Common use of Learning phase Clause in Contracts

Learning phase. 2.4.1. Drive the vehicle for a minimum of twenty minutes within the speed range in paragraph 1.4.2. to this annex, and with an average speed of eighty km/h (±10 km/h). It is allowed to be outside the speed range for a maximum cumulative time of two minutes during the learning phase. 2.4.2. At the discretion of the Technical Service, where the driving test is undertaken on a track (circle/oval) with only turns in a single direction, then the driving test in paragraph 2.4.1. above should be equally split (+/-2 minutes) in both directions. 2.4.3. Within the five minutes of completing the learning phase, measure the warm pressure of the tyre(s) to be deflated. The warm pressure shall be taken as the value Pwarm. This value will be used for subsequent operations.

Learning phase. 2.4.1. Drive the vehicle for a minimum of twenty minutes within the speed range in paragraph 1.4.2. to this annex, and with an average speed of eighty km/h (±10 10 km/h). It is allowed to be outside the speed range for a maximum cumulative time of two minutes during the learning phase. 2.4.2. At the discretion of the Technical Service, where the driving test is undertaken on a track (circle/oval) with only turns in a single direction, then the driving test in paragraph 2.4.1. above should be equally split (+/-2 minutes) in both directions. 2.4.3. Within the five minutes of completing the learning phase, measure the warm pressure of the tyre(s) to be deflated. The warm pressure shall be taken as the value Pwarm. This value will be used for subsequent operations.

Learning phase. 2.4.1. Drive the vehicle for a minimum of twenty 20 minutes within the speed range in paragraph 1.4.2. to this annexAnnex, and with an average speed of eighty 80 km/h (±10 +/-10 km/h). It is allowed to be outside the speed range for a maximum cumulative time of two 2 minutes during the learning phase. 2.4.2. At the discretion of the Technical Service, where the driving test is undertaken on a track (circle/oval) with only turns in a single direction, then the driving test in paragraph 2.4.1. 2.4.1 above should be equally split (+/-2 minutes) in both directions. 2.4.3. Within the five 5 minutes of completing the learning phase, measure the warm pressure of the tyre(s) to be deflated. The warm pressure shall be taken as the value Pwarm. This value will be used for subsequent operations. 2.5. Deflation phase. 2.5.1. Procedure for the puncture test to verify the requirements of paragraph 5.