Inspection, Testing and Calibration. Each Meter shall be tested at Seller’s expense in accordance with the requirements of ISO-NE Operating Procedure No. 18 with respect to frequency, method and test points; provided, however, that, notwithstanding the provisions of any ISO-NE Rules or ISO-NE Practices, Buyer may require that each Meter be tested at Seller’s expense once each Contract Year. Seller shall notify Buyer and coordinate such testing to allow for witnessing by Buyer, and the testing company will provide written reports of all testing results to Buyer. Buyer shall have the right to inspect and test (at its own expense) any of the Meters at the Facility at reasonable times and upon reasonable (but in any event, no less than 14 days’) notice from Buyer to Seller in coordination with the Interconnecting Utility. Buyer shall have the right to have a representative present during any testing or calibration of the Meters at the Facility by Seller in coordination with the Interconnecting Utility. Seller shall provide Buyer with timely notice of any such testing or calibration. Any representative of Buyer performing a Meter inspection shall undergo Seller provided training prior to such representative’s initial inspection. During any inspection, testing, or calibration of the Meters, Buyer shall be subject to Seller’s and its contractors’ reasonable site access rules and any safety Laws applicable to the site where the Facility is located. Buyer shall be accompanied by a Seller representative for any Meter inspection.
Appears in 5 contracts
Samples: Power Purchase Agreement, Power Purchase Agreement, Power Purchase Agreement
