Invoicing Arrangements and Fee Calculations
Invoicing Arrangements and Fee Calculations Sample Clauses
Related to Invoicing Arrangements and Fee Calculations
Payments and Invoicing Throughout the Delivery Term, Seller shall issue Payment Invoices and pay SCE in accordance with Exhibit E.
PAYMENT, INVOICING, AUDIT AND TAXES 4.1 All prices are exclusive of VAT or similar taxes and will be in the official currency of the country where the Accenture entity in the Agreement is located.
Fees and Invoicing The Consultant’s fee for tasks performed during the design phase and for all technical and administrative tasks during the construction and close-out phases, such as the review of Contractor submittals, preparation and distribution of minutes, on-site observation during construction, etc., will be a lump sum amount unless stated otherwise. The Consultant’s lump sum fee shall be further broken down by phase depending on the contract. In the event that any of the project phases or services are extended for reasons other than the fault of the Consultant, then the Consultant may submit an amendment for additional costs associated with the extension or additional services. Such costs shall be based on direct costs. The Consultant will not be entitled to an automatic extension of the monthly rate for that phase or any subsequent phase. Invoices for materials and labor expenses shall be submitted on an Invoice Form provided by the Owner, accompanied by appropriate backup as required by the Owner. Copies of all bills for reimbursables allowed by contract must be attached to the invoice form. Invoices during the design phase may be submitted monthly to the Owner or when work is completed, reviewed and accepted by the Owner. Invoices during the construction phase may also be submitted monthly. Completed invoices must identify the Owners project number for the project and location of the project. Invoices for all work performed shall be processed only after Owner review and acceptance of the work. Invoices will not be processed if work is found to be incomplete or unsatisfactory upon review by the Owner. The invoice, or portion of the invoice, will be held unprocessed until the Consultant makes the necessary corrections and the work is acceptable to Owner.
Payment and Invoicing 12.1. The Purchaser must pay all sums due to the Service Provider within 30 days of receipt of a valid invoice.
INVOICING REQUIREMENTS A. Upon acceptance of work by the Service Coordinator, the Contractor shall submit the invoice (and supporting documents where applicable) to the appropriate County department per the issued Delivery Order within thirty (30) calendar days of the acceptance. At minimum, all invoice shall contain the following information: • Correct Delivery Order number • Description of work performed to include the manufacturer name, original make and model number(s) of parts and equipment installed. • Start and ending date of the work • Location of the work • Total labor categorized per the Bid Response Form and rounded to the nearest (30) minutes • Itemized list of materials used according to the original manufacturer’s part name and part number. ▪ Unit price and quantity shall be provided on the invoice for each part • Applicable sales tax for materials purchased should be listed separately • Markdown/mark-ups for material shall be listed as a line item on the invoice. • Approved shipping charges shall be listed separately • Permit and special equipment rental cost for reimbursement (if applicable) • Invoice total
Payments and Fees Customer must pay the Fees according to the payment terms in the Sales Order in the currency stated. All invoices will only be delivered electronically using the billing and contact information provided by Customer. Customer agrees to provide clear indication with its payment as to which invoices (or portions thereof) the payment should be applied. Alternatively, these payment details can be emailed to Xxxxxxx@Xxxxxxx.xxx no later than the date of payment.
INVOICING AND PAYMENTS II.4.1 Pre-financing: Where required by Article I.5.1, the Contractor shall provide a financial guarantee in the form of a bank guarantee or equivalent supplied by a bank or an authorised financial institution (guarantor) equal to the amount indicated in the same Article to cover pre-financing under the Contract. Such guarantee may be replaced by a joint and several guarantee by a third party. The guarantor shall pay to the Agency at its request an amount corresponding to payments made by it to the Contractor which have not yet been covered by equivalent work on his part. The guarantor shall stand as first-call guarantor and shall not require the Agency to have recourse against the principal debtor (the Contractor). The guarantee shall specify that it enters into force at the latest on the date on which the Contractor receives the pre-financing. The Agency shall release the guarantor from its obligations as soon as the Contractor has demonstrated that any pre-financing has been covered by equivalent work. The guarantee shall be retained until the pre-financing has been deducted from interim payments or payment of the balance to the Contractor. It shall be released the following month. The cost of providing such guarantee shall be borne by the Contractor.
Detailed Invoicing Consultant agrees to provide City with a detailed invoice for services performed each month, within thirty (30) days of the end of the month in which the services were performed, unless otherwise specified in Exhibit A. Invoicing shall begin on the first of the month following the Effective Date of the Agreement. All charges must be presented in a line item format with each task separately explained in reasonable detail. Each invoice shall include the current monthly amount being billed, the amount invoiced to date, and the remaining amount available under any approved budget. Consultant must obtain prior written authorization from City for any fees or expenses that exceed the estimated budget.
Invoicing Except as may be prohibited by Applicable Laws, Supplier will implement an electronic invoicing process upon request by DXC and at Supplier’s sole expense, to submit invoices electronically to DXC or DXC’s third-party service provider in the electronic format specified by DXC or such third-party service provider. Supplier acknowledges and agrees that use of such process may entail disclosure of information to the service provider about the purchasing relationship between DXC and the Supplier, provided that such service provider is bound by DXC to confidentiality obligations as to Supplier’s information substantially similar to those provided under these terms. If Supplier fails to implement the electronic invoicing process within a reasonable time (not to exceed ninety (90) days) after DXC’s request, DXC may withhold payment on any invoice not received electronically until such time as Supplier submits the invoice electronically.
The OCN, From XXX, and Invoice Number will control the invoice sequencing The From XXX will be used to identify to <<customer_name>> which BellSouth XXX is sending the message. BellSouth and <<customer_name>> will use the invoice sequencing to control data exchange. BellSouth will be notified of sequence failures identified by <<customer_name>> and resend the data as appropriate. THE DATA WILL BE PACKED USING ATIS EMI RECORDS.
