Marking of goods and/or services Sample Clauses

Marking of goods and/or services. The bidder shall if so required at his own expense mark or permit the Purchaser’s Representative to mark all the approved goods and/or services with a recognized DRR’s or Purchaser’s mark. The goods and/or services, which cannot be so marked, shall, if so required by the Purchaser’s Representative, be packed in suitable packages or cases each of which shall be sealed and marked with such mark.
Sample 1
AutoNDA by SimpleDocs

Related to Marking of goods and/or services

  • Emergency Standby for Goods and/or Services If any Federal or State official, having authority to do so, declares an emergency or the occurrence of a natural disaster within the State of Connecticut, DAS and the Client Agency may request the Goods and Services on an expedited and prioritized basis. Upon receipt of such a request the Contractor shall make all necessary and appropriate commercially reasonable efforts to reallocate its staffing and other resources in order to give primary preference to Performing this Contract ahead of or prior to fulfilling, in whole or in part, any other contractual obligations that the Contractor may have. The Contractor is not obligated to make those efforts to Perform on an expedited and prioritized basis in accordance with this paragraph if doing so will make the Contractor materially breach any other contractual obligations that the Contractor may have. Contractor shall acknowledge receipt of any request made pursuant to this paragraph within 2 hours from the time that the Contractor receives it via purchase order or through a request to make an expedited or prioritized purchase through the State of Connecticut Purchasing Card (MasterCard) Program (the “P-Card Program”). If the Contractor fails to acknowledge receipt within 2 hours, confirm its obligation to Perform or actually Perform, as set forth in the purchase order or through the P-Card Program, then DAS and the Client Agency may procure the Performance from another source without further notice to Contractor and without creating any right of recourse at law or in equity against DAS or Client Agency.

  • Procurement of Goods and Services (a) If the HSP is subject to the procurement provisions of the BPSAA, the HSP will abide by all directives and guidelines issued by the Management Board of Cabinet that are applicable to the HSP pursuant to the BPSAA. (b) If the HSP is not subject to the procurement provisions of the BPSAA, the HSP will have a procurement policy in place that requires the acquisition of supplies, equipment or services valued at over $25,000 through a competitive process that ensures the best value for funds expended. If the HSP acquires supplies, equipment or services with the Funding it will do so through a process that is consistent with this policy.

  • Inspection of Goods 8.1 The Buyer shall inspect the goods upon delivery. 8.2 Where goods are damaged the Buyer shall notify the Supplier. The Buyer may reject the damaged goods and the following provisions shall apply: 8.2.1 the Supplier shall collect the damaged goods from the Buyer at the Supplier’s expense; 8.2.2 during the period between delivery of the goods to the Buyer and collection by the Supplier, the Buyer shall not be liable for any loss or further damage caused to the damaged goods; 8.2.3 all sums payable by the Buyer in relation to the damaged goods shall cease to become payable; 8.2.4 all sums paid by the Buyer in relation to the damaged goods shall be repaid by the Supplier immediately; 8.2.5 the Buyer shall be entitled to claim damages from the Supplier for any losses caused to the Buyer as a result of the goods being damaged. 8.3 Where there are shortages in the order the Buyer shall notify the Supplier and the following provisions shall apply: 8.3.1 all sums payable by the Buyer in relation to the missing goods shall cease to become payable; 8.3.2 all sums paid by the Buyer in relation to the missing goods shall be repaid by the Supplier immediately; 8.3.3 the Buyer shall be entitled to claim damages from the Supplier for any losses caused to the Buyer as a result of the shortages. 8.4 If the Buyer so requests, the Supplier shall immediately replace damaged goods or supply goods which are missing at the Supplier’s expense or the Buyer shall be entitled to cancel, without notice, the whole or any unexecuted part of the order and the rights referred to in Clause 5.2 shall apply. 8.5 Where there is an excess of goods in relation to the order the Buyer may reject the excess goods by notice in writing to the Supplier and the following provisions shall apply: 8.5.1 the Supplier shall collect the excess goods from the Buyer at the Supplier’s expense; 8.5.2 during the period between delivery of the goods and collection by the Supplier, the Buyer shall not be liable for any loss or damage caused to the excess goods; 8.5.3 no sum shall be due to the Supplier for the excess goods and in the event that sums are paid to the Supplier for the excess goods, the Supplier shall repay such sums to the Buyer immediately. 8.6 The Buyer may accept excess goods by notifying the Supplier of such acceptance and the price of the excess goods shall be payable by the Buyer. 8.7 The Supplier shall repair or replace free of charge, goods damaged or lost in transit upon receiving notice to that effect from the Buyer. 8.8 The Buyer’s signature on any delivery note of the Supplier is evidence of the number of packages received only and not evidence of the correct quantity of goods received or that the goods are in a good condition or of the correct quality.

  • Procurement of Goods and Works Except as ADB may otherwise agree, Goods and Works shall only be procured on the basis of the methods of procurement set forth below:

  • Goods and Services 4.3.1. The Supplier shall ensure that the Goods and/or the Services provided are fit for the purposes that may reasonably be inferred from the technical specifications and in accordance with the timetable for performance defined in the Contract. In any event the Supplier commits himself to achieve performance and results stipulated in the Contract. 4.3.2. The Goods and/or Services shall be delivered in a state of full completion with the complete “Documentation” (any operation and maintenance manuals, drawings, calculations, technical data, logic diagrams, progress reports, quality documentation, conformity certificates, test reports, bill of lading, certificates of origin, export control classification list number as per any applicable export regulation - such as the European Council Regulation 428/2009 (as amended) and/or the U.S. Export Administration Regulations (“EAR”), percentage of U.S. origin content, U.S. Export Control Classification Number (“ECCN”) or U.S. Munitions List category (“USML”) (if applicable) export authorizations and licenses, Harmonized Tariff Code - and any such other documents required under the Contract and/or applicable Laws) associated therewith as well as all instructions, recommendationsandother indicationsnecessaryin orderfor themtobeused correctly and under the appropriate safety conditions. If so required by the Purchaser, the Supplier shall submit any such Documentation to the Purchaserwith sufficient timeforreview andapproval by the Customer, in accordancewith the time-lines agreed between the Purchaser and the Customer. Where the Documentation provided by the Supplier is not compliant with Purchaser’s contractual requirements, the Supplier must make the necessary modifications, and indemnify the Purchaser for any costs, liabilities or penalties incurred by the Purchaser as a result of the non-compliance and/or delay. 4.3.3. Goods or Services that donotmeetall the requirements set in this Article 4.3 shall be considered as having a Non-Conformity as per Article 10 of these General Conditions and may be recorded as a non-conformity event (NCE) as defined in the Supplier Quality Manual. 4.3.4. If the Supplier is not certain that the results of the Services or Goods comply with the requirements defined in this Article 4.3, it shall inform immediately the Purchaser thereof in writing, providing all the needed indications concerning the risks of non- compliance and the measures that the Supplier intends to take in order to remedy the situation. The Purchaser shall notify its acceptance or rejection of the Supplier’s proposals as soon as possible and in writing. 4.3.5. If the Purchaser assesses on its part that the Supplier is not performing the Services and/or supplying the Goods in accordance with the Contract, itmay require the Supplier to indicate to it, in writing, the measures that the Supplier intends to take to remedy the situation. The Purchaser shall notify the Supplier in writing as soon as possible of its acceptance or rejection of the Supplier’s proposals.

  • Identification of Goods Identification of the goods shall not be deemed to have been made until both Buyer and Seller have agreed that the goods in question are to be appropriate to the performance of this Agreement.

  • Supply of Goods 6.1 In consideration of UKRI’s agreement to pay the Charges, the Supplier shall supply all Goods in accordance with the Agreement and any Contract. In particular, the Supplier warrants that the Goods shall: (a) conform with their description in the specifications (including the Specification), drawings, descriptions given in quotations, estimates, brochures, sales, marketing and technical literature or material (in whatever format made available by the Supplier) supplied by, or on behalf of, the Supplier; (b) be of satisfactory quality (within the meaning of the Sale of Goods Act 1979) and fit for any purpose held out by the Supplier or made known to the Supplier by UKRI, expressly or by implication, and in this respect UKRI relies on the Supplier's skill and judgement. The Supplier acknowledges and agrees that the approval by UKRI shall not relieve the Supplier of any of its obligations under this sub-clause; (c) where applicable, be free from defects (manifest or latent), in materials and workmanship and remain so for 12 months after Delivery; (d) be free from design defects; (e) comply with all applicable statutory and regulatory requirements relating to the manufacture, labelling, packaging, storage, handling and delivery of the Goods; (f) be supplied in accordance with all applicable legislation in force from time to time; and (g) be destined for supply into, and fully compliant for use in, the United Kingdom (unless specifically stated otherwise in the Specification). 6.2 In supplying the Goods, the Supplier shall co-operate with UKRI in all matters relating to the supply of the Goods and comply with all of UKRI’s instructions. 6.3 The Supplier shall ensure that at all times it has and maintains all the licences, permissions, authorisations, consents and permits that it needs to carry out its obligations under the Agreement. 6.4 UKRI and its representatives shall have the right to inspect and test the Goods at any time before Delivery. 6.5 If following such inspection or testing UKRI considers that the Goods do not conform or are unlikely to comply with the Supplier's undertakings at clause 6.1, UKRI shall inform the Supplier and the Supplier shall immediately take such remedial action as is necessary to ensure compliance. 6.6 Notwithstanding any such inspection or testing, the Supplier shall remain fully responsible for the Goods and any such inspection or testing shall not reduce or otherwise affect the Supplier's obligations under this Agreement, and UKRI shall have the right to conduct further inspections and tests after the Supplier has carried out its remedial actions. 6.7 UKRI’s rights under the Agreement are without prejudice to and in addition to the statutory terms implied in favour of UKRI under the Sale of Goods Act 1979, the Supply of Goods and Services Act 1982 and any other applicable legislation as amended.

  • Procurement of Goods Part A: General Goods shall be procured in accordance with the provisions of Section I of the "Guidelines for Procurement under IBRD Loans and XXX Credits" published by the Bank in January 1995 and revised in January 1996 (the Guidelines) and the following provisions of this Section, as applicable. Part B: International Competitive Bidding

  • REJECTION OF GOODS Notwithstanding any other rights of, or remedies available to UNDP under the Contract, in case any of the Goods are defective or otherwise do not conform to the specifications or other requirements of the Contract, UNDP, at its sole option, may reject or refuse to accept the Goods, and within thirty (30) days following receipt of notice from UNDP of such rejection or refusal to accept the Goods, the Contractor shall, in sole option of UNDP: 11.7.1 provide a full refund upon return of the Goods, or a partial refund upon a return of a portion of the Goods, by UNDP; or, 11.7.2 repair the Goods in a manner that would enable the Goods to conform to the specifications or other requirements of the Contract; or, 11.7.3 replace the Goods with Goods of equal or better quality; and, 11.7.4 pay all costs relating to the repair or return of the defective Goods as well as the costs relating to the storage of any such defective Goods and for the delivery of any replacement Goods to UNDP.

  • Classification of Goods The classification of goods in trade between the Parties shall be in conformity with the Harmonized System.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!