ATTACHMENT C STANDARD STATE PROVISIONS FOR CONTRACTS AND GRANTS
Protocol No action to coerce or censor or penalize any negotiation participant shall be made or implied by any other member as a result of participation in the negotiation process.
Stop Work Order (a) NYSERDA may at any time, by written Order to the Contractor, require the Contractor to stop all or any part of the Work called for by this Agreement for a period of up to ninety (90) days after the Stop Work Order is delivered to the Contractor, and for any further period to which the parties may agree. Any such order shall be specifically identified as a Stop Work Order issued pursuant to this Section. Upon receipt of such an Order, the Contractor shall forthwith comply with its terms and take all reasonable steps to minimize the incurrence of costs allocable to the Work covered by the Order during the period of work stoppage consistent with public health and safety. Within a period of ninety (90) days after a Stop Work Order is delivered to the Contractor, or within any extension of that period to which the parties shall have agreed, NYSERDA shall either: (i) by written notice to the Contractor, cancel the Stop Work Order, which shall be effective as provided in such cancellation notice, or if not specified therein, upon receipt by the Contractor, or (ii) terminate the Work covered by such order as provided in the Termination Section of this Agreement. (b) If a Stop Work Order issued under this Section is cancelled or the period of the Order or any extension thereof expires, the Contractor shall resume Work. An equitable adjustment shall be made in the delivery schedule, the estimated cost, the fee, if any, or a combination thereof, and in any other provisions of the Agreement that may be affected, and the Agreement shall be modified in writing accordingly, if: (i) the Stop Work Order results in an increase in the time required for, or in the Contractor’s cost properly allocable to, the performance of any part of this Agreement, and (ii) the Contractor asserts a claim for such adjustments within 30 days after the end of the period of Work stoppage; provided that, if NYSERDA decides the facts justify such action, NYSERDA may receive and act upon any such claim asserted at any time prior to final payment under this Agreement. (c) If a Stop Work Order is not cancelled and the Work covered by such Order is terminated, the reasonable costs resulting from the Stop Work Order shall be allowed by equitable adjustment or otherwise. (d) Notwithstanding the provisions of this Section 12.01, the maximum amount payable by NYSERDA to the Contractor pursuant to this Section 12.01 shall not be increased or deemed to be increased except by specific written amendment hereto.
Attachment E Data Use Agreement-TACCHO Version Attachment F – Federal Assurances-v1.1 Attachment G – Certification Regarding Lobbying Attachment H – FFATA Certification Form
MSAA Indicator Technical Specification Document This Agreement shall be interpreted with reference to the MSAA Indicator Technical Specifications document.
Escrow Format Specification Deposit’s Format. Registry objects, such as domains, contacts, name servers, registrars, etc. will be compiled into a file constructed as described in draft-xxxxx-xxxxxxx-registry-data-escrow, see Part A, Section 9, reference 1 of this Specification and draft-xxxxx-xxxxxxx-dnrd-objects-mapping, see Part A, Section 9, reference 2 of this Specification (collectively, the “DNDE Specification”). The DNDE Specification describes some elements as optional; Registry Operator will include those elements in the Deposits if they are available. If not already an RFC, Registry Operator will use the most recent draft version of the DNDE Specification available at the Effective Date. Registry Operator may at its election use newer versions of the DNDE Specification after the Effective Date. Once the DNDE Specification is published as an RFC, Registry Operator will implement that version of the DNDE Specification, no later than one hundred eighty (180) calendar days after. UTF-8 character encoding will be used.
Quality Agreement Concurrently with execution of this Agreement, the Parties will enter into an agreement that details the quality assurance obligations of each Party with respect to the Manufacture and supply of Supplied Products under this Agreement (the “Quality Agreement”). Each Party shall perform its obligations under the Quality Agreement in accordance with the terms and conditions thereof. In the event of a conflict between the terms of the Quality Agreement and the terms of this Agreement, the provisions of the Quality Agreement shall govern.
Software License Terms (a) Software that is made available by a Provider to Recipient in connection with any Service (any such Software being referred to herein as “TSA-Licensed Software”) provided hereunder will be subject to the terms set forth in this Section 3.5 except as otherwise provided in the applicable Service Schedule. The Provider hereby grants to the Recipient a non-exclusive, non-transferable license to use, in object code form, any TSA-Licensed Software that is made available by the Provider pursuant to a Service Schedule. For the avoidance of doubt, the Provider that makes available any TSA-Licensed Software in connection with the provision of any Service retains the unrestricted right to enhance or otherwise modify such TSA-Licensed Software at any time, provided that such enhancements or other modifications do not disrupt the provision of such Service to the Recipient. (b) The Recipient may not exceed the number of licenses, agents, tiers, nodes, seats, or other use restrictions or authorizations, if any, specified in the applicable Service Schedule. Some TSA-Licensed Software may require license keys or contain other technical protection measures. The Recipient acknowledges that the Provider may monitor the Recipient’s compliance with use restrictions and authorizations remotely, or otherwise. If the Provider makes a license management program available which records and reports license usage information, the Recipient agrees to appropriately install, configure and execute such license management program. (c) Unless otherwise permitted by the Provider, the Recipient may only make copies or adaptations of the TSA-Licensed Software for archival purposes or when copying or adaptation is an essential step in the authorized use of TSA-Licensed Software. If the Recipient makes a copy for backup purposes and installs such copy on a backup device, the Recipient may not operate such backup installation of the TSA-Licensed Software without paying an additional license fee, except in cases where the original device becomes inoperable. If a copy is activated on a backup device in response to failure of the original device, the use on the backup device must be discontinued when the original or replacement device becomes operable. The Recipient may not copy the TSA-Licensed Software onto or otherwise use or make it available on, to, or through any public or external distributed network. Licenses that allow use over the Recipient’s intranet require restricted access by authorized users only. (d) The Recipient must reproduce all copyright notices that appear in or on the TSA-Licensed Software (including documentation) on all permitted copies or adaptations. Copies of documentation are limited to internal use. (e) Notwithstanding anything to the contrary herein, certain TSA-Licensed Software may be licensed under the applicable Service Schedule for use only on a computer system owned, controlled, or operated by or solely on behalf of the Recipient and may be further identified by the Provider by the combination of a unique number and a specific system type (“Designated System”) and such license will terminate in the event of a change in either the system number or system type, an unauthorized relocation, or if the Designated System ceases to be within the possession or control of the Recipient. (f) The Recipient will not modify, reverse engineer, disassemble, decrypt, decompile, or make derivative works of the TSA-Licensed Software. Where the Recipient has other rights mandated under statute, the Recipient will provide the Provider with reasonably detailed information regarding any intended modifications, reverse engineering, disassembly, decryption, or decompilation and the purposes therefor. (g) The Recipient may permit a consultant or subcontractor to use TSA-Licensed Software at the licensed location for the sole purpose of providing services to the Recipient. (h) Upon expiration or termination of the Service Schedule under which TSA-Licensed Software is made available, the Recipient will destroy the TSA-Licensed Software. The Recipient will remove and destroy or return to the Provider any copies of the TSA-Licensed Software that are merged into adaptations, except for individual pieces of data in the Recipient’s database. The Recipient will provide certification of the destruction of TSA-Licensed Software, and copies thereof, to the Provider. The Recipient may retain one copy of the TSA-Licensed Software subsequent to expiration or termination solely for archival purposes. (i) The Recipient may not sublicense, assign, transfer, rent, or lease the TSA-Licensed Software to any other person except as permitted in this Section 3.5. (j) The Recipient agrees that the Provider may engage a third party designated by the Provider and approved by the Recipient (such approval not to be unreasonably withheld) to audit the Recipient’s compliance with the Software License terms. Any such audit will be at the Provider’s expense, require reasonable notice, and will be performed during normal business hours. Such third party will be required to execute a non-disclosure agreement that restricts such third party from disclosing confidential information of the Recipient to the Provider, except to the extent required to report on the extent to which the Recipient is not in compliance with the Software License terms.
Statement of Work The Statement of Work to which Grantee is bound is incorporated into and made a part of this Grant Agreement for all purposes and included as Attachment A.
Proposed Policies and Procedures Regarding New Online Content and Functionality By October 31, 2017, the School will submit to OCR for its review and approval proposed policies and procedures (“the Plan for New Content”) to ensure that all new, newly-added, or modified online content and functionality will be accessible to people with disabilities as measured by conformance to the Benchmarks for Measuring Accessibility set forth above, except where doing so would impose a fundamental alteration or undue burden. a) When fundamental alteration or undue burden defenses apply, the Plan for New Content will require the School to provide equally effective alternative access. The Plan for New Content will require the School, in providing equally effective alternate access, to take any actions that do not result in a fundamental alteration or undue financial and administrative burdens, but nevertheless ensure that, to the maximum extent possible, individuals with disabilities receive the same benefits or services as their nondisabled peers. To provide equally effective alternate access, alternates are not required to produce the identical result or level of achievement for persons with and without disabilities, but must afford persons with disabilities equal opportunity to obtain the same result, to gain the same benefit, or to reach the same level of achievement, in the most integrated setting appropriate to the person’s needs. b) The Plan for New Content must include sufficient quality assurance procedures, backed by adequate personnel and financial resources, for full implementation. This provision also applies to the School’s online content and functionality developed by, maintained by, or offered through a third-party vendor or by using open sources. c) Within thirty (30) days of receiving OCR’s approval of the Plan for New Content, the School will officially adopt, and fully implement the amended policies and procedures.
