Drawing not to scale Sample Clauses

Drawing not to scale. The support leg test device shall:
Sample 1
AutoNDA by SimpleDocs

Related to Drawing not to scale

  • Right Not to Follow Certain Instructions Notwithstanding clause (a) above, Agent shall not be required to take, or to omit to take, any action (i) unless, upon demand, Agent receives an indemnification satisfactory to it from the Lenders (or, to the extent applicable and acceptable to Agent, any other Person) against all Liabilities that, by reason of such action or omission, may be imposed on, incurred by or asserted against Agent or any Related Person thereof or (ii) that is, in the opinion of Agent or its counsel, contrary to any Loan Document or applicable Requirement of Law.

  • Agreement Not to Solicit Except as required in the performance of Executive’s duties as an employee of the Company, during Executive’s employment with the Company (whether before, during, or after the Term) and during the Restricted Period, Executive shall not, directly or indirectly, solicit, request, advise, induce or attempt to induce any vendor, supplier or other business contact of the Company to cancel, curtail, cease doing business with, or otherwise adversely change its relationship with the Company.

  • Reservation of Right Not to Sell The Fund reserves the right to refuse at any time or times to sell any of its shares of beneficial interest (“shares”) hereunder for any reason deemed adequate by it.

  • Officials Not to Benefit Contractor must comply with all applicable federal or State laws regulating ethical conduct of public officers and employees.

  • Costs Not To Be Reimbursed § 7.9.1 The Cost of the Work shall not include the items listed below: .1 Salaries and other compensation of the Construction Manager’s personnel stationed at the Construction Manager’s principal office or offices other than the site office, except as specifically provided in Section 7.2, or as may be provided in Article 14; .2 Bonuses, profit sharing, incentive compensation, and any other discretionary payments, paid to anyone hired by the Construction Manager or paid to any Subcontractor or vendor, unless the Owner has provided prior approval;

  • Agreement Not to Solicit Customers Executive agrees that during Executive’s employment with the Company hereunder and during the Non-Solicitation Period, Executive will not, either directly or indirectly, on Executive’s own behalf or in the service or on behalf of others, solicit, divert, or appropriate, or attempt to solicit, divert, or appropriate, to any business that engages in Restricted Field activities in the Business Territory (i) any person or entity whose account with the Company was sold or serviced by or under the supervision of Executive during the twelve (12) months preceding the termination of such employment, or (ii) any person or entity whose account with the Company has been directly solicited at least twice by the Company within the year preceding the termination of employment (the “Customers”). The Non-Solicitation Period set forth in this Section 11.4 shall be tolled during any period in which the Executive is in breach of the restriction set forth herein.

  • Licensed Documentation If commercially available, Licensee shall have the option to require the Contractor to deliver, at Contractor’s expense: (i) one (1) hard copy and one (1) master electronic copy of the Documentation in a mutually agreeable format; (ii) based on hard copy instructions for access by downloading from the Internet

  • Dissemination of Research Findings and Acknowledgement of Controlled-Access Datasets Subject to the NIH GDS Policy

  • Agreement Not to Solicit Employees Executive agrees that during Executive’s employment with the Company hereunder and during the Non-Solicitation Period, Executive will not, either directly or indirectly, on Executive’s own behalf or in the service or on the behalf of others solicit, divert, or hire away, or attempt to solicit, divert, or hire away any person then employed by the Company, nor encourage anyone to leave the Company’s employ. The Non-Solicitation Period set forth in this Section 11.5 shall be tolled during any period in which the Executive is in breach of the restriction set forth herein.

  • Application Form To apply for a pole attachment or conduit occupancy license under this Agreement, Applicant shall submit to SWBT two signed copies of the appropriate application forms. SWBT represents that the forms specified in subsections (a)-(b) are forms in use prior to the effective date of this Agreement and that SWBT is in the process of revising such forms to conform to the provisions of this Agreement and to streamline the application process. The parties therefore agree that the forms specified in subsections (a) and (b) will be interim forms only. SWBT reserves the right to change the format and content of these forms upon 60 days written notice to Applicant. (a) To apply for a pole attachment license, Applicant shall submit to SWBT two signed copies of SWBT’s Form SW-9434 (“Access Application and Make- Ready Authorization”) together with completed Form SW-9433 (“Pole Attachments”). An application for a pole attachment license will not be complete or subject to processing by SWBT until these forms have been submitted to SWBT; provided, however, that such forms will be deemed to be substantially complete if they contain the information specified in subsections (c)-(h) below, as applicable. Copies of Forms SW-9433 and SW-9434 are attached to this Agreement as parts of APPENDIX III. (b) To apply for a conduit occupancy license, Applicant shall submit to SWBT two signed copies of SWBT’s Form SW-9434 (“Access Application and Make-Ready Authorization”) together with completed Form SW-9435 (“Conduit Occupancy”). An application for a conduit occupancy license will not be complete or subject to processing by SWBT until these forms have been submitted to SWBT; provided, however, that such forms will be deemed to be substantially complete if they contain the information specified in subsections (c)-(h) below, as applicable. Copies of Forms SW-9434 and SW-9435 are attached to this Agreement as parts of APPENDIX III. (c) Each application for a license under this Agreement shall include, at a minimum, the following information: (1) the poles, ducts, and conduits (including all manholes) along Applicant’s proposed route to or within which Applicant desires to attach or place its facilities; (2) a description of the facilities to be attached to SWBT’s poles and a description of the facilities to be placed within each component of SWBT’s conduit system (including but not limited to ducts, conduits, manholes, and handholes) along the proposed route; (3) for poles, the proposed points of attachment; (4) for building entrance or building distribution ducts or conduits or other space within a building, a conspicuous statement, as required by Section 5.06 of this Agreement, that the application pertains to a building entrance or building distribution duct or conduit or other space within a building; (5) if applicable, a conspicuous notation that the space requested is not to be assigned (or billed) to Applicant until SWBT has received Applicant’s written instruction to make such assignment or issued a license authorizing Applicant to occupy the space requested; and (6) if applicable, a conspicuous statement that Applicant intends to occupy the space before the issuance of a license, as provided in Section 8.03 of this Agreement. (d) Facilities descriptions which apply to multiple pole attachments or conduit occupancies need only be described once on any form. Facilities descriptions shall include, at a minimum, the following information: (1) the number and types of cables, including the physical size (diameter) and weight (weight per foot); (2) the number and types of strands, if any, which will be used to support the cables, including the rated holding capacity expressed in thousand pound increments (e.g., 2.2M) of such strands; and (3) sufficient information to identify and describe the physical characteristics (size, dimensions, and weight) of apparatus enclosures and other facilities to be attached to SWBT’s poles or placed in SWBT’s conduit system. (e) When it appears to Applicant that facilities modification, capacity expansion, or make-ready work may be required to accommodate Applicant’s access requests, Applicant shall describe the facilities modification, capacity expansion, or make-ready work which Applicant proposes. Applicant shall also describe its plans, if any, to use any infrequent construction technique or connectivity solution authorized under Section 6.03 to avoid high or unusual expenditures and state its reasons for the use of such technique or solution. (f) Applicant acknowledges that the poles along a particular pole line or route may include poles owned by firms (such as electric utilities) other than SWBT, that it may be necessary for SWBT to rearrange its facilities or perform other make-ready work on poles other than poles it owns or controls in order to accommodate Applicant’s request for access to SWBT’s poles and that, at the time an application is submitted, it may be difficult for Applicant to determine with certainty whether a particular pole is owned or controlled by SWBT or by another entity. Accordingly, the application shall, to the extent feasible, identify all poles utilized by SWBT (without regard to ownership) along Applicant’s proposed route. (g) Each application for a license under this Agreement shall be accompanied by a construction schedule showing Applicant’s projected dates for beginning and completing construction at the sites specified in the application. Information on this schedule may be used by SWBT’s engineering and outside plant construction personnel in scheduling work required to process Applicant’s applications and scheduling such capacity expansions, make- ready work, and facilities modifications, if any, as may be necessary to accommodate Applicant’s facilities. (h) Applicant may include multiple cables in a single license application and may provide multiple services (e.g., CATV and non-CATV services) under the same cable sheath or jacket. When both CATV and non-CATV services are provided under the same cable sheath or jacket, or CATV and non-CATV services are provided using different cables attached or lashed to the same strand or otherwise occupying the same space on a pole or the same duct or inner duct within a conduit, Applicant will so advise SWBT and SWBT shall, if permitted by law, adjust its charges to enable SWBT to charge Applicant the rate applicable to telecommunications carriers rather than the rate applicable to cable television systems solely to provide cable service.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!