How are Required Minimum Distributions Computed A required minimum distribution (“RMD”) is determined by dividing the account balance (as of the prior calendar year end) by the distribution period. For lifetime RMDs, there is a uniform distribution period for almost all IRA owners of the same age. The uniform distribution period table is based on the joint life and last survivor expectancy of an individual and a hypothetical beneficiary 10 years younger. However, if the IRA owner’s sole beneficiary is his/her spouse and the spouse is more than 10 years younger than the account owner, then a longer distribution period based upon the joint life and last survivor life expectancy of the IRA owner and spouse will apply. An IRA owner may, however, elect to take more than his/her RMD at any time.
Dollar Limits Per Service Agreement Cost to diagnose, repair and/or replace - Per covered appliance $3,000
Compliance with Certain Requirements of Regulations; Deficit Capital Accounts In the event the Company is “liquidated” within the meaning of Regulations Section 1.704-1(b)(2)(ii)(g), distributions shall be made pursuant to this Article X to the Unit Holders who have positive Capital Accounts in compliance with Regulations Section 1.704-1(b)(2)(ii)(b)(2). If any Unit Holder has a deficit balance in such Member’s Capital Account (after giving effect to all contributions, distributions and allocations for all Fiscal Years, including the Fiscal Year during which such liquidation occurs), such Unit Holder shall have no obligation to make any contribution to the capital of the Company with respect to such deficit, and such deficit shall not be considered a debt owed to the Company or to any other Person for any purpose whatsoever. In the discretion of the Liquidator, a pro rata portion of the distributions that would otherwise be made to the Unit Holders pursuant to this Article X may be: (i) distributed to a trust established for the benefit of the Unit Holders for the purposes of liquidating Company assets, collecting amounts owed to the Company, and paying any contingent or unforeseen liabilities or obligations of the Company, in which case the assets of any such trust shall be distributed to the Unit Holders from time to time, in the reasonable discretion of the Liquidator, in the same proportions as the amount distributed to such trust by the Company would otherwise have been distributed to the Unit Holders pursuant to Section 10.2 of this Agreement; or (b) withheld to provide a reasonable reserve for Company liabilities (contingent or otherwise) and to reflect the unrealized portion of any installment obligations owed to the Company, provided that such withheld amounts shall be distributed to the Unit Holders as soon as practicable.
Compliance with Xxxxx-Xxxxx and Related Act requirements All rulings and interpretations of the Xxxxx-Xxxxx and Related Acts contained in 29 CFR parts 1, 3, and 5 are herein incorporated by reference in this contract.
Billing Limitations a. DSHS shall pay the Contractor only for authorized services provided in accordance with this Contract.
b. DSHS shall not pay any claims for payment for services submitted more than twelve (12) months after the calendar month in which the services were performed.
c. The Contractor shall not bill and DSHS shall not pay for services performed under this Contract, if the Contractor has charged or will charge another agency of the state of Washington or any other party for the same services.
COMPLIANCE WITH TAX LAW SECTION 5-a The following provisions apply to Contractors that have entered into agreements in an amount exceeding $100,000 for the purchase of goods and services:
a) Before such agreement can take effect, the Contractor must have on file with the New York State Department of Taxation and Finance a Contractor Certification form (ST-220-TD).
b) Prior to entering into such an agreement, the Contractor is required to provide NYSERDA with a completed Contractor Certification to Covered Agency form (Form ST-220-CA).
c) Prior to any renewal period (if applicable) under the agreement, the Contractor is required to provide NYSERDA with a completed Form ST-220-CA. Certifications referenced in paragraphs (b) and (c) above will be maintained by NYSERDA and made a part hereof and incorporated herein by reference. NYSERDA reserves the right to terminate this agreement in the event it is found that the certification filed by the Contractor in accordance with Tax Law Section 5-a was false when made.
Compliance with Equal Benefits Ordinance With respect to the provision of employee benefits, Contractor shall comply with the County Ordinance which prohibits contractors from discriminating in the provision of employee benefits between an employee with a domestic partner and an employee with a spouse.
How Are Contributions to a Xxxx XXX Reported for Federal Tax Purposes You must file Form 5329 with the IRS to report and remit any penalties or excise taxes. In addition, certain contribution and distribution information must be reported to the IRS on Form 8606 (as an attachment to your federal income tax return.)
Distribution Compliance Period The Purchaser agrees not to resell, pledge or transfer any Purchased Shares within the United States or to any U.S. Person, as each of those terms is defined in Regulation S, during the 40 days following the Closing Date.
Compliance with Timing Requirements of Regulations In the event the Partnership is "liquidated" within the meaning of Regulations Section 1.704-1(b)(2)(ii)(g), distributions shall be made pursuant to this Article 13 to the General Partner and Limited Partners who have positive Capital Accounts in compliance with Regulations Section 1.704-1(b)(2)(ii)(b)(2). If any Partner has a deficit balance in his or her Capital Account (after giving effect to all contributions, distributions and allocations for the taxable years, including the year during which such liquidation occurs), such Partner shall have no obligation to make any contribution to the capital of the Partnership with respect to such deficit, and such deficit shall not be considered a debt owed to the Partnership or to any other Person for any purpose whatsoever, except to the extent otherwise agreed to by such Partner and the General Partner. In the discretion of the Liquidator or the General Partner, a pro rata portion of the distributions that would otherwise be made to the General Partner and Limited Partners pursuant to this Article 13 may be:
A. distributed to a trust established for the benefit of the General Partner and Limited Partners for the purposes of liquidating Partnership assets, collecting amounts owed to the Partnership, and paying any contingent or unforeseen liabilities or obligations of the Partnership or of the General Partner arising out of or in connection with the Partnership. The assets of any such trust shall be distributed to the General Partner and Limited Partners from time to time, in the reasonable discretion of the Liquidator or the General Partner, in the same proportions and the amount distributed to such trust by the Partnership would otherwise have been distributed to the General Partner and Limited Partners pursuant to this Agreement; or
B. withheld to establish any reserves deemed necessary or appropriate for any contingent or unforeseen liabilities or obligations of the Partnership; and to reflect the unrealized portion of any installment obligations owed to the Partnership; provided that, such withheld amounts shall be distributed to the General Partner and Limited Partners as soon as practicable.
