Minimum Standards (a) It is intended that the provisions contained in the Employment Standards Act and Regulations (Act), presently in effect and from time to time amended, are minimum requirements only. (b) In the event this collective agreement does not contain a provision which is contained in the Act such provision shall be deemed to be incorporated in the collective agreement as part of its terms. (c) In the event this collective agreement contains a provision which is a lesser requirement than a similar or related provision contained in the Act, then the provision contained in the Act shall prevail, and shall be deemed to be incorporated in the collective agreement as part of its terms. (d) In the event a dispute arises respecting the application or interpretation of any provision of the Act which is deemed to be part of the terms of this collective agreement, the Grievance Procedure contained in this collective agreement, including Arbitration if necessary, shall apply for resolution of the dispute.
Quality Standards Each Party agrees that the nature and quality of its products and services supplied in connection with the other Party's Marks will conform to quality standards set by the other Party. Each Party agrees to supply the other Party, upon request, with a reasonable number of samples of any Materials publicly disseminated by such Party which utilize the other Party's Marks. Each Party will comply with all applicable laws, regulations, and customs and obtain any required government approvals pertaining to use of the other Party's marks.
OMB Standards Unless specified otherwise within this agreement, the Subrecipient shall procure all materials, property, or services in accordance with the requirements of 24 CFR 84.40−48.
Safety Standards Performance of the Contract for all commodities or contractual services must comply with requirements of the Occupational Safety and Health Act and other applicable State of Florida and federal requirements.
CONTRACT WORK HOURS AND SAFETY STANDARDS As per the Contract Work Hours and Safety Standards Act (40 U.S.C. 3701-3708), where applicable, all Customer Purchase Orders in excess of ,000 that involve the employment of mechanics or laborers must include a provision for compliance with 40 U.S.C. 3702 and 3704, as supplemented by Department of Labor regulations (29 CFR Part 5). Under 40 U.S.C. 3702 of the Act, each contractor must be required to compute the wages of every mechanic and laborer on the basis of a standard work week of 40 hours. Work in excess of the standard work week is permissible provided that the worker is compensated at a rate of not less than one and a half times the basic rate of pay for all hours worked in excess of 40 hours in the work week. The requirements of 40 U.S.C. 3704 are applicable to construction work and provide that no laborer or mechanic must be required to work in surroundings or under working conditions which are unsanitary, hazardous or dangerous. These requirements do not apply to the purchases of supplies or materials or articles ordinarily available on the open market, or contracts for transportation or transmission of intelligence.
Standards for Determining Commercial Reasonableness Borrower and Silicon agree that a sale or other disposition (collectively, "sale") of any Collateral which complies with the following standards will conclusively be deemed to be commercially reasonable: (i) Notice of the sale is given to Borrower at least seven days prior to the sale, and, in the case of a public sale, notice of the sale is published at least seven days before the sale in a newspaper of general circulation in the county where the sale is to be conducted; (ii) Notice of the sale describes the collateral in general, non-specific terms; (iii) The sale is conducted at a place designated by Silicon, with or without the Collateral being present; (iv) The sale commences at any time between 8:00 a.m. and 6:00 p.m; (v) Payment of the purchase price in cash or by cashier's check or wire transfer is required; (vi) With respect to any sale of any of the Collateral, Silicon may (but is not obligated to) direct any prospective purchaser to ascertain directly from Borrower any and all information concerning the same. Silicon shall be free to employ other methods of noticing and selling the Collateral, in its discretion, if they are commercially reasonable.
Contract Work Hours and Safety Standards Act The following clauses apply to any Federal-aid construction contract in an amount in excess of $100,000 and subject to the overtime provisions of the Contract Work Hours and Safety Standards Act. These clauses shall be inserted in addition to the clauses required by 29 CFR 5.5(a) or 29 CFR 4.6. As used in this paragraph, the terms laborers and mechanics include watchmen and guards.
Technical Standards The Generation System shall be installed and operated by the Interconnection Customer consistent with the requirements of this Agreement; the Technical Requirements; the applicable requirements located in the National Electrical Code (NEC); the applicable standards published by the American National Standards Institute (ANSI) and the Institute of Electrical and Electronic Engineers (IEEE); and local building and other applicable ordinances in effect at the time of the installation of the Generation System.
Contractor Standards Contractor shall comply with Contractor Standards provisions codified in the SDMC. Contractor understands and agrees that violation of Contractor Standards may be considered a material breach of the Contract and may result in Contract termination, debarment, and other sanctions.
STANDARDS OF DISCIPLINE 18.1 In order of severity, the usual types of disciplinary action are as follows: - oral reprimand, - written reprimand - suspension - demotion - termination of employment 18.2 When an employee is required to attend a meeting, the purpose of which is to investigate a disciplinary matter concerning the employee or to render a disciplinary decision concerning the employee, the employee is entitled to have, upon request, a representative of the Association attend the meeting. Where practicable, the employee shall receive a minimum of two (2) day’s notice of such a meeting and shall be informed of the reason for it. 18.3 When an employee is suspended from duty, demoted or terminated due to a disciplinary infraction, the Council shall notify the employee, in writing, of the reason(s) for the suspension, demotion or termination. The Council shall endeavour to provide this written notification at the time of the suspension, demotion or termination. 18.4 When an employee feels aggrieved by the application of any disciplinary action which was applied, or in the employee’s opinion was applied, to the employee by the Council, the employee may present a grievance in accordance with the Grievance Procedure Article of this Agreement. 18.5 Except in the case of an oral reprimand, the Council shall provide an employee with a written record of any disciplinary action taken by the Council against the employee after the date of signing of this Agreement, and such written record shall include the reason for the disciplinary action. 18.6 The Council agrees not to introduce as evidence in a hearing relating to disciplinary action any document from the file of an employee, the existence of which the employee was not aware at the time of filing or within a reasonable period thereafter. 18.7 The Council agrees not to introduce as evidence in an adjudication hearing any document from the file of an employee where the employee was not aware of its existence: 18.7.1 at the time of requesting the services of an adjudicator or 18.7.2 within a period of five (5) consecutive working days after the Council has been informed that the employee has requested the services of an adjudicator, whichever occurs later. 18.8 Notice of disciplinary action which may have been placed on the Council staff file of an employee following the date of signing of this Agreement shall be removed from the Council staff file of the employee after two (2) years have elapsed since the disciplinary action was taken provided that no further disciplinary action has been recorded during the two (2) year period. This two (2) year period will automatically be extended by the length of any period of leave without pay in excess of three (3) months.
