Minimum Amounts and Maximum Number of Tranches All borrowings, prepayments, conversions and continuations of Loans hereunder and all selections of Interest Periods hereunder shall be in such amounts and be made pursuant to such elections so that, after giving effect thereto, the aggregate principal amount of the Loans comprising each Eurodollar Tranche shall be equal to $10,000,000 or a whole multiple of $1,000,000 in excess thereof. In no event shall there be more than five Eurodollar Tranches outstanding at any time.
Exchange Cap The Company shall not issue or sell any shares of Common Stock pursuant to this Agreement, and the Investor shall not purchase or acquire any shares of Common Stock pursuant to this Agreement, to the extent that after giving effect thereto, the aggregate number of shares of Common Stock that would be issued pursuant to this Agreement and the transactions contemplated hereby would exceed 18,780,646 shares of Common Stock (representing 19.99% of the voting power or number of shares of Common Stock issued and outstanding immediately prior to the execution of this Agreement), which number of shares shall be reduced, on a share-for-share basis, by the number of shares of Common Stock issued or issuable pursuant to any transaction or series of transactions that may be aggregated with the transactions contemplated by this Agreement under applicable rules of the Principal Market (such maximum number of shares, the “Exchange Cap”), unless the Company’s stockholders have approved the issuance of Common Stock pursuant to this Agreement in excess of the Exchange Cap in accordance with the applicable rules of the Principal Market. For the avoidance of doubt, the Company may, but shall be under no obligation to, request its stockholders to approve the issuance of Common Stock pursuant to this Agreement; provided, that if such stockholder approval is not obtained, the Exchange Cap shall be applicable for all purposes of this Agreement and the transactions contemplated hereby at all times during the term of this Agreement (except as set forth in Section 3.3(b)).
Optional Prepayments with Make-Whole Amount The Company may, at its option, upon notice as provided below, prepay at any time all, or from time to time any part of, the Notes, in an amount not less than 5% of the aggregate principal amount of the Notes then outstanding in the case of a partial prepayment, at 100% of the principal amount so prepaid, and the Make-Whole Amount determined for the prepayment date with respect to such principal amount. The Company will give each holder of Notes written notice of each optional prepayment under this Section 8.2 not less than 10 days and not more than 60 days prior to the date fixed for such prepayment unless the Company and the Required Holders agree to another time period pursuant to Section 17. Each such notice shall specify such date (which shall be a Business Day), the aggregate principal amount of the Notes to be prepaid on such date, the principal amount of each Note held by such holder to be prepaid (determined in accordance with Section 8.3), and the interest to be paid on the prepayment date with respect to such principal amount being prepaid, and shall be accompanied by a certificate of a Senior Financial Officer as to the estimated Make-Whole Amount due in connection with such prepayment (calculated as if the date of such notice were the date of the prepayment), setting forth the details of such computation. Two Business Days prior to such prepayment, the Company shall deliver to each holder of Notes a certificate of a Senior Financial Officer specifying the calculation of such Make-Whole Amount as of the specified prepayment date.
Warranty Limitation We do not warrant that the operation of Software will be uninterrupted or error free, or that Software will operate in hardware and Software combinations other than as expressly required by us in the Product specifications or that Software will meet your requirements.
Reallocation to a Class with a Lower Salary Range Maximum 1. If the employee meets the skills and abilities requirements of the position and chooses to remain in the reallocated position, the employee retains the existing appointment status and has the right to be placed on the Employer’s internal layoff list for the classification occupied prior to the reallocation.
2. If the employee chooses to vacate the position or does not meet the skills and abilities requirements of the position, the layoff procedure specified in Article 31 of this Agreement applies.
Warranty Limitations This Contractual Warranty does not warrant uninterrupted or error-free operation of the Product or cover normal wear and tear of the Product or costs related to the removal, installation, or troubleshooting of the customer's electrical systems. The warranty claims that relate to defects caused by any of the following factors are not covered by the Contractual Warranty: • Improper Use or Non-compliance with installation, commissioning, operation or maintenance instructions (i.e. not according to the operation & installation manual) • Unauthorized modifications, changes or attempted repairs, • Vandalism, destruction through external influence and/or persons/animals • Use in an unsuitable environment, including any environment or location that causes excessive wear and tear or dirt or dust or debris buildup within the system or that is difficult or unsafe for Xantrex LLC representatives to access • Insufficient ventilation • Installation in a corrosive environment • Failure to observe applicable safety standards & regulations • Damages during transportation or storage • Force majeure, examples include, but not limited to: fire, flood, earthquakes, storm damage, overvoltage & lightning strikes • Exposure to fire, water, snow, moisture, or liquid ingress (except for any such exposure to environmental conditions that your Product was specifically designed to withstand as indicated in the applicable specifications for your Product) • Used as a component part of a product expressly warranted by another manufacturer • If the original identification (trade-mark, serial number) markings have been defaced, altered, or removed • Consumable components of any type are not covered, including but not limited to fans, fuses and filters etc. • Cosmetic shortcoming which do not impair the use of the product for the intended purpose i.e. supply of energy Warranty claims also exclude: • Damages arising due to the fact that the use of the product for the intended purpose is no longer possible or only possible with restrictions as a result of amendments to the statutory provisions applicable to the operation of the product made after the delivery of the product • Compensation for damages related to loss of power production or business operation or any expenses incurred by customer towards repair & replacement of the product (including but not limited to labor, transportation, temporary power) • Cost arising from changes to existing PV systems or building installations or vehicle or marine vessel installation and like • Additional costs and expenses (i.e. shipping costs, travel, accommodation, meals, etc.) arising due to remote locations of the indicated geographies, including but not limited to islands and overseas territories
Damage Limitation IN NO EVENT SHALL THE COMPANY BE LIABLE TO THE SUBSCRIBER FOR ANY LOST PROFITS OR SPECIAL, CONSEQUENTIAL OR PUNITIVE DAMAGES, EVEN IF INFORMED OF THE POSSIBILITY OF SUCH DAMAGES. THE FOREGOING SHALL BE INTERPRETED AND HAVE EFFECT TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, RULE OR REGULATION.
Intent to Limit Charges to Maximum Lawful Rate In no event shall the interest rate or rates payable under this Agreement, plus any other amounts paid in connection herewith, exceed the highest rate permissible under any law that a court of competent jurisdiction shall, in a final determination, deem applicable. Borrower and the Lender Group, in executing and delivering this Agreement, intend legally to agree upon the rate or rates of interest and manner of payment stated within it; provided, however, that, anything contained herein to the contrary notwithstanding, if said rate or rates of interest or manner of payment exceeds the maximum allowable under applicable law, then, ipso facto, as of the date of this Agreement, Borrower is and shall be liable only for the payment of such maximum as allowed by law, and payment received from Borrower in excess of such legal maximum, whenever received, shall be applied to reduce the principal balance of the Obligations to the extent of such excess.
Minimum Excess Availability Borrower shall have Excess Availability under the Revolving Credit Loans facility of not less than the amount specified in the Schedule, after giving effect to the initial advance hereunder and after giving effect to any applicable Loan Reserves against borrowing availability under the Revolving Credit Loans.
Loss Limitation Losses allocated pursuant to Section 3.2 of this Agreement shall not exceed the maximum amount of Losses that can be allocated without causing any Unit Holder to have an Adjusted Capital Account Deficit at the end of any Fiscal Year. In the event some but not all of the Unit Holders would have Adjusted Capital Account Deficits as a consequence of an allocation of Losses pursuant to Section 3.2 of this Agreement, the limitation set forth in this Section 3.5 shall be applied on a Unit Holder by Unit Holder basis and Losses not allocable to any Unit Holder as a result of such limitation shall be allocated to the other Unit Holders in accordance with the positive balances in such Unit Holder’s Capital Accounts so as to allocate the maximum permissible Losses to each Unit Holder under Section 1.704-1(b)(2)(ii)(d) of the Regulations.
