Price Reduction Notwithstanding any other provision set forth in this Warrant, at any time and from time to time during the period that this Warrant is exercisable, the Company in its sole discretion may reduce the Purchase Price or extend the period during which this Warrant is exercisable.
Economic Price Adjustment is the adjustment to the Aircraft Basic Price (Base Airframe, Engine and Special Features) as calculated pursuant to Exhibit D.
Reduction in Purchase Price Anything in this Section 11 to the contrary notwithstanding, the Company shall be entitled to make such reductions in the Purchase Price, in addition to those adjustments expressly required by this Section 11, as and to the extent that it in its sole discretion shall determine to be advisable in order that any consolidation or subdivision of the Preferred Shares, issuance wholly for cash of any of the Preferred Shares at less than the current market price, issuance wholly for cash of Preferred Shares or securities which by their terms are convertible into or exchangeable for Preferred Shares, dividends on Preferred Shares payable in Preferred Shares or issuance of rights, options or warrants referred to hereinabove in this Section 11, hereafter made by the Company to holders of its Preferred Shares shall not be taxable to such stockholders.
Non pre-priced Adjustment Factor To be applied to Work determined not to be included in the CTC but within the general scope of the work: 1.1500.
Average Log Length and Payment Reduction If the average log length for all logs delivered under this contract is less than the average log length specified in the table in clause G-024.2, The amount of allowable payment reduction shall be calculated by multiplying the payment rate in P-028.2 by the total volume delivered, and the difference between the average length of logs delivered and the average log length specified in G-024.2, times 1% as follows: Log Length Payment Reduction = (B x V x L) x (.01) Where: B = Bid rate from P-028.2 clause V = total delivered log Volume L = Length in feet below specified average (rounded to nearest Average log length payment reductions calculated by the Purchaser must be approved by the State, prior to payment for the final billing period. Third-party scaling organization information is required to determine ▇▇▇▇▇▇▇▇ mbf and Average log length for payment reduction purposes. Average log length is determined on a piece count basis. Value of log length price reduction will be derived from the applicable sort value as described in this contract. Scale information for determining Average log length for payment reduction eligibility must be obtained from roll-out scale. Truck-ramp, sample scaling, and/or bundle scaling information is not acceptable for determining eligibility. Purchaser’s exclusive remedy for below average log lengths shall be the payment reduction described in this clause, notwithstanding other provisions in the Uniform Commercial Code.