Location Condition Sample Clauses

Location Condition. Advertiser shall be solely responsible for the condition and appearance of the premises during such Location Shoot, and hereby releases Publisher from any claims regarding the appearance or depiction of Advertiser’s business location in the Multimedia Advertising. Advertiser represents and warrants that it has and shall maintain the requisite insurance on its premises to cover any injuries caused by the condition of the premises during the Location Shoot.
AutoNDA by SimpleDocs

Related to Location Condition

  • Termination Conditions This Agreement terminates upon the earlier of any of the following events: 18.1. Podmínky ukončení platnosti smlouvy Platnost této smlouvy skončí, jakmile nastane kterákoliv z následujících událostí:

  • Room Condition The university agrees to provide and the resident agrees to maintain the assigned room and all public areas in and around the immediate building(s) accessible to the resident in a clean, safe and sanitary condition. Upon termination of this agreement, the student should leave the assigned room, its furnishings, and its equipment in as good an order and condition as the same were upon commencement of the student’s occupancy, ordinary wear and tear excepted. University staff will complete an inventory of furnishings and an assessment of damages; charges will be assessed to the responsible individual(s). Personal property left in a room following the termination of occupancy will be deemed abandoned. Students will be charged for the removal of such property.

  • Release Conditions As used in this Agreement, "Release Conditions" shall mean the following:

  • SUPERIOR CONDITIONS 21.01 All existing benefits, rights, privileges, practices, terms or conditions of employment which may be considered to be superior to those contained herein and which are set out in Appendix 4 are specifically retained by this Agreement unless otherwise agreed by the local parties. The parties agree to remove from Appendix 4 those superior conditions which no longer have application. Where the parties cannot agree on whether a superior condition continues to have application, the issue will be reduced to a grievance and referred to arbitration.

  • Property Condition Seller agrees to maintain the Property in its current condition, subject to ordinary wear and tear, from the time this Agreement comes into effect until the Closing. Buyer recognizes that the Seller, along with any licensed real estate agent(s) involved in this transaction, make no claims as to the validity of any property disclosure information. Buyer is required to perform their own inspections, tests, and investigations to verify any information provided by the Seller. Afterward, the Buyer shall submit copies of all tests and reports to the Seller at no cost.

  • PROJECT CONDITIONS A. The Grantee agrees to the following Project Conditions:

  • Test conditions 6.1.1. The test shall be performed on a flat, dry concrete or asphalt surface affording good adhesion.

  • Site Conditions A. Existing Site Conditions: Information with respect to the site of the Work given in drawings or specifications has been obtained by County's representatives and is believed to be reasonably correct, but the County does not warrant either the completeness or accuracy of such information, and it is the responsibility of the Contractor to verify all such information.

  • BASIC CONDITIONS The State shall have no obligation to disburse money for the Project under this Grant Agreement until the Grantee has satisfied the following conditions:

  • Space Conditions All pipes passing through floors, walls, and ceilings shall be installed with sufficient space between them to permit installation of pipe insulation and floor, wall, and ceiling plates without cutting of insulation or plates. Roughed-in dimensions shall be prepared by the Contractor to accomplish this requirement. The Contractor shall locate all equipment that must be serviced, operated, or maintained in fully accessible positions. This provision includes but is not limited to valves, traps, cleanouts, motors, controllers, switchgear, drain points, filter, access doors, and fire dampers. If spaces, dimensions, or other design conditions do not permit compliance with the present article, the Contractor shall file a request in writing with the Design Professional for additional instructions, furnishing a copy to the Owner.

Time is Money Join Law Insider Premium to draft better contracts faster.