Filters in place and seal provided around edges.
Filters in place and Sample Clauses
Related to Filters in place and
Borrowing Procedures and Settlements (a) Procedure for Borrowing. Each Borrowing shall be made by an irrevocable written request by an Authorized Person delivered to Agent (which notice must be received by Agent no later than 10:00 a.m. (California time) on the Business Day prior to the date that is the requested Funding Date specifying (i) the amount of such Borrowing, and (ii) the requested Funding Date, which shall be a Business Day; provided, however, that in the case of a request for -------- ------- Swing Loan in an amount of $5,000,000, or less, such notice will be timely received if it is received by Agent no later than 10:00 a.m. (California time) on the Business Day that is the requested Funding Date) specifying (i) the amount of such Borrowing, and (ii) the requested Funding Date, which shall be a Business Day. At Agent's election, in lieu of delivering the above-described written request, any Authorized Person may give Agent telephonic notice of such request by the required time, with such telephonic notice to be confirmed in writing within 24 hours of the giving of such notice.
Installation and Conversion State Street and the Fund shall be responsible for the technical installation and conversion (“Installation and Conversion”) of the Designated Configuration. The Fund shall have the following responsibilities in connection with Installation and Conversion of the System: (i) The Fund shall be solely responsible for the timely acquisition and maintenance of the hardware and software that attach to the Designated Configuration in order to use the Data Access Services at the Designated Locations, and (ii) State Street and the Fund each agree that they will assign qualified personnel to actively participate during the Installation and Conversion phase of the System implementation to enable both parties to perform their respective obligations under this Addendum.
Sale of Placement Securities On the basis of the representations and warranties herein contained and subject to the terms and conditions herein set forth, upon the Sales Agent’s acceptance of the terms of a Placement Notice or upon receipt by the Sales Agent of an Acceptance, as the case may be, and unless the sale of the Placement Securities described therein has been declined, suspended, or otherwise terminated in accordance with the terms of this Agreement, the Sales Agent, for the period specified in the Placement Notice (as amended by the corresponding Acceptance, if applicable), will use its commercially reasonable efforts consistent with its normal trading and sales practices to sell such Placement Securities up to the amount specified, and otherwise in accordance with the terms of such Placement Notice (as amended by the corresponding Acceptance, if applicable). Each of the Company and the Operating Partnership acknowledges and agrees that (i) there can be no assurance that the Sales Agent will be successful in selling Placement Securities, (ii) the Sales Agent will incur no liability or obligation to the Company or the Operating Partnership or any other person or entity if it does not sell Placement Securities for any reason other than a failure by the Sales Agent to use its commercially reasonable efforts consistent with its normal trading and sales practices to sell such Placement Securities as required under this Section 6 and (iii) the Sales Agent shall be under no obligation to purchase Securities on a principal basis pursuant to this Agreement, except as otherwise agreed by the Sales Agent in the Placement Notice (as amended by the corresponding Acceptance, if applicable).
Heating, Ventilation and Air Conditioning Landlord shall furnish to the Premises heating, ventilation and air-conditioning (“HVAC”) in accordance with the Design Standards set forth in Exhibit D during Ordinary Business Hours. Landlord shall have access to all air-cooling, fan, ventilating and machine rooms and electrical closets and all other mechanical installations of Landlord (collectively, “Mechanical Installations”), and Tenant shall not construct partitions or other obstructions which may interfere with Landlord’s access thereto or the moving of Landlord’s equipment to and from the Mechanical Installations. No Tenant Party shall at any time enter the Mechanical Installations or tamper with, adjust, or otherwise affect such Mechanical Installations. Landlord shall not be responsible if the HVAC System fails to provide cooled or heated air, as the case may be, to the Premises in accordance with the Design Standards by reason of (i) any equipment installed by, for or on behalf of Tenant, which has an electrical load in excess of the average electrical load and human occupancy factors for the HVAC System as designed, or (ii) any rearrangement of partitioning or other Alterations made or performed by, for or on behalf of Tenant. Tenant shall install, if missing, blinds or shades on all windows, which blinds and shades shall be subject to Landlord’s approval, and shall keep operable windows in the Premises closed, and lower the blinds when necessary because of the sun’s position, whenever the HVAC System is in operation or as and when required by any Requirement. Tenant shall cooperate with Landlord and shall abide by the rules and regulations which Landlord may reasonably prescribe for the proper functioning and protection of the HVAC System. Tenant acknowledges that the server room in the Premises currently has three heat pumps installed, being two 4-ton units, and one 2.5-ton unit (the “Existing Heat Pumps”). The 2.5-ton unit is currently connected and operational. Tenant shall determine whether it is satisfied with the condition of the Existing Heat Pumps and Landlord shall not have any responsibility or liability for the condition, operation, maintenance, repair or replacement of the Existing Heat Pumps. Tenant may operate the Existing Heat Pumps. Tenant shall be responsible for, and pay directly for, all necessary maintenance and repairs to the Existing Heat Pumps. Tenant shall reimburse Landlord monthly for the cost of all utility services used to operate the Existing Heat Pumps within 10 Business Days after receipt of Landlord’s invoice for such amount. Landlord may measure Tenant’s usage of such utility services by either a sub-meter or by other reasonable methods such as by temporary check meters or by survey. Tenant, at its cost, may replace the Existing Heat Pumps with one or more new heat pumps, provided, however, that the capacity of such replacement heat pump(s) shall not exceed the 10.5-ton capacity cooling capacity of the Existing Heat Pumps.
Conversion of Merger Sub Capital Stock Each share of common stock, par value $0.01 per share, of Merger Sub issued and outstanding immediately prior to the Effective Time shall be converted into and become one newly issued, fully paid and non-assessable share of common stock of the Surviving Corporation.
Settlement of Placement Securities Unless otherwise specified in the applicable Placement Notice (as amended by the corresponding Acceptance, if applicable), settlement for sales of Placement Securities will occur on the second (2nd) Trading Day (or such earlier day as is industry practice for regular-way trading) following the date on which such sales are made (each, a “Settlement Date”). The amount of proceeds to be delivered to the Company on a Settlement Date against receipt of the Placement Securities sold (the “Net Proceeds”) will be equal to the aggregate sales price received by the Sales Agent at which such Placement Securities were sold, after deduction for (i) the Sales Agent’s commission, discount or other compensation for such sales payable by the Company pursuant to Section 2 hereof, (ii) any other amounts due and payable by the Company to the Sales Agent hereunder pursuant to Section 8(a) hereof, and (iii) any transaction fees imposed by any governmental or self-regulatory organization in respect of such sales.
Delivery of Placement Securities On or before each Settlement Date, the Company will, or will cause its transfer agent to, electronically transfer the Placement Securities being sold by crediting the Sales Agent’s or its designee’s account (provided the Sales Agent shall have given the Company written notice of such designee prior to the Settlement Date) at The Depository Trust Company through its Deposit and Withdrawal at Custodian System or by such other means of delivery as may be mutually agreed upon by the parties hereto which in all cases shall be freely tradable, transferable, registered shares in good deliverable form. On each Settlement Date, the Sales Agent will deliver the related Net Proceeds in same day funds to an account designated by the Company on, or prior to, the Settlement Date. The Company agrees that if the Company, or its transfer agent (if applicable), defaults in its obligation to deliver Placement Securities on a Settlement Date, the Company agrees that in addition to and in no way limiting the rights and obligations set forth in Section 10(a) and Section 11 hereof, it will (i) hold the Sales Agent harmless against any loss, liability, claim, damage, or expense whatsoever (including reasonable legal fees and expenses), as incurred, arising out of or in connection with such default by the Company or its transfer agent (if applicable) and (ii) pay to the Sales Agent any commission, discount, or other compensation to which it would otherwise have been entitled absent such default.
Conversion of Merger Sub Common Stock At the Effective Time, each share of common stock, par value $0.01 per share, of Merger Sub issued and outstanding immediately prior to the Effective Time shall be converted into one fully paid and nonassessable share of common stock, par value $0.01 per share, of the Surviving Corporation.
Provisioning Line Splitting and Splitter Space 3.8.1 The Data LEC, Voice CLEC or BellSouth may provide the splitter. When Southern Telecom or its authorized agent owns the splitter, Line Splitting requires the following: a non-designed analog Loop from the serving wire center to the NID at the End User’s location; a collocation cross connection connecting the Loop to the collocation space; a second collocation cross connection from the collocation space connected to a voice port; the high frequency spectrum line activation, and a splitter. The Loop and port cannot be a Loop and port combination (i.e. UNE-P), but must be individual stand-alone Network Elements. When BellSouth owns the splitter, Line Splitting requires the following: a non designed analog Loop from the serving wire center to the NID at the End User’s location with CFA and splitter port assignments, and a collocation cross connection from the collocation space connected to a voice port. 3.8.2 An unloaded 2-wire copper Loop must serve the End User. The meet point for the Voice CLEC and the Data LEC is the point of termination on the MDF for the Data LEC's cable and pairs. 3.8.3 The foregoing procedures are applicable to migration to Line Splitting Service from a UNE-P arrangement, BellSouth Retail Voice Service, BellSouth High Frequency Spectrum (CO Based) Line Sharing. 3.8.4 For other migration scenarios to line splitting, BellSouth will work cooperatively with CLECs to develop methods and procedures to develop a process whereby a Voice CLEC and a Data LEC may provide services over the same Loop.
Toilet Facilities The Employer provides the Contractor access to toilet facilities. Temporary chemical toilets are provided by the Contractor where deemed necessary.
