Controlled Blasting Provisions Sample Clauses

Controlled Blasting Provisions. 1. Line holes for controlled blasting are a minimum of 2 inches and a maximum of 3 inches in diameter with a 40-foot, maximum depth, and slope measurement. They are loaded with sufficient explosive charges to effect clean splitting of the materials between adjacent drill holes and a minimum of shattering or overbreak. Explosive charges include properly spaced cartridges, securely fastened to detonating cord with holes completely stemmed with free flowing sand or other approved materials. 2. Presplit or cushion blast a short test line of holes, as changes in conditions warrant, to determine the loading, spacing, and depth of lift required to obtain the desired result. Space drill holes as nearly parallel one to another as possible. 3. If drill holes do not remain open full depth or deviate more than 1 foot from a line formed by the intersection of the plane of the staked slope and a vertical perpendicular plane through the collar of a slope drill hole, reduce the lift until an open hole can be maintained or the deviation can be controlled within the 1-foot tolerance. 4. Successive sets of line holes may have their collars offset up to 1 foot, but be so inclined that all sets closely approximate the staked slopes. 5. Do not use lifters or springing of line holes in controlled blasting operations. 6. The end result of these specifications is intended to produce a cut face sheared along the staked slope line with a minimum of overbreak and little or no material shattered or loosened back of the finished slope. The amount and type of explosives, methods of loading, delay patterns, and other features not otherwise specified, are to meet the above requirements. 7. Furnish a blasting plan showing pattern and depth of drill holes, type and amount of explosives used, loading pattern, and sequence of firing to the Engineer prior to drilling.
Sample 1
AutoNDA by SimpleDocs

Related to Controlled Blasting Provisions

  • Controlling Provisions In the event of any inconsistencies between the provisions of this Amendment and the provisions of any other Loan Document, the provisions of this Amendment shall govern and prevail. Except as expressly modified by this Amendment, the Loan Documents shall not be modified and shall remain in full force and effect.

  • Voting Provisions As a condition precedent to entering into this Agreement, at the request of the Company, Purchaser shall become a party to any voting agreement to which the Company is a party at the time of Purchaser’s execution and delivery of this Agreement, as such voting agreement may be thereafter amended from time to time (the “Voting Agreement”), by executing an adoption agreement or counterpart signature page agreeing to be bound by and subject to the terms of the Voting Agreement and to vote the Shares in the capacity of a “Common Holder” and a “Stockholder,” as such terms may be defined in the Voting Agreement.

  • CLOSING PROVISIONS (a) Subscriber agrees to be identified as a customer of JetBrains and agrees that JetBrains may refer to Subscriber by name, trade name and trademark, if applicable, and may briefly describe Subscriber’s business in JetBrains marketing materials, on JetBrains Site, and in public or legal documents. Subscriber hereby grants JetBrains a worldwide, non- exclusive, royalty-free license to use Subscriber’s name and any of Subscriber’s trade names and trademarks solely pursuant to this marketing section. (b) This Agreement is governed by the laws of the Czech Republic. All disputes arising from the present Agreement and/or in connection with it shall be finally brought to and decided by any relevant competent common court in the Czech Republic. The parties agree that the United Nations Convention on Contracts for the International Sale of Goods does not apply to this Agreement. (c) JetBrains may modify this Agreement at any time by posting a revised version of the Agreement on JetBrains Site. The modified terms will become effective upon posting of a revised version of the Agreement on JetBrains Site. By continuing to use Service after the effective date of any modification to this Agreement, Subscriber agrees to be bound by the modified terms. It is Subscriber’s responsibility to check JetBrains Site regularly for modifications to this Agreement. (d) The parties are independent contractors. This Agreement does not create a partnership, franchise, joint venture, agency, or a fiduciary or employment relationship between the parties. (e) Sections 7, 8, 9, 10, 12 (c), 12(d), 14(a), 14(b), and 14(c) shall survive any termination or expiration of this Agree- ment. (f) There are no third-party beneficiaries to this Agreement. (g) If any provision of this Agreement is held by a court of competent jurisdiction to be contrary to law, the provision shall be modified by the court and interpreted so as best to accomplish the objectives of the original provision to the fullest extent permitted by law, and the remaining provisions of this Agreement shall remain in effect.

  • Remaining Provisions Except as expressly modified by this Amendment, the Employment Agreement shall remain in full force and effect. This Amendment embodies the entire agreement and understanding of the parties hereto with respect to the subject matter hereof, and supersedes all prior and contemporaneous agreements and understandings, oral or written, relative thereto.

  • Vesting Provisions Subject to the provisions of paragraph 3 below, the option shall vest 33⅓% on each of July 31, 2020, July 31, 2021 and July 31, 2022, except as follows:

  • Surviving Provisions Notwithstanding any termination of this Agreement, each party’s obligations under Article VIII to indemnify other parties shall survive and not be affected by any termination of this Agreement. In addition, with respect to Existing Contracts, all provisions of this Agreement shall also survive and not be affected by any termination of this Agreement.

  • Governing Provisions This Agreement is made under and subject to the provisions of the Plan, and all of the provisions of the Plan are also provisions of this Agreement. If there is a difference or conflict between the provisions of this Agreement and the provisions of the Plan, the provisions of the Plan will govern. By signing this Agreement, the Grantee confirms that he or she has received a copy of the Plan.

  • Terms Herein Controlling Provisions The terms of this attachment shall prevail and control over the terms of any other conflicting provision in any other document relating to and a part of the Agreement.

  • Concluding provisions Section 7.1 - Entire Agreement. All prior understandings, letters of intent, and agreements between the parties are merged in and superseded by this Agreement (including all Exhibits hereto).

  • COMMON PROVISIONS Article 16. Quantitative restrictions on imports and all measures having equivalent effect shall be prohibited between the Community and Israel. Article 17. Quantitative restrictions on exports and all measures having equivalent effect shall be prohibited between the Community and Israel. 1. Products originating in Israel shall not on importation into the Community be accorded a treatment more favourable than that which the Member States apply among themselves. 2. Application of the provisions of this Agreement shall be without prejudice to Council Regulation (EEC) No. 1911/91 of 26 June 1991 on the application of the provisions of Community law to the Canary Islands. 1. The Parties shall refrain from any measure or practice of an internal fiscal nature establishing, whether directly or indirectly, discrimination between the products of one Party and like products originating in the territory of the other Party. 2. Products exported to the territory of one of the Parties may not benefit from repayment of indirect internal taxation in excess of the amount of indirect taxation imposed on them directly or indirectly. 1. In the event of specific rules being established as a result of the implementation of its agricultural policy or of any alteration of the current rules or in the event of any alteration or extension of the provisions relating to the implementation of the agricultural policy, the Party in question may amend the arrangements resulting from the Agreement in respect of the products which are the subject of those rules or alterations. 2. In such cases the Party in question shall take due account of the interests of the other Party. To this end the Parties may consult each other within the Association Council. 1. The Agreement shall not preclude the maintenance or establishment of customs unions, free-trade areas or arrangements for frontier trade, except in so far as they alter the trade arrangements provided for in the Agreement. 2. Consultation between the Community and Israel shall take place within the Association Council concerning agreements establishing customs unions or free-trade areas and, where required, on other major issues related to their respective trade policy with third countries. In particular, in the event of a third country acceding to the European Union, such consultation shall take place so as to ensure that account can be taken of the mutual interests of the Community and Israel. Article 22. If one of the Parties finds that dumping is taking place in trade with the other Party within the meaning of Article VI of the GATT, it may take appropriate measures against this practice in accordance with the Agreement on implementation of Article VI of the GATT and with its relevant internal legislation, under the conditions and in accordance with the procedures laid down in Article 25. Article 23. Where any product is being imported in such increased quantities and under such conditions as to cause or threaten to cause: - serious injury to domestic producers of like or directly competitive products in the territory of one of the Parties, or - serious disturbances in any sector of the economy, or - difficulties which could bring about serious deterioration in the economic situation of a region, the Community or Israel may take appropriate measures under the conditions and in accordance with the procedures laid down in Article 25. Article 24. Where compliance with the provisions of Article 17 leads to: (i) re-export towards a third country against which the exporting Party maintains, for the product concerned, quantitative export restrictions, export duties, or measures having equivalent effect, or (ii) a serious shortage, or threat thereof, of a product essential to the exporting Party, and where the situations referred to above give rise, or are likely to give rise, to major difficulties for the exporting Party, that Party may take appropriate measures under the conditions and in accordance with the procedures laid down in Article

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!