EOA Purge Fitting Sample Clauses

EOA Purge Fitting. The Satellite shall be configured to provide a purge fitting [**Redacted**].
Sample 1Sample 2Sample 3See All (8)
AutoNDA by SimpleDocs

Related to EOA Purge Fitting

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CSTC chooses to subtend a Verizon access Tandem, CSTC’s NPA/NXX must be assigned by CSTC to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG. 9.2.2 CSTC shall establish Access Toll Connecting Trunks pursuant to applicable access Tariffs by which it will provide Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic to and from CSTC’s Customers. 9.2.3 The Access Toll Connecting Trunks shall be two-way trunks. Such trunks shall connect the End Office CSTC utilizes to provide Telephone Exchange Service and Switched Exchange Access to its Customers in a given LATA to the access Tandem(s) Verizon utilizes to provide Exchange Access in such LATA. 9.2.4 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access to allow CSTC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier which is connected to a Verizon access Tandem.

  • Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning): 1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises. 2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated. 3. If capacity exists, provide "side-door" porting through the switch. 4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch). 2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases. 2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.

  • Fabrication Making up data or results and recording or reporting them.

  • Local Circuit Switching Capability, including Tandem Switching Capability 4.1.3.1 Definition 4.1.3.2 Notwithstanding BellSouth’s general duty to unbundle local circuit switching, BellSouth shall not be required to unbundle local circuit switching for <<customer_name>> when <<customer_name>> serves end-users with four (4) or more voice-grade (DS-0) equivalents or lines in locations served by BellSouth’s local circuit switches, which are in the following MSAs: Atlanta, GA; Miami, FL; Orlando, FL; Ft. Lauderdale, FL; Charlotte-Gastonia-Rock Hill, NC; Greensboro-Winston Salem-High Point, NC; Nashville, TN; and New Orleans, LA, and BellSouth has provided non-discriminatory cost based access to the Enhanced Extended Link (EEL) throughout Density Zone 1 as determined by NECA Tariff No. 4 as in effect on January 1, 1999. 4.1.3.3 In the event that <<customer_name>> orders local circuit switching for a single end user account name at a single physical end user location with four (4) or more 2-wire voice-grade loops from a BellSouth central office in an MSA listed above, BellSouth shall charge <<customer_name>> the market based rate in Exhibit C for use of the local circuit switching functionality for the affected facilities. 4.1.3.4 A featureless port is one that has a line port, switching facilities, and an interoffice port. A featured port is a port that includes all features then capable or a number of then capable features specifically requested by <<customer_name>>. Any features that are not currently then capable but are technically feasible through the switch can be requested through the NBR/BFR process. 4.1.3.5 BellSouth will provide to <<customer_name>> customized routing of calls: (i) to a requested directory assistance services platform; (ii) to an operator services platform pursuant to Section 10 of Attachment 2; (iii) for <<customer_name>>’s PIC’ed toll traffic in a two (2) PIC environment to an alternative OS/DA platform designated by <<customer_name>>. <<customer_name>> customers may use the same dialing arrangements as BellSouth customers. 4.1.3.6 Remote Switching Module functionality is included in Switching Capability. The switching capabilities used will be based on the line side features they support. 4.1.3.7 Switching Capability will also be capable of routing local, intraLATA, interLATA, and calls to international customer’s preferred carrier; call features (e.g. call forwarding) and Centrex capabilities. 4.1.3.8 Where required to do so in order to comply with an effective Commission order, BellSouth will provide to <<customer_name>> purchasing local BellSouth switching and reselling BellSouth local exchange service under Attachment 1, selective routing of calls to a requested directory assistance services platform or operator services platform. <<customer_name>> customers may use the same dialing arrangements as BellSouth customers, but obtain a <<customer_name>> branded service.

  • Load Shedding The systematic reduction of system demand by temporarily decreasing Load in response to a transmission system or area Capacity shortage, system instability, or voltage control considerations under the ISO OATT. Local Furnishing Bonds. Tax-exempt bonds issued by a Transmission Owner under an agreement between the Transmission Owner and the New York State Energy Research and Development Authority (“NYSERDA”), or its successor, or by a Transmission Owner itself, and pursuant to Section 142(f) of the Internal Revenue Code, 26 U.S.C. § 142(f). Locality. A single LBMP Load Zone or set of adjacent LBMP Load Zones within one Transmission District within which a minimum level of Installed Capacity must be maintained. Local Reliability Rule. A Reliability Rule established by a Transmission Owner, and adopted by the NYSRC to meet specific reliability concerns in limited areas of the NYCA, including without limitation, special conditions and requirements applicable to nuclear plants and special requirements applicable to the New York City metropolitan area. Locational Based Marginal Pricing (“LBMP”). A pricing methodology under which the price of Energy at each location in the NYS Transmission System is equivalent to the cost to supply the next increment of Load at that location (i.e., the short-run marginal cost). The short-run marginal cost takes generation Bid Prices and the physical aspects of the NYS Transmission System into account. The short-run marginal cost also considers the impact of Out-of-Merit Generation (as measured by its Bid Price) resulting from the Congestion and Marginal Losses occurring on the NYS Transmission System which are associated with supplying an increment of Load. The term LBMP also means the price of Energy bought or sold in the LBMP Markets at a specific location.

  • Installation, Maintenance, Testing and Repair Unless otherwise agreed in writing by the Parties, to the extent required by Applicable Law, Interconnection provided by a Party shall be equal in quality to that provided by such Party to itself, any subsidiary, affiliates or third party. If either Party is unable to fulfill its obligations under this Section 14.2, it shall notify the other Party of its inability to do so and will negotiate alternative intervals in good faith. The Parties agree that to the extent required by Applicable Law, the standards to be used by a Party for isolating and clearing any disconnections and/or other outages or troubles shall be at parity with standards used by such Party with respect to itself, any subsidiary, affiliate or third party.

  • Television Equipment Recycling Program If this Contract is for the purchase or lease of covered television equipment, then Contractor certifies that it is compliance with Subchapter Z, Chapter 361 of the Texas Health and Safety Code related to the Television Equipment Recycling Program.

  • WINDOW CLEANING Tenant shall not clean, nor require, permit, suffer or allow any window in the Premises to be cleaned from the outside in violation of Section 202 of the Labor Law, or any other Requirement, or of the rules of the Board of Standards and Appeals, or of any other board or body having or asserting jurisdiction.

  • Spares Boeing will revise, as applicable, the customized Recommended Spares Parts List (RSPL) and Illustrated Parts Catalog (IPC).

  • Durable Medical Equipment (DME), Medical Supplies, Prosthetic Devices, Enteral Formula or Food, and Hair Prosthesis (Wigs) This plan covers durable medical equipment and supplies, prosthetic devices and enteral formula or food as described in this section. DME is equipment which: • can withstand repeated use; • is primarily and customarily used to serve a medical purpose; • is not useful to a person in the absence of an illness or injury; and • is for use in the home. DME includes supplies necessary for the effective use of the equipment. This plan covers the following DME: • wheelchairs, hospital beds, and other DME items used only for medical treatment; and • replacement of purchased equipment which is needed due to a change in your medical condition or if the device is not functional, no longer under warranty, or cannot be repaired. DME may be classified as a rental item or a purchased item. In most cases, this plan only pays for a rental DME up to our allowance for a purchased DME. Repairs and supplies for rental DME are included in the rental allowance. Medical supplies are consumable supplies that are disposable and not intended for re- use. Medical supplies require an order by a physician and must be essential for the care or treatment of an illness, injury, or congenital defect. Covered medical supplies include: • essential accessories such as hoses, tubes and mouthpieces for use with medically necessary DME (these accessories are included as part of the rental allowance for rented DME); • catheters, colostomy and ileostomy supplies, irrigation trays and surgical dressings; and • respiratory therapy equipment. This plan covers diabetic equipment and supplies for the treatment of diabetes in accordance with R.I. General Law §27-20-30. Covered diabetic equipment and supplies include: • therapeutic or molded shoes and inserts for custom-molded shoes for the prevention of amputation; • blood glucose monitors including those with special features for the legally blind, external insulin infusion pumps and accessories, insulin infusion devices and injection aids; and • lancets and test strips for glucose monitors including those with special features for the legally blind, and infusion sets for external insulin pumps. The amount you pay differs based on whether the equipment and supplies are bought from a durable medical equipment provider or from a pharmacy. See the Summary of Pharmacy Benefits and the Summary of Medical Benefits for details. Coverage for some diabetic equipment and supplies may only be available from either a DME provider or from a pharmacy. Visit our website to determine if this is applicable or call our Customer Service Department. Prosthetic devices replace or substitute all or part of an internal body part, including contiguous tissue, or replace all or part of the function of a permanently inoperative or malfunctioning body part and alleviate functional loss or impairment due to an illness, injury or congenital defect. Prosthetic devices do not include dental prosthetics. This plan covers the following prosthetic devices as required under R.I. General Law § 27-20-52: • prosthetic appliances such as artificial limbs, breasts, larynxes and eyes; • replacement or adjustment of prosthetic appliances if there is a change in your medical condition or if the device is not functional, no longer under warranty and cannot be repaired; • devices, accessories, batteries and supplies necessary for prosthetic devices; • orthopedic braces except corrective shoes and orthotic devices used in connection with footwear; and • breast prosthesis following a mastectomy, in accordance with the Women’s Health and Cancer Rights Act of 1998 and R.I. General Law 27-20-29. The prosthetic device must be ordered or provided by a physician, or by a provider under the direction of a physician. When you are prescribed a prosthetic device as an inpatient and it is billed by a provider other than the hospital where you are an inpatient, the outpatient benefit limit will apply. Enteral formula or food is nutrition that is absorbed through the intestinal tract, whether delivered through a feeding tube or taken orally. Enteral nutrition is covered when it is the sole source of nutrition and prescribed by the physician for home use. In accordance with R.I. General Law §27-20-56, this plan covers enteral formula taken orally for the treatment of: • malabsorption caused by Crohn’s Disease; • ulcerative colitis; • gastroesophageal reflux; • chronic intestinal pseudo obstruction; and • inherited diseases of amino acids and organic acids. Food products modified to be low protein are covered for the treatment of inherited diseases of amino acids and organic acids. Preauthorization may be required. The amount that you pay may differ depending on whether the nutrition is delivered through a feeding tube or taken orally. When enteral formula is delivered through a feeding tube, associated supplies are also covered. This plan covers hair prosthetics (wigs) worn for hair loss suffered as a result of cancer treatment in accordance with R.I. General Law § 27-20-54 and subject to the benefit limit and copayment listed in the Summary of Medical Benefits. This plan will reimburse the lesser of the provider’s charge or the benefit limit shown in the Summary of Medical Benefits. If the provider’s charge is more than the benefit limit, you are responsible for paying any difference. This plan covers Early Intervention Services in accordance with R.I. General Law §27- 20-50. Early Intervention Services are educational, developmental, health, and social services provided to children from birth to thirty-six (36) months. The child must be certified by the Rhode Island Department of Human Services (DHS) to enroll in an approved Early Intervention Services program. Services must be provided by a licensed Early Intervention provider and rendered to a Rhode Island resident. Members not living in Rhode Island may seek services from the state in which they reside; however, those services are not covered under this plan. Early Intervention Services as defined by DHS include but are not limited to the following: • speech and language therapy; • physical and occupational therapy; • evaluation; • case management; • nutrition; • service plan development and review; • nursing services; and • assistive technology services and devices.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!