Maximum Ovality of Pipe Sample Clauses

Maximum Ovality of Pipe. The outside diameter of pipes, tolerance on the same and ovality of pipe shall be as given in Table 2 of IS 4984. Ovality shall be measured as the difference between maximum outside diameter and minimum outside diameter measured at the same cross section of the pipe, at 300 mm away from the cut end. For pipes to be coiled the ovality shall be measured prior to coiling. For coiled pipes, however, re-rounding of pipes shall be carried out prior to the measurement of ovality.
AutoNDA by SimpleDocs

Related to Maximum Ovality of Pipe

  • TOTALITY OF AGREEMENT The County and the Federation recognize and agree that the provisions contained herein represent the totality of the agreement between the parties. It is understood and agreed, however, that the parties may by voluntary mutual consent, modify or add to this Agreement at any time during its term.

  • Quality of Life Improving the quality of life for Americans and others throughout the world.

  • Originality of Services Except as to standard generic details, Consultant agrees that all technologies, formulae, procedures, processes, methods, writings, ideas, dialogue, compositions, recordings, teleplays and video productions prepared for, written for, or submitted to the District and/or used in connection with this Agreement, shall be wholly original to Consultant and shall not be copied in whole or in part from any other source, except that submitted to Consultant by District as a basis for such services.

  • Survivability of Orders In the event the term of any order or Professional/Technical Services work order (“Order”) placed under this Contract extends past the termination or expiration of this Contract, the terms and conditions of this Contract shall remain in full force and effect as it applies to such order and will continue in effect for such order until the term of that order expires or the order is cancelled or terminated in accordance with the terms of this Contract.

  • Quality of Services (a) The Consultant shall be responsible for the professional quality, technical accuracy, and the coordination of all designs, drawings, specifications, and other services furnished pursuant to this Agreement.

  • Finality of Decisions There shall be no appeal from any Arbitration Board's decision. Each such decision shall be final and binding on the Union and its members, the employee or employees involved, and the Company. The Union will discourage any attempt of its members, and will not encourage or co-operate with any of its members in any appeal to any Court or Labour Board from a decision of an Arbitration Board.

  • Equality of Treatment Unless otherwise provided in this Agreement, the persons specified in Article 3, who ordinarily reside in the territory of a Contracting State, shall receive equal treatment with nationals of that Contracting State in the application of the legislation of that Contracting State.

  • Finality of Disputes 13.1.1 Except as otherwise specifically provided for in this Agreement, no claim may be brought for any dispute arising from this Agreement more than twelve (12) months from the date the occurrence which gives rise to the dispute is discovered or reasonably should have been discovered with the exercise of due care and attention.

  • Finality of Decision The review by an ALJ or DAB provided for above shall not be considered to be an appeal right arising under any statutes or regulations. Consequently, the parties to this CIA agree that the DAB’s decision (or the ALJ’s decision if not appealed) shall be considered final for all purposes under this CIA.

  • Quality of Service Contractor shall perform its services with care, skill, and diligence, in accordance with the applicable professional standards currently recognized by such profession, and shall be responsible for the professional quality, technical accuracy, completeness, and coordination of all reports, designs, drawings, plans, information, specifications, and/or other items and services furnished under this Agreement. Contractor shall, without additional compensation, correct or revise any errors or deficiencies immediately upon discovery in its reports, drawings, specifications, designs, and/or other related items or services.

Time is Money Join Law Insider Premium to draft better contracts faster.