Indicator Light. 31 The automatic bypass transfer switch must include a bypass indicator light that automatically 32 notifies the user when the manual bypass switch is in bypass position. The indicator light must 33 be illuminated when in UPS mode.
Indicator Light Sample Clauses
Related to Indicator Light
Indicator Home and Community Care • Reduce wait time for home care (improve access) • More days at home (including end of life care) Percent of Palliative Care Patients discharged from hospital with home support Sustainability and Quality • Improve patient satisfaction • Reduce unnecessary readmissions Overall Satisfaction with Health Care in the Community SCHEDULE 6: INTEGRATED REPORTING General Obligations
Indicators Debt to Asset Ratio (10%) •Cash Flow (10%) •Total Margin (25%)
RE-WEIGHING PRODUCT Deliveries are subject to re- weighing at the point of destination by the Authorized User. If shrinkage occurs which exceeds that normally allowable in the trade, the Authorized User shall have the option to require delivery of the difference in quantity or to reduce the payment accordingly. Such option shall be exercised in writing by the Authorized User.
Access Toll Connecting Trunk Group Architecture 9.2.1 If CSTC chooses to subtend a Verizon access Tandem, CSTC’s NPA/NXX must be assigned by CSTC to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG. 9.2.2 CSTC shall establish Access Toll Connecting Trunks pursuant to applicable access Tariffs by which it will provide Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic to and from CSTC’s Customers. 9.2.3 The Access Toll Connecting Trunks shall be two-way trunks. Such trunks shall connect the End Office CSTC utilizes to provide Telephone Exchange Service and Switched Exchange Access to its Customers in a given LATA to the access Tandem(s) Verizon utilizes to provide Exchange Access in such LATA. 9.2.4 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access to allow CSTC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier which is connected to a Verizon access Tandem.
Bilateral Safeguard Measures 1. Where, as a result of the reduction or elimination of a customs duty under this Agreement, any product originating in a Party is being imported into the territory of another Party in such increased quantities, in absolute terms or relative to domestic production, and under such conditions as to constitute a substantial cause of serious injury or threat thereof to the domestic industry of like or directly competitive products in the territory of the importing Party, the importing Party may take bilateral safeguard measures to the minimum extent necessary to remedy or prevent the injury, subject to the provisions of paragraphs 2 to 10. 2. Bilateral safeguard measures shall only be taken upon clear evidence that increased imports have caused or are threatening to cause serious injury pursuant to an investigation in accordance with the procedures laid down in the WTO Agreement on Safeguards. 3. The Party intending to take a bilateral safeguard measure under this Article shall immediately, and in any case before taking a measure, make notification to the other Parties and the Joint Committee. The notification shall contain all pertinent information, which shall include evidence of serious injury or threat thereof caused by increased imports, a precise description of the product involved and the proposed measure, as well as the proposed date of introduction, expected duration and timetable for the progressive removal of the measure. A Party that may be affected by the measure shall be offered compensation in the form of substantially equivalent trade liberalisation in relation to the imports from any such Party. 4. If the conditions set out in paragraph 1 are met, the importing Party may take measures consisting in increasing the rate of customs duty for the product to a level not to exceed the lesser of: (a) the MFN rate of duty applied at the time the action is taken; or (b) the MFN rate of duty applied on the day immediately preceding the date of the entry into force of this Agreement. 5. Bilateral safeguard measures shall be taken for a period not exceeding one year. In very exceptional circumstances, after review by the Joint Committee, measures may be taken up to a total maximum period of three years. No measure shall be applied to the import of a product which has previously been subject to such a measure. 6. The Joint Committee shall within 30 days from the date of notification examine the information provided under paragraph 3 in order to facilitate a mutually acceptable resolution of the matter. In the absence of such resolution, the importing Party may adopt a measure pursuant to paragraph 4 to remedy the problem, and, in the absence of mutually agreed compensation, the Party against whose product the measure is taken may take compensatory action. The bilateral safeguard measure and the compensatory action shall be immediately notified to the other Parties and the Joint Committee. In the selection of the bilateral safeguard measure and the compensatory action, priority must be given to the measure which least disturbs the functioning of this Agreement. The compensatory action shall normally consist of suspension of concessions having substantially equivalent trade effects or concessions substantially equivalent to the value of the additional duties expected to result from the bilateral safeguard measure. The Party taking compensatory action shall apply the action only for the minimum period necessary to achieve the substantially equivalent trade effects and in any event, only while the measure under paragraph 4 is being applied. 7. Upon the termination of the measure, the rate of customs duty shall be the rate which would have been in effect but for the measure. 8. In critical circumstances, where delay would cause damage which would be difficult to repair, a Party may take a provisional emergency measure pursuant to a preliminary determination that there is clear evidence that increased imports constitute a substantial cause of serious injury, or threat thereof, to the domestic industry. The Party intending to take such a measure shall immediately notify the other Parties and the Joint Committee thereof. Within 30 days of the date of the notification, the procedures set out in paragraphs 2 to 6, including for compensatory action, shall be initiated. Any compensation shall be based on the total period of application of the provisional emergency measure and of the emergency measure. 9. Any provisional measure shall be terminated within 200 days at the latest. The period of application of any such provisional measure shall be counted as part of the duration of the measure set out in paragraph 5 and any extension thereof. Any tariff increases shall be promptly refunded if the investigation described in paragraph 2 does not result in a finding that the conditions of paragraph 1 are met. 10. Five years after the date of entry into force of this Agreement, the Parties shall review in the Joint Committee whether there is need to maintain the possibility to take safeguard measures between them. If the Parties decide, after the first review, to maintain such possibility, they shall thereafter conduct biennial reviews of this matter in the Joint Committee.
Unbundled Digital Loops 2.3.1 BellSouth will offer Unbundled Digital Loops (UDL). UDLs are service specific, will be designed, will be provisioned with test points (where appropriate), and will come standard with OC and a DLR. The various UDLs are intended to support a specific digital transmission scheme or service. 2.3.2 BellSouth shall make available the following UDLs, subject to restrictions set forth herein:
PROCUREMENT CARD The State has entered into an agreement for purchasing card services. The Purchasing Card enables Authorized Users to make authorized purchases directly from a Contractor without processing Purchase Orders or Purchase Authorizations. Purchasing Cards are issued to selected employees authorized to purchase for the Authorized User and having direct contact with Contractors. Cardholders can make purchases directly from any Contractor that accepts the Purchasing Card. The Contractor shall not process a transaction for payment through the credit card clearinghouse until the purchased Products have been shipped or services performed. Unless the cardholder requests correction or replacement of a defective or faulty Product in accordance with other Contract requirements, the Contractor shall immediately credit a cardholder’s account for Products returned as defective or faulty.
Start-Up and Synchronization Consistent with the mutually acceptable procedures of the Developer and Connecting Transmission Owner, the Developer is responsible for the proper synchronization of the Large Generating Facility to the New York State Transmission System in accordance with NYISO and Connecting Transmission Owner procedures and requirements.
Network Interconnection Architecture Each Party will plan, design, construct and maintain the facilities within their respective systems as are necessary and proper for the provision of traffic covered by this Agreement. These facilities include but are not limited to, a sufficient number of trunks to the point of interconnection with the tandem company, and sufficient interoffice and interexchange facilities and trunks between its own central offices to adequately handle traffic between all central offices within the service areas at a P.01 grade of service or better. The provisioning and engineering of such services and facilities will comply with generally accepted industry methods and practices, and will observe the rules and regulations of the lawfully established tariffs applicable to the services provided.
Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning): 1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises. 2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated. 3. If capacity exists, provide "side-door" porting through the switch. 4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch). 2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases. 2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.
