Margin of Safety Sample Clauses

Margin of Safety. The sprinkler system shall be hydraulically designed so that the total waterflow and pressure demand is at least 10% less than the available water flow and pressure at the site.
AutoNDA by SimpleDocs
Margin of Safety. An implicit MOS was included in TMDL development through application of a dynamic model for simulating daily loading over a wide range of hydrologic and environmental conditions, and through the use of conservative assumptions in model calibration and scenario development. In addition to this implicit margin of safety, a 5 percent explicit MOS was used to account for the differences between modeled and monitored data. Long-term water quality monitoring data were used for model calibration. While these data represented actual conditions, they were not continuous time series and may not have captured the full range of in-stream conditions that occurred during the simulation period. The explicit 5 percent MOS also accounts for those cases where monitoring data may not have captured the full range of in-stream conditions.

Related to Margin of Safety

  • Rectification of Safety Hazard 60.12 Where, because of the existence of a safety hazard, a site has been stopped for a defined period of time and Employees sent off site by agreement between Site Managers and any combination of Union Official/s, Health and Safety Committee, those people who remain on site to do rectification work will be paid at the rate of double time for all such work.

  • Margin Regulations Neither the making of any Loan hereunder nor the use of the proceeds thereof will violate the provisions of Regulation T, U or X of the Board.

  • COMPLIANCE WITH HEALTH, SAFETY, AND ENVIRONMENTAL REGULATIONS The Contractor, it’s Subcontractors, and their respective employees, shall comply fully with all applicable federal, state, and local health, safety, and environmental laws, ordinances, rules and regulations in the performance of the services, including but not limited to those promulgated by the City and by the Occupational Safety and Health Administration (OSHA). In case of conflict, the most stringent safety requirement shall govern. The Contractor shall indemnify and hold the City harmless from and against all claims, demands, suits, actions, judgments, fines, penalties and liability of every kind arising from the breach of the Contractor’s obligations under this paragraph.

  • General Regulations A. Excessively loud speakers and sound displays are not permitted, and BAC Productions shall have the right to reject any exhibit which does not, in its sole, and reasonable opinion, conform to the general tenor of the show.

  • COMPLIANCE WITH HEALTH & SAFETY CODE § 25249 7(f) Xxxxxxxx agrees to comply with the reporting requirements referenced in Health & Safety Code § 25249.7(f).

  • COMPLIANCE WITH HEALTH & SAFETY CODE SECTION 25249 7(f) Ecological agrees to comply with the reporting form requirements referenced in California Health & Safety Code § 25249.7(f).

  • Federal Reserve Regulations (a) None of Holdings, the Borrower or any of the Subsidiaries is engaged principally, or as one of its important activities, in the business of extending credit for the purpose of buying or carrying Margin Stock.

  • Compliance with Federal Law, Regulations, and Executive Orders This is an acknowledgement that FEMA financial assistance will be used to fund the contract only. The contractor will comply will all applicable federal law, regulations, executive orders, FEMA policies, procedures, and directives.

  • Compliance with Federal Regulations (1) Any contract entered pursuant to this solicitation shall contain the following provisions: All USDOT-required contractual provisions, as set forth in FTA Circular 4220.1F, are incorporated by reference. Anything to the contrary herein notwithstanding, FTA mandated terms shall control in the event of a conflict with other provisions contained in this Agreement. Contractor shall not perform any act, fail to perform any act, or refuse to comply with any grantee request that would cause the recipient to be in violation of FTA terms and conditions. Contractor shall comply with all applicable FTA regulations, policies, procedures and directives, including, without limitation, those listed directly or incorporated by reference in the Master Agreement between the recipient and FTA, as may be amended or promulgated from time to time during the term of this contract. Contractor’s failure to so comply shall constitute a material breach of this contract.

  • COMPLIANCE WITH NEW YORK STATE INFORMATION SECURITY BREACH AND NOTIFICATION ACT Contractor shall comply with the provisions of the New York State Information Security Breach and Notification Act (General Business Law Section 899-aa; State Technology Law Section 208).

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!