request, Provider shall provide the District with certified payrolls as evidence of compliance with this section. The District retains sole discretion to determine whether Section 10-20.56(d-15) applies to this Agreement or any day of school closure and, if the District determines such law is applicable, the District retains the discretion to determine if and when a school closure day is rescheduled. For purposes of this section, “school closures” shall not include holidays or other days of closure reflected on the District’s school calendar for which Provider is not scheduled to provide services under the Agreement.
Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract. a. The contractor shall notify all potential subcontractors and suppliers and lessors of their EEO obligations under this contract. b. The contractor will use good faith efforts to ensure subcontractor compliance with their EEO obligations.
