Interpretation of Agreement It is understood that the parties hereto intend this Agreement to be interpreted and enforced so as to provide indemnification to Indemnitee to the fullest extent now or hereafter permitted by law.
Definitions Interpretation and Accounting Terms Defined Terms 1 Section 1.2 Computation of Time Periods 17 Section 1.3 Accounting Terms and Principles 18 Section 1.4 Conversion of Foreign Currencies 18 Section 1.5 Certain Terms 18
Interpretation of Contract In the event of a conflict or question involving the provisions of any part of this Contract, interpretation and clarification as necessary shall be determined by the County’s assigned buyer. If disagreement exists between the Contractor and the County’s assigned buyer in interpreting the provision(s), final interpretation and clarification shall be determined by the County’s Purchasing Agent or his designee.
Interpretation, etc Any of the terms defined herein may, unless the context otherwise requires, be used in the singular or the plural, depending on the reference. References herein to any Section, Appendix, Schedule or Exhibit shall be to a Section, an Appendix, a Schedule or an Exhibit, as the case may be, hereof unless otherwise specifically provided. The use herein of the word “include” or “including,” when following any general statement, term or matter, shall not be construed to limit such statement, term or matter to the specific items or matters set forth immediately following such word or to similar items or matters, whether or not no limiting language (such as “without limitation” or “but not limited to” or words of similar import) is used with reference thereto, but rather shall be deemed to refer to all other items or matters that fall within the broadest possible scope of such general statement, term or matter.
Interpretation of Contract Documents The Contract Documents shall be construed neither against nor in favor of either party, but shall be construed in a neutral manner.
Definitions Rules of Interpretation Section 1.01. Definitions The following capitalized terms as used in this FAA shall have the following meanings:
Interpretation; Governing Law This Agreement shall be subject to and interpreted in accordance with all applicable provisions of law including, but not limited to, the 1940 Act, and the rules and regulations promulgated under the 1940 Act. To the extent that the provisions of this Agreement conflict with any such applicable provisions of law, the latter shall control. The laws of the State of Minnesota shall otherwise govern the construction, validity and effect of this Agreement.
Interpretation; Absence of Presumption (a) It is understood and agreed that the specification of any dollar amount in the representations and warranties contained in this Agreement or the inclusion of any specific item in the Sellers Disclosure Letter is not intended to imply that such amounts or higher or lower amounts, or such items so included or other items, are or are not material, and no Party shall use the fact of the setting of any amount or the fact of the inclusion of any item in the Sellers Disclosure Letter in any dispute or controversy between the Parties as to whether any obligation, item or matter not described in this Agreement or included in the Sellers Disclosure Letter is or is not material for purposes of this Agreement. (b) For the purposes of this Agreement, (i) words in the singular shall be held to include the plural and vice versa, and words of one gender shall be held to include the other gender as the context requires; (ii) references to the terms Article, Section, paragraph, Exhibit and Schedule are references to the Articles, Sections, paragraphs, Exhibits and Schedules to this Agreement unless otherwise specified; (iii) the terms “hereof,” “herein,” “hereby,” “hereto,” and derivative or similar words refer to this entire Agreement, including the Schedules and Exhibits hereto; (iv) references to “$” or cash shall mean U.S. dollars; (v) the word “including” and words of similar import when used in this Agreement shall mean “including without limitation,” unless otherwise specified; (vi) the word “or” shall not be exclusive; (vii) references to “written” or “in writing” include in electronic form; (viii) provisions shall apply, when appropriate, to successive events and transactions; (ix) Sellers and Purchasers have each participated in the negotiation and drafting of this Agreement and if an ambiguity or question of interpretation should arise, this Agreement shall be construed as if drafted jointly by the Parties hereto and no presumption or burden of proof shall arise favoring or burdening any Party by virtue of the authorship of any of the provisions in this Agreement; (x) a reference to any Person includes such Person’s successors and permitted assigns; (xi) any reference to “days” shall mean calendar days unless Business Days are expressly specified; and (xii) when calculating the period of time before which, within which or following which any act is to be done or step taken pursuant to this Agreement, the date that is the reference date in calculating such period shall be excluded and if the last day of such period is not a Business Day, the period shall end at the close of business on the next succeeding Business Day. (c) If the Closing shall occur, notwithstanding anything in this Agreement to the contrary, any payment obligation of Purchasers hereunder shall be a joint and several obligation of Purchasers and the Transferred Entities.
Governing Law; Interpretation This Agreement shall be interpreted and enforced under the laws of the Commonwealth of Massachusetts, without regard to conflict of law principles. In the event of any dispute, this Agreement is intended by the parties to be construed as a whole, to be interpreted in accordance with its fair meaning, and not to be construed strictly for or against either you or the Company or the “drafter” of all or any portion of this Agreement.
Construction Phase - Administration of the Construction Contract INDICATE IN STATEMENT OF WORK “NOT APPLICABLE” IF SECTION IS NOT APPLICABLE 1.1.9.1. The Construction Phase will commence with the award of the Construction Contract to a selected vendor (“Contractor”) and will terminate when final payment is made by the State to the Contractor. In any event, the construction phase will not extend 60 days beyond the substantial completion date unless extended by change order. If such extension occurs, additional costs due to the ARCHITECT/ENGINEER shall be negotiated with the State. 1.1.9.2. The ARCHITECT/ENGINEER shall work with the State during the construction of the Project to provide the administration of the contract between the State and the Contractor in accordance with the terms herein and consistent with the contract between the State and the Contractor, and the extent of his/her duties and responsibilities and the limitations of his/her authority as assigned therein shall not be modified without his/her written consent. 1.1.9.3. The ARCHITECT/ENGINEER shall advise and consult with the State, and all of the State's instructions to the Contractor shall be issued through the ARCHITECT/ENGINEER after authorization by the State. 1.1.9.4. The ARCHITECT/ENGINEER shall, at all times, have access to the work wherever it is in preparation or progress. 1.1.9.5. The ARCHITECT/ENGINEER shall make periodic visits to the Project site, at least biweekly, and shall make such further visits when reasonably requested by the State, as to familiarize himself/herself with the progress and quality of the work performed and as to determine, on the basis of such visits, if such progress and quality are in accordance with the Contract Documents. The ARCHITECT/ENGINEER shall be responsible for project meeting minutes. In addition to this, the ARCHITECT/ENGINEER shall periodically report his/her findings thereon to the State, at such times as in the exercise of his/her professional judgment such findings are appropriate and at least monthly, at the conference provided for in Section 1.1.9.6, and further at such times as the State may reasonably request. The ARCHITECT/ENGINEER shall not be required to make exhaustive or continuous on-site inspections, except as required in the exercise of his/her professional judgment for said reports and, except in particular, to fulfill the commissioning requirements. The ARCHITECT/ENGINEER shall not be responsible for construction means, methods, techniques, sequences or procedures or for safety precautions and programs in connection with the work, and he/she shall not be responsible for the Contractor's failure to carry out the work in accordance with the Contract Documents except as provided for herein specifically between the State and the ARCHITECT/ENGINEER. 1.1.9.6. In preparing the bid documents, to the extent that the ARCHITECT/ENGINEER utilizes sub- consultants for their expertise, such as, but not limited to: Landscape Architects, Civil, Structural, Mechanical, and Electrical Engineers, these consultants, in effect, become an extension of the ARCHITECT/ENGINEER. Where the term ARCHITECT/ENGINEER is used in Section 1.1.9.2 as well as 1.1.9.5, it shall include those sub-consultants when work is being performed in their area of expertise. For example, the Mechanical Engineer would inspect the under slab plumbing before it is backfilled, but then wouldn’t necessarily be needed on site until the rest of the mechanical systems are being installed. The sub-consultant shall also be required to periodically inspect the progress of the “As-builts” and verify that they are up-to-date and verify such to the ARCHITECT/ENGINEER, before the ARCHITECT/ENGINEER issues the certificate of payment for that pay period. 1.1.9.7. Based upon his/her determinations and reports made under Section 1.1.9.5 of this Agreement and upon the Contractor's applications for payment, the ARCHITECT/ENGINEER shall once every month, after an on-site conference between the State, the Contractor and the ARCHITECT/ENGINEER, determine the amount then owing to the Contractor and shall then issue a certificate of payment for the amount agreed upon. The issuance of a Certificate for Payment shall constitute a representation by the ARCHITECT/ENGINEER to the State, based on such ARCHITECT/ENGINEER'S determination and report and the data supplied to him/her by the Contractor (without affecting his/her duties defined in Section 1.1.9.5.), that the work has progressed to the point indicated; that the quality of the work is in accordance with the Contract Documents (subject to the results of any specified subsequent tests required by the Contract Documents, to immaterial and insubstantial deviations from the Contract Documents, which will be corrected prior to completion, and to any further specific qualifications stated in the Certificate for Payment); and that the Contractor is entitled to such payment in the amount certified. Provided, however, the issuance of such certificate will not affect any obligations of the Contractor to the State. By issuing a certificate for payment, the ARCHITECT/ENGINEER shall not be deemed to represent that he/she has made any examination to ascertain how and for what purpose the Contractor has used the monies paid on account of the contract sum. ARCHITECT/ENGINEER shall not accept any part of the work on behalf of the State; ARCHITECT/ENGINEER may only recommend acceptance. Final acceptance is a right reserved solely to the State. 1.1.9.8. The ARCHITECT/ENGINEER shall be, in the first instance, the interpreter of the requirements of all Construction Documents, and shall have all requisite authority relating thereto for the purposes of authorizing the Contractor to proceed or stop with any component of the project after consultation and agreement with the State. The ARCHITECT/ENGINEER shall not be liable to the State for any loss or cost incurred by the State arising from delays in the construction schedule caused by any decision made by the ARCHITECT/ENGINEER in the reasonable exercise of professional judgment either to exercise or not to exercise his/her authority to stop the Work. 1.1.9.9. The ARCHITECT/ENGINEER shall review and respond to shop drawings, samples, and other submissions of the Contractor as in conformance with the design concept and information in the Contract Documents and the designs and plans relating to the project until approved or not requiring re-submission. The ARCHITECT/ENGINEER shall also review the submittal log at construction meetings and report to the State, on a monthly basis, their findings thereon. 1.1.9.10. The ARCHITECT/ENGINEER shall prepare all change orders and supporting data for the State's approval. 1.1.9.11. The ARCHITECT/ENGINEER shall conduct inspections to determine the Dates of Substantial Completion and Final Completion and shall receive written guarantees and related documents assembled by the Contractors and shall issue a final certificate of payment in accordance with Section 1.1.9.6. 1.1.9.12. The ARCHITECT/ENGINEER shall be responsible for system commissioning in accordance with the BGS Design Guidelines and as indicated in the BGS Commissioning Guidelines. Please see the BGS website xxxx://xxx.xxxxxxx.xxx/facilities/forms . The ARCHITECT/ENGINEER shall inspect, and document, each and every system to ensure that it complies with design intent, including but not limited to: system installation, system operation, and seasonal changeover. 1.1.9.13. Except in the manner specifically provided for herein, the ARCHITECT/ENGINEER shall not be responsible to the State for the acts or omissions of the Contractor or any of the Contractor’s agents or employees, or any other person not an employee or agent of the ARCHITECT/ENGINEER performing work on the Project. The ARCHITECT/ENGINEER shall be responsible for and shall pay the amount of any increase in the total Contract Price or the total Change Order(s) Price, which increase results from an error, inconsistency, or omission in the Contract Documents or instructions. 1.1.9.14. ARCHITECT/ENGINEER shall furnish to the State, a complete set of marked-up drawings and specifications showing all the changes to the Construction Documents made by Addenda, Change Orders, Shop Drawings, RFIs and other information received from the Clerk; and General Contractor’s As-built markups. The changes to the drawings are to be created on a separate layer in the DWG set and highlighted in a box, cloud or the like in the PDF set. The specifications are also to differentiate the changes made by highlighting in a box, cloud, etc. and be provided in Microsoft Word. These drawings and specifications shall be supplied within three (3) months of the date of Substantial Completion and before final payment. 1.1.9.15. Architect/Engineer (and design team members as required) shall conduct a one-year warranty inspection of the completed construction project between the eleventh and twelfth month from the date of substantial completion and shall issue a list of defective items needing correction to the Contractor.
