Inventory Measurement Procedures for Product Inventory
Inventory Measurement Procedures for Product Inventory Sample Clauses
Related to Inventory Measurement Procedures for Product Inventory
Computer Equipment Recycling Program If this Contract is for the purchase or lease of computer equipment, then Contractor certifies that it is in compliance with Subchapter Y, Chapter 361 of the Texas Health and Safety Code related to the Computer Equipment Recycling Program and the Texas Commission on Environmental Quality rules in 30 TAC Chapter 328.
Inventory To the extent Inventory held for sale or lease has been produced by any Borrower, it has been and will be produced by such Borrower in accordance with the Federal Fair Labor Standards Act of 1938, as amended, and all rules, regulations and orders thereunder.
Loss Leader; Recycled Products Contractor shall not sell or use any article or product as a “loss leader” as defined in Section 17030 of the Business and Professions Code. If Contractor will sell to the Judicial Council, or use in the performance of this Agreement, goods specified in PCC 12207 (for example, certain paper products, office supplies, mulch, glass products, lubricating oils, plastic products, paint, antifreeze, tires and tire-derived products, and metal products), then with respect to those goods: (i) Contractor shall use recycled products in the performance of this Agreement to the maximum extent doing so is economically feasible, and (ii) upon request, Contractor shall certify in writing under penalty of perjury, the minimum, if not exact, percentage of post consumer material as defined in the PCC 12200, in such goods regardless of whether the goods meet the requirements of PCC 12209.
Eligible Inventory For purposes of this Agreement, Eligible Inventory shall exclude any Inventory to which any of the exclusionary criteria set forth below applies. The Administrative Agent shall have the right to establish, modify or eliminate Reserves against Eligible Inventory from time to time in its reasonable credit judgment. In addition, the Administrative Agent reserves the right, at any time and from time to time after the Original Closing Date, to adjust any of the criteria set forth below, to establish new criteria and to adjust the applicable advance rate with respect to Eligible Inventory, in its reasonable credit judgment, subject to the approval of the Supermajority Lenders in the case of adjustments, new criteria, changes in the applicable advance rate or the elimination of Reserves which have the effect of making more credit available. Eligible Inventory shall not include any Inventory of Borrower or any Borrowing Base Guarantor that: (i) the Collateral Agent, on behalf of Secured Parties, does not have a first priority and exclusive perfected Lien on such Inventory; (ii) is not located on premises in United States or Canada; (iii) (A) is located on premises leased by Borrower or a Borrowing Base Guarantor, unless (x) at such location the aggregate value of Inventory exceeds $250,000, and (y) either (1) a reasonably satisfactory Landlord Lien Waiver and Access Agreement has been delivered to the Collateral Agent, or (2) Reserves reasonably satisfactory to the Administrative Agent have been established with respect thereto or (B) is stored with a bailee or warehouseman where the aggregate value of Inventory exceeds $250,000 unless either (x) a reasonably satisfactory, acknowledged bailee waiver letter has been received by the Collateral Agent or (y) Reserves reasonably satisfactory to the Administrative Agent have been established with respect thereto, or (C) is located at an owned location subject to a mortgage in favor of a lender other than the Collateral Agent where the aggregate value of Inventory exceeds $250,000 unless either (x) a reasonably satisfactory mortgagee waiver has been delivered to the Collateral Agent or (y) Reserves reasonably satisfactory to the Administrative Agent have been established with respect thereto; (iv) is placed on consignment (other than Eligible Consigned Inventory); (v) is covered by a negotiable document of title, unless such document has been delivered to the Collateral Agent with all necessary endorsements, free and clear of all Liens except those in favor of the Collateral Agent and the Lenders and landlords, carriers, bailees and warehousemen if clause (iii) above has been complied with; (vi) is to be returned to suppliers; (vii) is obsolete, unsalable, shopworn, seconds, damaged or unfit for sale; (viii) is slow moving (in excess of 1-year supply); (ix) consists of display items, samples or packing or shipping materials, manufacturing supplies or replacement parts (it being understood that Eligible Inventory shall not exclude work-in-process Inventory if it is not excluded in accordance with other criteria set forth herein, unless otherwise determined by the Administrative Agent in its reasonable credit judgment); (x) is not of a type held for sale in the ordinary course of Borrower’s or any Borrowing Base Guarantor’s, as applicable, business; (xi) breaches any of the representations or warranties pertaining to Inventory set forth in the Loan Documents; (xii) consists of Hazardous Material or goods that can be transported or sold only with licenses that are not readily available; (xiii) is not covered by casualty insurance maintained as required by Section 5.04; (xiv) consists of custom made Inventory which is not saleable to any other customer or in ordinary course; (xv) is in transit; or (xvi) is subject to any licensing arrangement the effect of which would be to limit the ability of Collateral Agent, or any Person selling the Inventory on behalf of Collateral Agent, to sell such Inventory in enforcement of the Collateral Agent’s Liens, without further consent or payment to the licensor or other.
SIGNIFICANT LANDS INVENTORY FINDING Find that this activity is consistent with the use classification designated by the Commission for the land pursuant to Public Resources Code section 6370 et seq.
Testing of Metering Equipment Connecting Transmission Owner shall inspect and test all of its Metering Equipment upon installation and at least once every two (2) years thereafter. If requested to do so by NYISO or Developer, Connecting Transmission Owner shall, at Developer’s expense, inspect or test Metering Equipment more frequently than every two (2) years. Connecting Transmission Owner shall give reasonable notice of the time when any inspection or test shall take place, and Developer and NYISO may have representatives present at the test or inspection. If at any time Metering Equipment is found to be inaccurate or defective, it shall be adjusted, repaired or replaced at Developer’s expense, in order to provide accurate metering, unless the inaccuracy or defect is due to Connecting Transmission Owner’s failure to maintain, then Connecting Transmission Owner shall pay. If Metering Equipment fails to register, or if the measurement made by Metering Equipment during a test varies by more than two percent from the measurement made by the standard meter used in the test, Connecting Transmission Owner shall adjust the measurements by correcting all measurements for the period during which Metering Equipment was in error by using Developer’s check meters, if installed. If no such check meters are installed or if the period cannot be reasonably ascertained, the adjustment shall be for the period immediately preceding the test of the Metering Equipment equal to one-half the time from the date of the last previous test of the Metering Equipment. The NYISO shall reserve the right to review all associated metering equipment installation on the Developer’s or Connecting Transmission Owner’s property at any time.
Accessories, Spare Parts and Tools Accessories, spare parts and tools dispatched with a piece of equipment, machine, apparatus or vehicle, which are part of the normal equipment and included in the price thereof or which are not separately invoiced, shall be regarded as one with the piece of equipment, machine, apparatus or vehicle in question.
Raw Materials A. Catalent shall procure Raw Materials only from vendors that are approved in writing by Palatin or otherwise qualified in accordance with the provisions of the Quality Agreement. Catalent shall be responsible for procuring Raw Materials as necessary to meet the Firm Commitment. Catalent shall not be liable for any delay in delivery of Product if (i) Catalent is unable to obtain, in a timely manner, a particular Raw Material necessary for Processing and (ii) Catalent placed orders for such Raw Materials promptly following receipt of Palatin’s Firm Commitment. In the event that any Raw Material becomes subject to purchase lead time beyond the Firm Commitment time frame, the parties will negotiate in good faith an appropriate amendment to this Agreement, including Clause 4.2. B. In certain instances, Palatin may require a specific supplier, manufacturer or vendor (“Vendor”) to be used for Raw Material. In such an event, (i) such Vendor will be identified in the Specifications and (ii) the Raw Materials from such Vendor shall be deemed Palatin-supplied Materials for purposes of this Agreement. If the cost of the Raw Material from any such Vendor (other than a Vendor specified in the Specifications as of the Effective Date) is greater than Catalent’s costs for the same raw material of equal quality from other vendors, Catalent shall add the difference between Catalent’s cost of the Raw Material and the Vendor’s cost of the Raw Material to the Unit Pricing. Palatin will be responsible for all reasonable, out-of-pocket costs incurred by Catalent associated with qualification of any such Vendor who has not been previously qualified by Catalent. C. In the event of (i) a Specification change for any reason, (ii) obsolescence of any Raw Material or (iii) termination or expiry of this Agreement, Palatin shall bear the cost of any unused Raw Materials (including packaging), so long as Catalent (a) purchased such Raw Materials in quantities consistent with Palatin’s then current Firm Commitment and any minimum purchase obligations required by the vendor and (b) used commercially reasonable efforts to mitigate such costs by using any such unused Raw Materials in the manufacture of other products.
Location of Equipment and Inventory All Equipment and Inventory are (i) located at the locations indicated on Schedule 4 (ii) in transit to such locations or (iii) in transit to a third party purchaser which will become obligated on a Receivable to the Debtor upon receipt. Except for Equipment and Inventory referred to in clauses (ii) and (iii) of the preceding sentence, the Debtor has exclusive possession and control of the Inventory and Equipment.
Accounts Receivable; Inventory (a) For each Account with respect to which Advances are requested, on the date each Advance is requested and made, such Account shall be an Eligible Account. (b) All statements made and all unpaid balances appearing in all invoices, instruments and other documents evidencing the Eligible Accounts are and shall be true and correct and all such invoices, instruments and other documents, and all of Borrower’s Books are genuine and in all respects what they purport to be. Whether or not an Event of Default has occurred and is continuing, Bank may notify any Account Debtor owing Borrower money of Bank’s security interest in such funds and verify the amount of such Eligible Account. All sales and other transactions underlying or giving rise to each Eligible Account shall comply in all material respects with all applicable laws and governmental rules and regulations. Borrower has no knowledge of any actual or imminent Insolvency Proceeding of any Account Debtor whose accounts are Eligible Accounts in any Transaction Report. To the best of Borrower’s knowledge, all signatures and endorsements on all documents, instruments, and agreements relating to all Eligible Accounts are genuine, and all such documents, instruments and agreements are legally enforceable in accordance with their terms. (c) For any item of Inventory consisting of Eligible Inventory in any Transaction Report, such Inventory (i) consists of finished goods, in good, new, and salable condition, which is not perishable, returned, consigned, obsolete, not sellable, damaged, or defective, and is not comprised of demonstrative or custom inventory, works in progress, packaging or shipping materials, or supplies; (ii) meets all applicable governmental standards; (iii) has been manufactured in compliance with the Fair Labor Standards Act; (iv) is not subject to any Liens, except the first priority Liens granted or in favor of Bank under this Agreement or any of the other Loan Documents; and (v) is located at the locations identified by Borrower in the Perfection Certificate where it maintains Inventory (or any location permitted under Section 7.2).
