OMB Standards Unless specified otherwise within this agreement, the Subrecipient shall procure all materials, property, or services in accordance with the requirements of 24 CFR 84.40−48.
Applicable Standards The requirements and guidelines of NERC, the Applicable Regional Entity, and the Control Area in which the Customer Facility is electrically located; the PJM Manuals; and Applicable Technical Requirements and Standards.
Quality Standards Each Party agrees that the nature and quality of its products and services supplied in connection with the other Party's Marks will conform to quality standards set by the other Party. Each Party agrees to supply the other Party, upon request, with a reasonable number of samples of any Materials publicly disseminated by such Party which utilize the other Party's Marks. Each Party will comply with all applicable laws, regulations, and customs and obtain any required government approvals pertaining to use of the other Party's marks.
Goods, Standards and Appurtenances Any Goods delivered must be standard new Goods, latest model, except as otherwise specifically stated in the Contract. Remanufactured, refurbished or reconditioned equipment may be accepted but only to the extent allowed under the Contract. Where the Contract does not specifically list or describe any parts or nominal appurtenances of equipment for the Goods, it shall be understood that the Contractor shall deliver such equipment and appurtenances as are usually provided with the manufacturer's stock model.
Minimum Standards (a) It is intended that the provisions contained in the Employment Standards Act and Regulations (Act), presently in effect and from time to time amended, are minimum requirements only. (b) In the event this collective agreement does not contain a provision which is contained in the Act such provision shall be deemed to be incorporated in the collective agreement as part of its terms. (c) In the event this collective agreement contains a provision which is a lesser requirement than a similar or related provision contained in the Act, then the provision contained in the Act shall prevail, and shall be deemed to be incorporated in the collective agreement as part of its terms. (d) In the event a dispute arises respecting the application or interpretation of any provision of the Act which is deemed to be part of the terms of this collective agreement, the Grievance Procedure contained in this collective agreement, including Arbitration if necessary, shall apply for resolution of the dispute.
Contract Work Hours and Safety Standards Act The following clauses apply to any Federal-aid construction contract in an amount in excess of $100,000 and subject to the overtime provisions of the Contract Work Hours and Safety Standards Act. These clauses shall be inserted in addition to the clauses required by 29 CFR 5.5(a) or 29 CFR 4.6. As used in this paragraph, the terms laborers and mechanics include watchmen and guards.
Service Level Standards In addition to all other requirements in this Agreement, and in accordance with the Best Claims Practices & Estimating Guidelines, Vendor shall use reasonable and good faith efforts to meet the Service Level Standards set forth below.
Employment Standards Act Where the provisions of the Employment Standards Act exceed those within this agreement such provisions shall apply.
Manufacturing Standards All forest products except poles, produced and sold under this contract will be manufactured to maximize the amount of logs meeting preferred log lengths and to achieve the average log length listed. 97318 3 WS "WS" indicates that west side scaling rules apply. Minimum trim is 8 inches per scaling segment for west side scaling rules. "ES" indicates that east side scaling rules apply. Minimum trim is 4 inches per scaling segment for east side scaling rules. Poles produced under this contract will be manufactured to ANSI specifications (American National Standard Specifications and Dimensions for Wood Poles), in force at the time of signing this contract. a. Sweep will be limited to within the bole of the log as measured using a tape stretched between the centers of each end of the log. b. Logs approved by the state for peelers shall be chuckable with no more than a 2 inch diameter area of rot within a 5 inch diameter circle located at the center of either end of the log. c. Limbs and knots shall be cut flush, with no more than 15 percent of a log having limbs or knots over 2 inches in diameter extending more than 2 inches above the surface of the log.
General Standards An Assistant Professor will be competent to teach in a particular field, will be current in the literature of that field, and will seek to meet student needs in both the classroom and in non-classroom environments. However, an Assistant may be a junior member of the academic community, with little professional and/or teaching experience. Furthermore, an Assistant may have little experience in curriculum development, committee work, governance, professional and/or community service, etc. In short, an Assistant Professor generally will be new to tenure-track college teaching. For eligibility for promotion from Assistant to Associate Professor, the candidate must have served a minimum of four (4) years at the rank of Assistant Professor, and must show evidence that he/she has grown professionally and consistently has sought to meet student needs, in both the classroom and in non-classroom environments. A successful candidate for the rank of Associate Professor will have remained current in the field, and will have improved his/her teaching in some demonstrable way. He/she also will have demonstrated professional growth in one or more of the following ways: completion of additional appropriate course work (if applicable), attendance at professional conferences, service on campus and/or District committees, professional and/or community service, or, the production of some creative work. Evidence of professional growth will be drawn from a careful analysis of student evaluations and peer evaluations over a period of time, and from a critical reading of materials submitted by the candidate. For promotion from Associate to Professor, the candidate must have served a minimum of four (4) years at the rank of Associate Professor, and must show evidence that he/she has grown professionally to a point where he/she has mastered both a particular field of knowledge and the teaching of that knowledge. A successful candidate must show evidence that he/she consistently has sought to meet student needs, in both the classroom and non-classroom environments. A Professor should be a senior member of the faculty, one who has such substantial experience, knowledge, and skill that he/she could mentor junior faculty in his/her area of expertise. A Professor will have demonstrated all the same kinds of achievements and attributes necessary for promotion to the Associate Professor rank, but in addition will demonstrate that he/she is a leader in some appropriate sense. Evidence of professional growth and leadership will be drawn from a careful analysis of student evaluations and peer evaluations over a period of time, and from a critical reading of materials submitted by the candidate.
