Component 4: Increased Trade and Expanded Markets. This Component was eliminated from the original proposal and is not covered by the Cooperative Agreement between USAID and the Consortium.
Component 4: Increased Trade and Expanded Markets Sample Clauses
Related to Component 4: Increased Trade and Expanded Markets
Reducing Text Messaging While Driving Pursuant to Executive Order 13513, 74 FR 51225 (Oct. 6, 2009), Recipient should encourage its employees, subrecipients, and contractors to adopt and enforce policies that ban text messaging while driving, and Recipient should establish workplace safety policies to decrease accidents caused by distracted drivers.
Staffing Levels To the extent legislative appropriations and PIN authorizations allow, safe staffing levels will be maintained in all institutions where employees have patient, client, inmate or student care responsibilities. In July of each year, the Secretary or Deputy Secretary of each agency will, upon request, meet with the Union, to hear the employees’ views regarding staffing levels. In August of each year, the Secretary or Deputy Secretary of Budget and Management will, upon request, meet with the Union to hear the employees’ views regarding the Governor’s budget request.
Applicable Margins The ABR Applicable Margin and the LIBOR Applicable Margin to be used in calculating the interest rate applicable to different Types of Advances shall vary from time to time in accordance with the long-term unsecured debt ratings from Xxxxx’x, and Fitch of the General Partner and the Borrower. In the event the General Partner and the Borrower have different ratings, the rating of the higher rated entity shall be used. In the event the rating agencies are split on the rating for the higher rated entity, the lower rating for such entity shall be deemed to be the applicable rating (e.g., if the higher rated entity’s Xxxxx’x debt rating is Baa1, and its Fitch’s rating is BBB, then the Applicable Margins shall be computed based on the Fitch rating), and the Applicable Margins shall be adjusted effective on the next Business Day following any change in the higher rated entity’s Xxxxx’x debt rating, and/or Fitch’s debt rating, as the case may be. The applicable debt ratings and the Applicable Margins are set forth in the table attached as Exhibit A. In the event that Fitch or Xxxxx’x shall discontinue their ratings of the REIT industry, the General Partner or the Borrower, a mutually agreeable substitute rating agency (or two mutually agreeable substitute agencies if both existing rating agencies discontinue such ratings) shall be selected by the Required Lenders and the Borrower. If the Required Lenders and the Borrower cannot agree on a substitute rating agency or substitute rating agencies within thirty (30) days after such discontinuance, or if Fitch and Xxxxx’x shall discontinue their ratings of the REIT industry, the Borrower, or the General Partner, the Applicable Margin to be used for the calculation of interest on Advances hereunder shall be the highest Applicable Margin for each Type. If a rating agency downgrade or discontinuance results in an increase in the ABR Applicable Margin, the LIBOR Applicable Margin, or Facility Fee Rate and if such downgrade or discontinuance is reversed and the affected Applicable Margin is restored within ninety (90) days thereafter, at the Borrower’s request, the Borrower shall receive a credit against interest next due the Lenders equal to interest accrued from time to time during such period of downgrade or discontinuance and actually paid by the Borrower on the Advances at the differential between such Applicable Margins, and the differential of the Facility Fee paid during such period of downgrade. If a rating agency upgrade results in a decrease in the ABR Applicable Margin, LIBOR Applicable Margin or Facility Fee Rate and if such upgrade is reversed and the affected Applicable Margin is restored within ninety (90) days thereafter, Borrower shall be required to pay an amount to the Lenders equal to the interest differential on the Advances and the differential on the Facility Fees during such period of upgrade.
Predatory Lending Regulations; High Cost Loans None of the Mortgage Loans are classified as (a) “high cost” loans under the Home Ownership and Equity Protection Act of 1994 or (b) “high cost,” “threshold,” “predatory” or “covered” loans or “High Cost Home Loans” under any other applicable state, federal or local law (or a similarly classified loan using different terminology under a law imposing heightened regulatory scrutiny or additional legal liability for residential mortgage loans having high interest rates, points and/or fees);
Unbundled Channelization (Multiplexing) 5.7.1 To the extent NewPhone is purchasing DS1 or DS3 or STS-1 Dedicated Transport pursuant to this Agreement, Unbundled Channelization (UC) provides the optional multiplexing capability that will allow a DS1 (1.544 Mbps) or DS3 (44.736 Mbps) or STS-1 (51.84 Mbps) Network Elements to be multiplexed or channelized at a BellSouth central office. Channelization can be accomplished through the use of a multiplexer or a digital cross-connect system at the discretion of BellSouth. Once UC has been installed, NewPhone may request channel activation on a channelized facility and BellSouth shall connect the requested facilities via COCIs. The COCI must be compatible with the lower capacity facility and ordered with the lower capacity facility. This service is available as defined in NECA 4. 5.7.2 BellSouth shall make available the following channelization systems and interfaces: 5.7.2.1 DS1 Channelization System: channelizes a DS1 signal into a maximum of twenty- four (24)
Workplace adjustment An employer wishing to employ a person under the provisions of this clause shall take reasonable steps to make changes in the workplace to enhance the employee’s capacity to do the job. Changes may involve re-design of job duties, working time arrangements and work organisation in consultation with other employees in the area.
Provisioning Line Splitting and Splitter Space 3.8.1 The Data LEC, Voice CLEC or BellSouth may provide the splitter. When Southern Telecom or its authorized agent owns the splitter, Line Splitting requires the following: a non-designed analog Loop from the serving wire center to the NID at the End User’s location; a collocation cross connection connecting the Loop to the collocation space; a second collocation cross connection from the collocation space connected to a voice port; the high frequency spectrum line activation, and a splitter. The Loop and port cannot be a Loop and port combination (i.e. UNE-P), but must be individual stand-alone Network Elements. When BellSouth owns the splitter, Line Splitting requires the following: a non designed analog Loop from the serving wire center to the NID at the End User’s location with CFA and splitter port assignments, and a collocation cross connection from the collocation space connected to a voice port. 3.8.2 An unloaded 2-wire copper Loop must serve the End User. The meet point for the Voice CLEC and the Data LEC is the point of termination on the MDF for the Data LEC's cable and pairs. 3.8.3 The foregoing procedures are applicable to migration to Line Splitting Service from a UNE-P arrangement, BellSouth Retail Voice Service, BellSouth High Frequency Spectrum (CO Based) Line Sharing. 3.8.4 For other migration scenarios to line splitting, BellSouth will work cooperatively with CLECs to develop methods and procedures to develop a process whereby a Voice CLEC and a Data LEC may provide services over the same Loop.
Number Resources, Rate Center Areas and Routing Points 8.1 Nothing in this Agreement shall be construed to limit or otherwise adversely affect in any manner either Party’s right to employ or to request and be assigned any Central Office Codes (“NXX”) pursuant to the Central Office Code Assignment Guidelines and any relevant FCC or Commission orders, as may be amended from time to time, or to establish, by Tariff or otherwise, Rate Center Areas and Routing Points corresponding to such NXX codes. 8.2 It shall be the responsibility of each Party to program and update its own switches and network systems pursuant to information provided in the LERG in order to recognize and route traffic to the other Party’s assigned NXX codes. Except as expressly set forth in this Agreement, neither Party shall impose any fees or charges whatsoever on the other Party for such activities. 8.3 Unless otherwise required by Commission order, the Rate Center Areas will be the same for each Party. During the term of this Agreement, Onvoy shall adopt the Rate Center Area and Rate Center Points that the Commission has approved for Frontier within the LATA and Tandem serving area. Onvoy shall assign whole NPA-NXX codes to each Rate Center Area unless otherwise ordered by the FCC, the Commission or another governmental entity of appropriate jurisdiction, or the LEC industry adopts alternative methods of utilizing NXXs. 8.4 Onvoy will also designate a Routing Point for each assigned NXX code. Onvoy shall designate one location for each Rate Center Area in which the Onvoy has established NXX code(s) as the Routing Point for the NPA-NXXs associated with that Rate Center Area, and such Routing Point shall be within the same LATA as the Rate Center Area but not necessarily within the Rate Center Area itself. Unless specified otherwise, calls to subsequent NXXs of Onvoy will be routed in the same manner as calls to Xxxxx’s initial NXXs. 8.5 Notwithstanding anything to the contrary contained herein, nothing in this Agreement is intended, and nothing in this Agreement shall be construed, to in any way constrain Onvoy’s choices regarding the size of the local calling area(s) that Onvoy may establish for its Customers, which local calling areas may be larger than, smaller than, or identical to Frontier’s local calling areas.
Increased LIBO Rate Loan Costs, etc The Borrower agrees to reimburse each Lender and each Issuer for any increase in the cost to such Lender or Issuer of, or any reduction in the amount of any sum receivable by such Secured Party in respect of, such Secured Party’s Commitments and the making of Credit Extensions hereunder (including the making, continuing or maintaining (or of its obligation to make or continue) any Loans as, or of converting (or of its obligation to convert) any Loans into, LIBO Rate Loans) that arise in connection with any change in, or the introduction, adoption, effectiveness, interpretation, reinterpretation or phase-in after the Restatement Effective Date of, any law or regulation, directive, guideline, decision or request (whether or not having the force of law) of any Governmental Authority, except for such changes with respect to increased capital costs and Taxes which are governed by Sections 4.5 and 4.6, respectively. Each affected Secured Party shall promptly notify the Administrative Agent and the Borrower in writing of the occurrence of any such event, stating the reasons therefor and the additional amount required fully to compensate such Secured Party for such increased cost or reduced amount. Such additional amounts shall be payable by the Borrower directly to such Secured Party within five Business Days of its receipt of such notice, and such notice shall, in the absence of manifest error, constitute prima facie evidence thereof and shall be binding on the Borrower.
Unbundled Loop Modifications (Line Conditioning 2.5.1 Line Conditioning is defined as routine network modification that BellSouth regularly undertakes to provide xDSL services to its own customers. This may include the removal of any device, from a copper Loop or copper Subloop that may diminish the capability of the Loop or Subloop to deliver high-speed switched wireline telecommunications capability, including xDSL service. Such devices include, load coils, excessive bridged taps, low pass filters, and range extenders. Excessive bridged taps are bridged taps that serves no network design purpose and that are beyond the limits set according to industry standards and/or the BellSouth’s TR 73600 Unbundled Local Loop Technical Specification. 2.5.2 BellSouth will remove load coils only on copper Loops and Subloops that are less than eighteen thousand (18,000) feet in length. 2.5.3 For any copper loop being ordered by NewPhone which has over six thousand (6,000) feet of combined bridged tap will be modified, upon request from NewPhone, so that the loop will have a maximum of six thousand (6,000) feet of bridged tap. This modification will be performed at no additional charge to NewPhone. Loop conditioning orders that require the removal of bridged tap that serves no network design purpose on a copper Loop that will result in a combined total of bridged tap between two thousand five hundred (2,500) and six thousand (6,000) feet will be performed at the rates set forth in Exhibit A. 2.5.4 NewPhone may request removal of any unnecessary and non-excessive bridged tap (bridged tap between zero (0) and two thousand five hundred (2,500) feet which serves no network design purpose), at rates pursuant to BellSouth’s SC Process as mutually agreed to by the Parties. 2.5.5 Rates for ULM are as set forth in Exhibit A. 2.5.6 BellSouth will not modify a Loop in such a way that it no longer meets the technical parameters of the original Loop type (e.g., voice grade, ADSL, etc.) being ordered. 2.5.7 If NewPhone requests ULM on a reserved facility for a new Loop order, BellSouth may perform a pair change and provision a different Loop facility in lieu of the reserved facility with ULM if feasible. The Loop provisioned will meet or exceed specifications of the requested Loop facility as modified. NewPhone will not be charged for ULM if a different Loop is provisioned. For Loops that require a DLR or its equivalent, BellSouth will provide LMU detail of the Loop provisioned. 2.5.8 NewPhone shall request Loop make up information pursuant to this Attachment prior to submitting a service inquiry and/or a LSR for the Loop type that NewPhone desires BellSouth to condition. 2.5.9 When requesting ULM for a Loop that BellSouth has previously provisioned for NewPhone, NewPhone will submit a SI to BellSouth. If a spare Loop facility that meets the Loop modification specifications requested by NewPhone is available at the location for which the ULM was requested, NewPhone will have the option to change the Loop facility to the qualifying spare facility rather than to provide ULM. In the event that BellSouth changes the Loop facility in lieu of providing ULM, NewPhone will not be charged for ULM but will only be charged the service order charges for submitting an order.
