Manufacturer’s Responsibility for Failed Batches Sample Clauses

Manufacturer’s Responsibility for Failed Batches. If Manufacturing Services in respect of a Batch of Supplied Product fail to yield Supplied Product deliverable by Manufacturer to Acorda in compliance with the Compliant Product Requirements and the failure is attributable to Manufacturer’s failure to provide the Manufacturing Services in respect of such Batch of Supplied Product in accordance with the terms of this Agreement (“Manufacturer Defective Manufacturing”), then Acorda will be entitled to [*****]. The Active Materials in such non-conforming Supplied Product as referenced in this Section 6.1 will be included in the “Quantity Convertedfor purposes of calculating the “Actual Annual Yield” under Section 2.7(a)(ii).
AutoNDA by SimpleDocs

Related to Manufacturer’s Responsibility for Failed Batches

  • Servicer's Responsibilities In addition to any other obligations set forth herein, upon acquisition of each REO, the Servicer shall be responsible for:

  • Specific Responsibilities In addition to its overall responsibility for monitoring and providing a forum to discuss and coordinate the Parties’ activities under this Agreement, the JSC shall in particular:

  • Customer Responsibilities (a) The Customer agrees to (i) promptly notify the Bank of any change that the Customer wishes to make to Exhibit B, (ii) promptly notify the Bank if any information contained in the Customer Information Sheet becomes inaccurate or untrue and (iii) indemnify the Bank for any losses resulting from the Customer's failure to adhere to the provisions of Subsection (a) of this Section 11.

  • No Responsibility for Title, etc So long as and to the extent that it is in the exercise of reasonable care, the Custodian shall not be responsible for the title, validity or genuineness of any property or evidence of title thereto received or delivered by it pursuant to this Agreement.

  • Contractor Responsibilities It shall be Tenant’s responsibility to cause each of Tenant’s contractors and subcontractors to:

  • ALPS’ Responsibilities In connection with its performance of TA Web, ALPS shall:

  • Responsibility for Subcustodians Except as provided in the last sentence of this Section 8.6, the Custodian shall be liable to the Fund for any loss or damage to the Fund caused by or resulting from the acts or omissions of any Subcustodian to the extent that such acts or omissions would be deemed to be negligence, gross negligence or willful misconduct in accordance with the terms of the relevant subcustodian agreement under the laws, circumstances and practices prevailing in the place where the act or omission occurred. The liability of the Custodian in respect of the countries and Subcustodians designated by the Custodian, from time to time on the Global Custody Network Listing shall be subject to the additional condition that the Custodian actually recovers such loss or damage from the Subcustodian.

  • Responsibility for Contract Administration The Servicer will have the sole obligation to manage, administer, service and make collections on the Contracts and perform or cause to be performed all contractual and customary undertakings of the holder of the Contracts to the Obligor. The Owner Trustee, at the written request of a Servicing Officer, shall furnish the Servicer with any powers of attorney or other documents necessary or appropriate in the opinion of the Owner Trustee to enable the Servicer to carry out its servicing and administrative duties hereunder. The Servicer is hereby appointed the servicer hereunder until such time as any Service Transfer may be effected under Article VIII.

  • Joint Responsibility If the Seller determines that the Interface Problem is attributable partially to the design of a Warranted Part and partially to the design of any Supplier Part, the Seller will, if so requested by the Buyer, seek a solution to the Interface Problem through cooperative efforts of the Seller and any Supplier involved. The Seller will promptly advise the Buyer of such corrective action as may be proposed by the Seller and any such Supplier. Such proposal will be consistent with any then existing obligations of the Seller hereunder and of any such Supplier towards the Buyer. Such corrective action, unless reasonably rejected by the Buyer, will constitute full satisfaction of any claim the Buyer may have against either the Seller or any such Supplier with respect to such Interface Problem.

  • Responsibility for documentation Neither the Agent nor the Arranger:

Time is Money Join Law Insider Premium to draft better contracts faster.