Common use of GENERAL OFFERINGS Clause in Contracts

GENERAL OFFERINGS. 4.1 Except where Virtual Collocation is not practical for technical reasons or because of space limitations, SBC-13STATE will provide Virtual Collocation to Collocator for the purpose of interconnecting to SBC-13STATE network for the transmission and routing of telephone exchange service or exchange access, or both pursuant to 47 U.S.C. §251 (c)(2), or for obtaining access to SBC-13STATE Unbundled Network Elements (“UNEs”) for the provision of a telecommunications service pursuant to 47 U.S.C. §251 (c)(3) of the FTA 96. Virtual Collocation will be provided on a "first come, first served" basis, in accordance with the requirements of the Act (including 47 U.S.C. 251 (c)(6) of the FTA 96. 4.2 In the case of SBC-13STATE Virtual Collocation, the Collocator is responsible for engineering and furnishing the virtually collocated equipment. It must use an SBC- 13STATE Approved Vendor to perform the installation of such in the SBC-13STATE Eligible Structure. The Collocator's SBC-13STATE Approved Vendor will be permitted access to the SBC-13STATE Main Distribution Frame or its equivalent for placement and termination of interconnection cabling and the cabling arrangement to provide grounding for equipment. Collocator must use an SBC-13STATE Approved Power Installation Vendor to place power cable leads from the Collocator's dedicated space to SBC-13STATE's Battery Distribution Fuse Bay (BDFB) or Power Plant, whichever is applicable. Additional requirements relating to installation and placement of interconnection cabling and power cabling is set forth in Section 10.5 and 10.6 of this Appendix. SBC-13STATE will exercise physical control over, but not ownership of, the equipment installed by Collocator in a Virtual Collocation arrangement. The equipment and associated facilities will be maintained and repaired at the direction of the Collocator by SBC-13STATE. 4.2.1 Collocator will install their own bay(s) by an SBC-13STATE Approved Vendor. SBC-13STATE will provide space for the bay(s) in either a Standard Bay arrangement of 10 sq. ft. or a Non-Standard Bay arrangement of 18 sq. ft. The standard bay and non-standard bay dimensions are as follows: 4.2.1.1 Standard bay dimensions cannot exceed 7'0" high, and 23" interior width, 26" exterior width, and up to 15" deep. 4.2.1.2 Non-standard bay dimensions cannot exceed 7'0" high, 36" in width, and up to 36" in depth.

GENERAL OFFERINGS. 4.1 Except where Virtual Collocation is not practical for technical reasons or because of space limitations, SBC-13STATE will provide Virtual Collocation to Collocator for the purpose of interconnecting to SBC-13STATE network for the transmission and routing of telephone exchange service or exchange access, or both pursuant to 47 U.S.C. §251 (c)(2), or for obtaining access to SBC-13STATE Unbundled Network Elements (“UNEs”) for the provision of a telecommunications service pursuant to 47 U.S.C. §251 (c)(3) of the FTA 96. Virtual Collocation will be provided on a "first come, first served" basis, in accordance with the requirements of the Act (including 47 U.S.C. 251 (c)(6) of the FTA 96. 4.2 In the case of SBC-13STATE Virtual Collocation, the Collocator is responsible for engineering and furnishing the virtually collocated equipment. It must use an SBC- 13STATE Approved Vendor to perform the installation of such in the SBC-13STATE Eligible Structure. The Collocator's SBC-13STATE Approved Vendor will be permitted access to the SBC-13STATE Main Distribution Frame or its equivalent for placement and termination of interconnection cabling and the cabling arrangement to provide grounding for equipment. Collocator must use an SBC-13STATE Approved Power Installation Vendor to place power cable leads from the Collocator's dedicated space to SBC-13STATESBC- 13STATE's Battery Distribution Fuse Bay (BDFB) or Power Plant, whichever is applicable. Additional requirements relating to installation and placement of interconnection cabling and power cabling is set forth in Section 10.5 and 10.6 of this Appendix. SBC-13STATE SBC- 13STATE will exercise physical control over, but not ownership of, the equipment installed by Collocator in a Virtual Collocation arrangement. The equipment and associated facilities will be maintained and repaired at the direction of the Collocator by SBC-13STATESBC- 13STATE. 4.2.1 Collocator will install their own bay(s) by an SBC-13STATE Approved Vendor. SBC-13STATE will provide space for the bay(s) in either a Standard Bay arrangement of 10 sq. ft. or a Non-Standard Bay arrangement of 18 sq. ft. The standard bay and non-standard bay dimensions are as follows: 4.2.1.1 Standard bay dimensions cannot exceed 7'0" high, and 23" interior width, 26" exterior width, and up to 15" deep. 4.2.1.2 Non-standard bay dimensions cannot exceed 7'0" high, 36" in width, and up to 36" in depth.

GENERAL OFFERINGS. 4.1 Except where Virtual Collocation is not practical for technical reasons or because of space limitations, SBC-13STATE will provide Virtual Collocation to Collocator for the purpose of interconnecting to SBC-13STATE network for the transmission and routing of telephone exchange service or exchange access, or both pursuant to 47 U.S.C. §251 (c)(2), or for obtaining access to SBC-13STATE Unbundled Network Elements (“UNEs”) for the provision of a telecommunications service pursuant to 47 U.S.C. §251 (c)(3) of the FTA 96. Virtual Collocation will be provided on a "first come, first served" basis, in accordance with the requirements of the Act (including 47 U.S.C. 251 (c)(6) of the FTA 96. 4.2 In the case of SBC-13STATE Virtual Collocation, the Collocator is responsible for engineering and furnishing the virtually collocated equipment. It Collocator must use an SBC- 13STATE SBC-13STATE Approved Vendor to perform the installation of such in the SBC-13STATE SBC- 13STATE Eligible Structure. The Collocator's SBC-13STATE Approved Vendor will be permitted access to the SBC-13STATE Main Distribution Frame or its equivalent for placement installation and termination of interconnection cabling and the cabling arrangement to provide grounding for equipment. Collocator must use an SBC-13STATE Approved Power Installation Vendor to place install power cable leads cable(s) from the Collocator's dedicated space to the designated SBC-13STATE's Battery Distribution Fuse Bay (BDFB) or Power PlantPlant Primary Distribution points, whichever is applicable. Additional requirements relating to installation and placement of interconnection cabling and power cabling is set forth in Section 10.5 and 10.6 of this Appendix. SBC-13STATE will exercise physical control over, but not ownership of, the equipment installed by Collocator in a Virtual Collocation arrangement. The equipment and associated facilities will be maintained and repaired at the direction of the Collocator by SBC-13STATE. 4.2.1 Collocator will install their own bay(s) by an SBC-13STATE Approved Vendor. SBC-13STATE will provide space for the bay(s) in either a Standard Bay arrangement of 10 sq. ft. or a Non-Standard Bay arrangement of 18 sq. ft. The standard bay and non-standard bay dimensions are as follows: 4.2.1.1 Standard bay dimensions cannot exceed 7'0" high, and 23" interior width, 26" exterior width, and up to 15" deep. 4.2.1.2 Non-standard bay dimensions cannot exceed 7'0" high, 36" in width, and up to 36" in depth.

GENERAL OFFERINGS. 4.1 Except where Virtual Collocation is not practical for technical reasons or because of space limitations, SBC-13STATE will provide Virtual Collocation to Collocator for the purpose of interconnecting to SBC-13STATE SBC- 13STATE network for the transmission and routing of telephone exchange service or exchange access, or both pursuant to 47 U.S.C. §251 (c)(2), or for obtaining access to SBC-13STATE Unbundled Network Elements (“UNEs”) for the provision of a telecommunications service pursuant to 47 U.S.C. §251 (c)(3) of the FTA 96. Virtual Collocation will be provided on a "first come, first served" basis, in accordance with the requirements of the Act (including 47 U.S.C. 251 (c)(6) of the FTA 96. 4.2 In the case of SBC-13STATE Virtual Collocation, the Collocator is responsible for engineering and furnishing the virtually collocated equipment. It Collocator must use an SBC- 13STATE SBC-13STATE Approved Vendor to perform the installation of such in the SBC-13STATE Eligible Structure. The Collocator's SBC-13STATE Approved Vendor will be permitted access to the SBC-13STATE Main Distribution Frame or its equivalent for placement installation and termination of interconnection cabling and the cabling arrangement to provide grounding for equipment. Collocator must use an SBC-13STATE Approved Power Installation Vendor to place install power cable leads cable(s) from the Collocator's dedicated space Virtual Collocation Space to the designated SBC-13STATE's Battery Distribution Fuse Bay (BDFB) or Power PlantPlant Primary Distribution points, whichever is applicable. Additional requirements relating to installation and placement of interconnection cabling and power cabling is set forth in Section 10.5 and 10.6 of this Appendix. SBC-13STATE will exercise physical control over, but not ownership of, the equipment installed by Collocator in a Virtual Collocation arrangement. The equipment and associated facilities will be maintained and repaired at the direction of the Collocator by SBC-13STATE. 4.2.1 Collocator will install their own bay(s) by an SBC-13STATE Approved Vendor. SBC-13STATE will provide space for the bay(s) in either a Standard Bay arrangement of 10 sq. ft. or a Non-Standard Bay arrangement of 18 sq. ft. The standard bay and non-standard bay dimensions are as follows: 4.2.1.1 Standard bay dimensions cannot exceed 7'0" high, and 23" interior width, 26" exterior width, and up to 15" deep. 4.2.1.2 Non-standard bay dimensions cannot exceed 7'0" high, 36" in width, and up to 36" in depth.