Installation Tenant may install and use Tenant's Lines and make connections and disconnections at the terminal blocks as described above, provided Tenant shall: (i) obtain Landlord's prior written approval of all aspects thereof, (ii) use an experienced and qualified contractor designated or approved in writing in advance by Landlord (whom Landlord may require to enter an access and indemnity agreement on Landlord's then standard form of agreement therefor), (iii) comply with such inside wire standards as Landlord may adopt from time to time, and all other provisions of this Lease, including Paragraph 8 respecting alterations, and the Building rules respecting access to the wire closets, (iv) not install Lines in the same sleeve, chaseway or other enclosure in close proximity with electrical wire, and not install PVC-coated Lines under any circumstances, (v) thoroughly test any riser Lines to which Tenant intends to connect any Lines to ensure that such riser Lines are available and are not then connected to or used for telephone, data transmission or any other purpose by any other party (whether or not Landlord has previously approved such connections), and not connect to any such unavailable or connected riser Lines, and (vi) not connect any equipment to the Lines which may create an electromagnetic field exceeding the normal insulation ratings of ordinary twisted pair riser cable or cause radiation higher than normal background radiation, unless the Lines therefor (including riser Lines) are appropriately insulated to prevent such excessive electromagnetic fields or radiation (and such insulation shall not be provided by the use of additional unused twisted pair Lines). As a condition to permitting installation of new Lines, Landlord may require that Tenant remove any existing Lines located in or serving the Premises.
Communications Equipment Members of the board of directors or any committee thereof may participate in and act at any meeting of such board or committee through the use of a conference telephone or other communications equipment by means of which all persons participating in the meeting can hear each other, and participation in the meeting pursuant to this section shall constitute presence in person at the meeting.
HVAC A. Heating, ventilating and air conditioning equipment will be provided with sufficient capacity to accommodate a maximum population density of one (1) person per one hundred fifty (150) square feet of useable floor area served, and a combined lighting and standard electrical load of 3.0 xxxxx per square foot of useable floor area. In the event Tenant introduces into the Premises personnel or equipment which overloads the system’s ability to adequately perform its proper functions, Landlord shall so notify Tenant in writing and supplementary system(s) may be required and installed by Landlord at Tenant’s expense, if within fifteen (15) days Tenant has not modified its use so as not to cause such overload. Operating criteria of the basic system shall not be less than the following:
Maintenance Repairs and Alterations 6.01 Tenant's Obligations to Repair ------------------------------ Tenant shall at its sole cost and expense, maintain in clean and safe condition, and make all repairs and replacements to the Premises and every part thereof, structural and non-structural, so as to keep, maintain and preserve the Premises in first class condition and repair, including, without limitation, the roof, the foundation, the heating, ventilation and air conditioning system ("HVAC"), elevators, if any, all plumbing and sewage facilities, fire sprinklers, electrical and lighting facilities, systems, appliances, and equipment within the Premises, fixtures, interior and exterior walls, floors, ceilings, windows, doors, entrances, all interior and exterior glass (including plate glass), and skylights located within the Premises, and all sidewalks, service areas, parking areas and landscaping comprising part of the Premises. All repairs and replacements required to be made by Tenant shall be made promptly with new materials of like kind and quality to those used in the original construction of the Premises. If the repair or replacement work affects the structural parts of the Premises, or if the estimated cost of any item or repair or replacement exceeds $10,000, then Tenant shall first obtain Landlord's written approval of the scope of work, plans therefor, and materials to be used. Any such work shall be performed by Landlord's contractor or by such contractor as Tenant may choose from an approved list to be submitted by Landlord. Landlord shall have the right to make any repairs or replacements which are not promptly made by Tenant and charge Tenant, as Additional Rent, for the cost thereof together with interest thereon at the Agreed Rate from the date of payment thereof by Landlord. Without limiting any of Tenant's obligations hereunder, during the Lease Term Tenant, at its expense, shall obtain and keep in force an HVAC service contract and a roof maintenance program satisfactory to Landlord. Tenant hereby waives the benefit of any statute now or hereafter in effect which would otherwise afford Tenant the right to make repairs at Landlord's expense or to terminate this Lease because of Landlord's failure to keep the Premises in good condition, order and repair. Tenant specifically waives all rights it may have under Sections 1932(1), 1941 and 1942 of the California Civil Code, and any similar or successor statute or law. Notwithstanding anything to the contrary contained herein, Landlord shall exercise its rights under any guaranties or warranties relating to the original construction of the Premises if the need to make repairs arises due to a defect therein; provided, however, Landlord shall not have any liability or be required to expend any funds if such guaranties or warranties are not honored by the makers hereof.
Rooftop Equipment Provided that Tenant complies with the terms of ----------------- this Section, Tenant may, at its risk and expense, install a satellite dish and related communications equipment and wiring (collectively, the "Rooftop ------- Equipment") on the roof of the Building at a location approved by Landlord, --------- which equipment may be used solely by Tenant and its Permitted Transferees or Permitted Sublessees. Before installing the Rooftop Equipment, Tenant shall submit to Landlord for its approval (which approval shall be in Landlord's sole discretion) plans and specifications which (a) specify in detail the design, location, size, and, in the case of a satellite dish, frequency of the Rooftop Equipment and (b) are sufficiently detailed to allow for the installation of the Rooftop Equipment in a good and workmanlike manner and in accordance with all Laws (the "Legal Requirements"). If Landlord approves of such plans, Tenant ------------------ shall install (in a good and workmanlike manner), maintain and use the Rooftop Equipment in accordance with all Legal Requirements and shall obtain all consents and permits required for the installation and operation thereof; copies of all such permits and evidence of such consents must be submitted to Landlord before Tenant begins to install the Rooftop Equipment. Tenant shall thereafter maintain all permits necessary for the maintenance and operation of the Rooftop Equipment while it is on the Building and operate and maintain the Rooftop Equipment in such a manner so as not to unreasonably interfere with any other satellite, antennae, or other transmission facility on the Building's roof or in the Building. Landlord may require that Tenant screen the Rooftop Equipment with a parapet or other screening device acceptable to Landlord. Tenant shall maintain the Rooftop Equipment and screening device in good repair and condition. Tenant shall, at its risk and expense, remove the Rooftop Equipment (including all wiring related thereto), within five days after the occurrence of any of the following events: (1) the termination of Tenant's right to possess the Premises; (2) the termination of the Lease; (3) the expiration of the Term; or (4)
Maintenance Repairs Utility Installations Trade Fixtures and Alterations 7.1 Lessee's Obligations.
Alterations For purposes of this Lease, any physical improvement addition, enhancement or change with respect to all or any portion of the Premises is referred to as an "Alteration." Tenant or Franchisor shall have the right at any time and from time to time during the Term to make or cause to be made any Alteration in or to the Premises (i) without Landlord's consent, if such Alteration is performed in order to comply with any of Tenant's agreements with Franchisor and such Alteration does not adversely affect any structural component of the Building and (ii) in the case of any Alteration other than those permitted under clause (i) above, with Landlord's prior consent, which consent shall not be unreasonably withheld provided that such Alteration does not (A) diminish the value of the Premises (including, by way of example only, but without limitation, by diminishing the utility of the Improvements for use as a restaurant or diminishing the useful life of the Improvements), except to a de minimis extent, or (B) adversely affect any structural component of the Building. Every Alteration shall be made in accordance with all applicable laws, legal requirements and the Permitted Encumbrances. If Tenant shall submit a request to Landlord for Landlord's approval of an Alteration which requires Landlord's approval, Landlord shall (x) approve such Alteration proposed by Tenant within twenty-one (21) days of receiving Tenant's proposal and request for approval or (y) disapprove Tenant's proposal in writing with a detailed explanation of its objections within twenty-one (21) days of receiving Tenant's proposal and request for approval. If Tenant submits a proposal to Landlord and Landlord disapproves such proposal within the twenty-one (21) day time period, Tenant may submit another proposal with modifications thereto made in response to Landlord's objections and Landlord shall so approve or disapprove same within seven (7) days after submission of such modified proposal. If Landlord does not approve or disapprove any proposal or modified proposal in writing with a detailed explanation of its objections within the applicable seven (1) or twenty-one (21) day period, Tenant may submit to Landlord a reminder notice, which shall state that Landlord's failure to disapprove the applicable proposal within seven (7) days after receipt of such reminder notice shall be deemed to constitute Landlord's approval thereof. If Landlord does not disapprove such proposal or modified proposal in writing with a detailed explanation of Landlord's objections to Tenant's modifications within seven (7) days after receipt of Tenant's reminder notice, Landlord shall be deemed to have approved the Alterations proposed by Tenant.
Utility Installations Trade Fixtures Alterations 8.3.1 The term “Utility Installations” refers to all floor and window coverings, air and/or vacuum lines, power panels, electrical distribution, security and fire protection systems, communication cabling, lighting fixtures, HVAC equipment, plumbing, and fencing in or on the Premises. The term “
Permitted Alterations Tenant shall not make or permit any Alterations without the prior written consent of Landlord (which consent shall not be unreasonably withheld, conditioned or delayed). Notwithstanding the foregoing, in no event shall any Alterations (i) affect the exterior of the Building or the outside areas of the Property or the Building (or be visible from adjoining sites), (ii) affect or penetrate any of the structural portions of the Building, including, but not limited to, the roof, (iii) require any change to the basic floor plan of the Premises, any change to the structural or mechanical components of the Premises, or any governmental approval or permit as a prerequisite to the construction thereof, (iv) interfere in any manner with the proper functioning of or Landlord’s access to any mechanical, electrical, plumbing or HVAC systems, facilities or equipment located in or serving the Building, or (v) diminish the value of the Premises. All Alterations shall be constructed pursuant to plans and specifications previously provided to and, when applicable, approved in writing by Landlord, shall be installed by a licensed contractor at Tenant’s sole expense in compliance with all Applicable Laws, and shall be accomplished in a good and workmanlike manner conforming in quality and design with the Premises existing as of the Commencement Date and in accordance with the provisions of Section 22.1 below. No Hazardous Materials, including, but not limited to, asbestos or asbestos-containing materials, shall be used by Tenant or Tenant’s Agents in the construction or installation of any Alterations permitted hereunder. All Alterations made by Tenant shall be and become the property of Landlord upon the construction or installation thereof and shall not be deemed Tenant’s Personal Property; provided, however, that Landlord may, at its option and by notice delivered to Tenant at the time of Landlord’s approval, require that Tenant, upon the expiration or sooner termination of this Lease, at Tenant’s expense, remove any or all Alterations and return the Premises to its condition as of the Commencement Date, normal wear and tear excepted. Notwithstanding any other provisions of this Lease to the contrary, Tenant shall be solely responsible for the maintenance, repair and replacement of any and all Alterations made by or for the benefit of Tenant (including, without limitation, by Landlord for the benefit of Tenant). In addition, Tenant shall be responsible for the payment of any increase in Real Property Taxes that are attributable to any Alterations, which payment shall be made by Tenant to Landlord within ten (10) days following Landlord’s written demand therefor from time to time. Notwithstanding anything to the contrary in this Section 8.1, Tenant, without Landlord’s consent, may make minor Alterations to the Premises which do not affect the Building’s structure or operating systems and that do not cost more than $50,000.00 per project; provided however, Tenant shall provide notice no less than ten (10) business days’ notice of such Alterations.
Electrical During the Term of this Lease, there shall be available to the Leased Premises electrical facilities comparable to those supplied in other comparable office buildings in the vicinity of the Building to provide sufficient power for normal lighting and office machines of similar low electrical consumption, and one personal computer for each desk station, but not for any additional computers or extraordinary data processing equipment, special lighting and any other item of electrical equipment which requires a voltage other than one hundred ten (110) volts single phase and is not typically found in an office, as determined by Landlord in its sole, but reasonable discretion; and provided, however, that if the installation of such electrical equipment requires additional air conditioning capacity above that normally provided to tenants of the Building or above standard usage of existing capacity as determined by Landlord in its sole, but reasonable discretion, then the additional air conditioning installation and/or operating costs attributable thereto shall be paid by Tenant. Tenant agrees not to use any apparatus or device in, upon or about the Leased Premises which may in any way increase the amount of such electricity usually furnished or supplied to the Leased Premises, and Tenant further agrees not to connect any apparatus or device to the wires, conduits or pipes or other means by which such electricity is supplied, for the purpose of using additional or unusual amounts of electricity, without the prior written consent of Landlord. At all times, Tenant’s use of electric current shall never exceed Tenant’s share of the capacity of the feeders to the Building or the risers or wiring installation. Tenant shall not install or use or permit the installation or use in the Leased Premises of any computer or electronic data processing or ancillary equipment or any other electrical apparatus designed to operate on electrical current in excess of 110 volts and 5 amps per machine, without the prior written consent of Landlord, which consent shall not be unreasonably withheld, conditioned or delayed. If Tenant shall require electrical current in excess of that usually furnished or supplied for use of the Leased Premises as general office space, Tenant shall first procure the written consent of Landlord (which consent shall not be unreasonably withheld, conditioned or delayed) to the use thereof and Landlord or Tenant may (i) cause a meter to be installed in or for the Leased Premises, or (ii) if Tenant elects not to install said meter, Landlord may reasonably estimate such excess electrical current. The cost of any meters (including, without limitation, the cost of any installation) or surveys to estimate such excess electrical current shall be paid by Tenant. Landlord’s approval of any space plan, floor plan, construction plans, specifications, or other drawings or materials regarding the construction of the Tenant Improvements or any alterations shall not be deemed or construed as consent by Landlord under this paragraph to Tenant’s use of such excess electrical current as provided above. Tenant agrees to pay to Landlord, promptly upon demand therefor, all costs of such excess electrical current consumed as calculated by said meters (at the rates charged for such services to the Building by the municipality or the local public utility) or the excess amount specified in said estimate, as the case may be, plus any additional expense incurred in keeping account of the electrical current so consumed, which additional expense Landlord shall advise Tenant within a reasonable time after request by Tenant.
